Mass spectrometry based identification of geometric isomers during metabolic stability study of a new cytotoxic sulfonamide derivatives supported by quantitative structure-retention relationships

Simultaneous analysis of water-soluble and fat-soluble vitamins through RP-HPLC/DAD in food supplements and brewer's yeast

The current study is focused on investigation and quantitation of seven commercially available on the Bulgarian market food supplements, containing multivitamin mixtures of water-soluble and fat-soluble vitamins. In addition, a second fermentation brewer's yeast is also analyzed. The analytical procedures are performed on a RP-HPLC/DAD using Purospher STAR C18 (Merck Millipore, Germany) 5 μm, 25 × 0.46 cm column, conditioned at 25 °C in a column oven. Dionex UltiMate 3000 high performance liquid chromatograph was carried out in diode array detector, set up at 270 nm for water-soluble vitamins, except for vitamin B₅, where 210 nm was applied as analytical wavelength. The fat-soluble vitamins were detected at 325 nm and 265 nm for vitamin A and vitamin E, respectively. Two general methods were developed where Method 1 was based on gradient elution and Method 2 was based on isocratic elution. Both methods identified stated by the manufacturer labeled amounts. The developed methods are applicable for routine analysis of vitamin contents both in multivitamin preparations and in brewer's yeast from secondary fermentation.

Metabolic stability studies of lead compounds supported by separation techniques and chemometrics analysis

With metabolism being one of the main routes of drug elimination from the body (accounting for removal of around 75% of known drugs), it is crucial to understand and study metabolic stability of drug candidates. Metabolically unstable compounds are uncomfortable to administer (requiring repetitive dosage during therapy), while overly stable drugs increase risk of adverse drug reactions. Additionally, biotransformation reactions can lead to formation of toxic or pharmacologically active metabolites (either less-active than parent drug, or even with different action). There were numerous approaches in estimating metabolic stability, including in vitro, in vivo, in silico, and high-throughput screening to name a few. This review aims at describing separation techniques used in in vitro metabolic stability estimation, as well as chemometric techniques allowing for creation of predictive models which enable high-throughput screening approach for estimation of metabolic stability. With a very low rate of drug approval, it is important to understand in silico methods that aim at supporting classical in vitro approach. Predictive models that allow assessment of certain biological properties of drug candidates allow for cutting not only cost, but also time required to synthesize compounds predicted to be unstable or inactive by in silico models.

Understanding performance of 3D-printed sorbent in study of metabolic stability

Metabolic stability tests are one of the fundamental steps at the preclinical stages of new drug development. Microsomes, used as a typical enzymatic model of liver biotransformation, can be a challenging matrix for analytical scientists due to a high concentration of cellular proteins and membrane lipids. In the work, we propose a new procedure integrating biotransformation reaction with SPME-like protocol for sample clean-up. It is beneficial to increase the overall quality of results in contrary to the typical protein precipitation approach. A set of ten arylpiperazine analogs, six of which are considered promising drug candidates (and four are accepted drugs) were used as a probe to assess the goodness of the newly proposed approach. In order to promote an efficient extraction protocol, a new, miniaturized shape of a sorbent, suitable to perform the extraction in 100 µL of the sample has been designed. Termination of the biotransformation process by protein denaturation with hot water was additionally evaluated. A quantitative structure-property relationship (QSPR) study using Orthogonal Partial Least Squares (OPLS) technique to reveal insights to the sorption mechanism was also performed. The obtained results showed the new 3D-printed sorbent can be an attractive basis for the new sample preparation approach for metabolic stability studies and an alternative for commercially available protocols based on solid-phase microextraction (SPME) or solid-phase extraction (SPE) principles.