Four commonly used dual-energy X-ray absorptiometry scanners do not identically classify subjects for osteopenia or osteoporosis by T-score in four bone regions BIz11.5

Definition of osteoporosis by bone density criteria in men: effect of using female instead of male young reference data depends on skeletal site and densitometer manufacturer

Whether to use young male or young female reference data to calculate bone mineral density (BMD) T-scores in men remains controversial. The third National Health and Nutrition Examination and Survey (NHANES III) data show that the mean and standard deviation of femoral neck and total hip BMD is greater in young men than young women, and therefore differences in T-scores at these sites using NHANES III female vs male norms becomes less as BMD decreases. In contrast, manufacturer-specific reference databases generally assume similar standard deviations of BMD in men and women. Using NHANES III reference data for the femoral neck and total hip, respectively we found that men with T-scores of -2.5 when young male norms are used have T-scores of -2.4 and -2.3 when young female norms are used. Using manufacturer-specific reference data, we found that men with T-scores of -2.5 when young male norms are used at the femoral neck, total hip, lumbar spine, or one-third of the forearm would have T-scores ranging from -2.4 to -0.4 when young female norms are used, depending on skeletal site and densitometer manufacturer. The change of proportions of men diagnosed with osteoporosis when young female norms are used instead of young male reference data differs substantially according to skeletal site and densitometer manufacturer.

Pediatric in vivo cross-calibration between the GE Lunar Prodigy and DPX-L bone densitometers

Dual energy x-ray absorptiometry (DXA) machine cross-calibration is an important consideration when upgrading from old to new technology. In a recent cross-calibration study using adult subjects, close agreement between GE Lunar DPX-L and GE Lunar Prodigy scanners was reported. The aim of this work was to cross-calibrate the two machines for bone and body composition parameters for pediatrics from age 5 years onwards. One-hundred ten healthy volunteers aged 5-20 years had total body and lumbar spine densitometry performed on DPX-L and Prodigy densitometers. Cross-calibration was achieved using linear regression and Bland-Altman analysis. There was close agreement between the machines, with r2 ranging from 0.85 to 0.99 for bone and body composition parameters. Paired t-tests demonstrated significant differences between machines that were dependent on scan acquisition mode, with the greatest differences reported for the smallest children. At the lumbar spine, Prodigy bone mineral density (BMD) values were on average 1.6% higher compared with DPX-L. For the total body, there were no significant differences in BMD; however, there were significant differences in bone mineral content (BMC) and bone area. For small children, the Prodigy measured lower BMC (9.4%) and bone area (5.8%), whereas for larger children the Prodigy measured both higher BMC (3.1%) and bone area (3.0%). A similar contrasting pattern was also observed for the body composition parameters. Prodigy values for lean body mass were higher (3.0%) for small children and lower (0.5%) for larger children, while fat body mass was lower (16.4%) for small children and higher (2.0%) for large children. Cross-calibration coefficients ranged from 0.84 to 1.12 and were significantly different from 1 (p<0.0001) for BMC and bone area. Bland-Altman plots showed that within the same scan acquisition modes, the magnitude of the difference increased with body weight. The results from this study suggest that the differences between machines are mainly due to differences in bone detection algorithms and that they vary with body weight and scan mode. In general, for population studies the differences are not clinically significant. However, for individual children being measured longitudinally, cross-over scanning may be required.