Stability of Bio-Intact (1–84) Parathyroid Hormone ex Vivo in Serum and EDTA Plasma from Hemodialysis Patients

Inadequate PTH-Response to Hypocalcemia in People Living with HIV

BACKGROUND

Small experimental studies suggest that PTH-secretion following hypocalcemia might be blunted in people living with HIV.

OBJECTIVE

To estimate the frequency of inadequately low concentrations of parathyroid hormone in the presence of hypocalcemia in people living with HIV.

METHODS

Retrospective study in PLWH enrolled in the ongoing ArcHIV study between 2016 and 2017. PLWH with routine measurements for both calcium and parathyroid hormone were included into this analysis. The proportion of patients with a combination of low levels of both calcium and parathyroid hormone was the primary endpoint of this analysis.

RESULTS

496 PLWH were included (mean age 47.1 (± 10.2) years, 393 (79.2 %) men). In 14 (2.8 %) PLWH low calcium levels with low levels of PTH was found in both years. Being under a tenofovir disoproxil- containing treatment in both years was the only explanatory variable significantly associated with inadequately low levels of PTH in the presence of hypocalcemia in both years (OR 4.3 [CI95: 1.4; 16.0]).

CONCLUSION

The combination of low levels of both calcium and PTH was found more frequent in our study sample when compared to what is expected from general populations. Interestingly, being under a tenofovir disoproxil-containing therapy was associated with this combination throughout both years.

Parathyroid Hormone Measurement in Chronic Kidney Disease: From Basics to Clinical Implications

Accurate measurement of parathyroid hormone (PTH) is crucial for therapeutic decision-making in patients with chronic kidney disease-mineral and bone disorder (CKD-MBD). The second-generation PTH assays, often referred to as "intact PTH" assays, are the current standard and most available assays in clinical practice. However, intact PTH assays measure both full-length biologically active PTH and heterogeneous PTH fragments in the circulation, providing the equivocal value of PTH measurement in patients with CKD-MBD. Due to the variability of PTH assays, preanalytical sample errors, and the phenomenon of end-organ PTH hyporesponsiveness, current CKD-MBD guidelines recommend a wide range for serum PTH targets (2-9 the upper normal limit of the intact PTH assay) in dialysis patients to diminish the risk of developing adynamic bone disease. Nevertheless, a sizeable proportion of CKD patients still experience renal osteodystrophy despite having serum PTH levels within the recommended range. The primary cause of this inconsistency is the analytical interference of various PTH fragments and oxidized PTH forms that considerably accumulate in CKD patients. Therefore, a new mass spectrometry-based assay, which is capable of specifically measuring the whole spectra of PTH fragments, can potentially improve diagnostic accuracy for renal osteodystrophy. However, the effects of different PTH fragments on bone metabolism, vascular calcification, and mortality in CKD patients warrant further research.

Analytical Differences in Intraoperative Parathyroid Hormone Assays

BACKGROUND

We compared the rates of intraoperative parathyroid hormone (PTH) decline using the Siemens Immulite^® Turbo PTH and Roche Elecsys^® short turnaround time PTH assays in 95 consecutive surgical patients to investigate analytical and turnaround time (TAT) differences between the tests performed in the operating room (OR) vs the central clinical chemistry laboratory (CCL).

METHODS

Serial blood samples from 95 patients undergoing parathyroidectomy were collected and measured using the 2 immunoassays. Specimens from the first 15 patients were measured simultaneously in the OR and CCL and used for the TAT study. In addition to 2 baseline samples, specimens were collected at 5, 10, and 15 min (for some patients, >15 min) after parathyroidectomy.

RESULTS

In the TAT study, a significant difference was observed (OR median 20 min vs CCL median 27 min; P < 0.05). Of the 95 patient series, slower rates of parathyroid hormone decrease were observed in approximately 20% of the patients when comparing the Roche with the Immulite immunoassay.

CONCLUSIONS

There was a slightly longer TAT in the CCL compared with running the assay directly within the OR (median difference of approximately 7 min). For a majority of the patients, both methods showed equivalent rates of PTH decline; however, for approximately 20% of the patients, there was a slower rate of PTH decline using the Roche assay.

Parathormone stability in hemodialyzed patients and healthy subjects: comparison on non-centrifuged EDTA and serum samples with second- and third-generation assays

Background:

Parathyroid hormone (PTH) stability is important. Many studies have shown divergent results between EDTA and serum, which are mainly linked to differences in protocols or cut-offs used to determine whether or not PTH remained stable. No studies have yet compared PTH stability as measured by second- and third-generation assays on the same samples in hemodialyzed patients and healthy subjects.

Methods:

Five pairs of samples (EDTA and gel tubes) were obtained in 10 hemodialyzed patients before a dialysis session and in 10 healthy subjects. One pair was centrifuged and run directly to define the “T0”. Two pairs were kept at +4°C and two pairs were kept at +25°C. They were centrifuged after 4 and 18 h. Supernatant was kept at –80°C for 1 week. All samples were measured in a single batch, on Roche Cobas and DiaSorin XL second- and third-generation PTH assays. We used three different approaches to evaluate PTH stability: Wilcoxon test, an Acceptable Change Limit (ACL) according to ISO Guide 5725-6 and a Total Change Limit (TCL) derived from the sum of biological and technical variability according to WHO.

Results:

PTH decreased in all samples. Stability of PTH was mainly dependent on the way it was evaluated. Percentages of decrease were systematically lower in EDTA vs. serum. Wilcoxon and ACL showed that PTH was no more stable after 4 h at +4°C in EDTA or serum gel tubes. None of the subjects presented a PTH decrease higher than the TCL with EDTA plasma. In serum gel tubes, PTH was unstable only when kept at 25°C for 18 h.

Conclusions:

PTH seems more stable in EDTA than in serum gel tubes but only when samples have to stay unprocessed for a long period (18 h) at room temperature (25°C), which can happen when samples are delivered from external care centers. For all the other conditions, using serum gel tubes is recommended since calcium measurement, which is necessary for a good PTH results interpretation, can be achieved on the same tube.

PTH--a particularly tricky hormone: why measure it at all in kidney patients?

Plasma parathyroid hormone (PTH) concentrations are commonly measured in the context of CKD, as PTH concentration elevation is typical in this clinical context. Much has been inferred from this raised PTH concentration tendency, both about the state of skeletal integrity and health and also about the potential clinical outcomes for patients. However, we feel that reliance on PTH concentrations alone is a dangerous substitute for the search for, and use of, more precise and reliable biomarkers. In this article, we rehearse these arguments, bringing together patient-level and analytical considerations for the first time.

Variability of parathyroid hormone and other markers of bone mineral metabolism in patients receiving hemodialysis

BACKGROUND AND OBJECTIVES

Clinical management of mineral bone disorder in patients with kidney failure is guided by biochemical targets, in particular parathyroid hormone (PTH) concentration. The biologic variation of PTH and other bone mineral markers was measured in hemodialysis patients to better define their role in management.

DESIGN, SETTING, PARTICIPANTS, & MEASUREMENTS

Intact PTH, biointact (whole-molecule) PTH, calcium, albumin-adjusted calcium, phosphate, and alkaline phosphatase (ALP) were measured in nonfasting samples obtained twice a week (both short-dialysis interval) over a 6-week period in 22 stable hemodialysis patients. Concurrently, samples were obtained from 12 healthy volunteers. Intraindividual coefficients of variance (CVI) were calculated and used to derive the reference change value (RCV) required to be 95% certain that a change has occurred.

RESULTS

CVI of all markers was significantly (P<0.05) greater in patients than in healthy volunteers. For phosphate, ALP, and PTH this implies that an increased number of samples is required to estimate an individual's homeostatic set point. CVI of intact PTH was 25.6% in hemodialysis patients and 19.2% in healthy volunteers. A greater RCV should be used for patients (72%) compared with healthy volunteers (54%). Ideally 26 specimens should be measured to estimate a patient's intact PTH homeostatic set point (within +/-10%) with 95% probability. The CVI of biointact PTH was at least as high as that for intact PTH.

CONCLUSIONS

The uncertainty of PTH estimation in an individual significantly undermines its value as a tool in the management of chronic kidney disease-mineral bone disorder using current management approaches.

The role of ethylenediamine tetraacetic acid (EDTA) as in vitro anticoagulant for diagnostic purposes

Anticoagulants are used to prevent clot formation both in vitro and in vivo. In the specific field of in vitro diagnostics, anticoagulants are commonly added to collection tubes either to maintain blood in the fluid state for hematological testing or to obtain suitable plasma for coagulation and clinical chemistry analyses. Unfortunately, no universal anticoagulant that could be used for evaluation of several laboratory parameters in a sample from a single test tube is available so far. Ethylenediamine tetraacetic acid (EDTA) is a polyprotic acid containing four carboxylic acid groups and two amine groups with lone-pair electrons that chelate calcium and several other metal ions. Calcium is necessary for a wide range of enzyme reactions of the coagulation cascade and its removal irreversibly prevents blood clotting within the collection tube. Historically, EDTA has been recommended as the anticoagulant of choice for hematological testing because it allows the best preservation of cellular components and morphology of blood cells. The remarkable expansion in laboratory test volume and complexity over recent decades has amplified the potential spectrum of applications for this anticoagulant, which can be used to stabilize blood for a variety of traditional and innovative tests. Specific data on the behavior of EDTA as an anticoagulant in hematology, including possible pitfalls, are presented. The use of EDTA for measuring cytokines, protein and peptides, and cardiac markers is described, with an outline of the protection of labile molecules provided by this anticoagulant. The use of EDTA in proteomics and in general clinical chemistry is also described in comparison with other anticoagulants and with serum samples. Finally, the possible uses of alternative anticoagulants instead of EDTA and the potential use of a universal anticoagulant are illustrated.

Stability of intact parathyroid hormone in samples from hemodialysis patients

The determination of intact parathyroid hormone levels is used for diagnosis and in the management of renal osteodystrophy. Pre-analytical and analytical conditions are important in the overall confidence of the assay. Unfortunately, there are no clear recommendations for the use of serum samples or samples anticoagulated with ethylenediaminotetraacetic acid (EDTA) for the best preservation of intact parathyroid hormone. In our study, the Roche Elecsys assay was used to measure intact hormone in both serum and EDTA plasmas from 16 hemodialysis patients over the span of a month. Parathyroid hormone stability was determined in samples kept frozen for 1-5 days or after 8-24 h at room temperature. There was no difference in hormone stability between serum and EDTA samples after 1 day in frozen storage. After 5 days frozen, hormone degradation was significantly greater after EDTA anticoagulation than in serum aliquots. When samples were stored at room temperature, intact parathyroid hormone was significantly more stable in EDTA-treated samples than in clotted serum samples, especially after 24 h. We conclude that optimum results are achieved in the measurement of intact parathyroid hormone levels depending on the workflow of the lab. If the lab works with intermittent batches of samples, frozen serum is the best. If the lab services general practitioners and/or several hospitals and has a continuous flow of samples, EDTA-treated samples stored at room temperature are the best.