Evaluation of radiological health risk caused by the use of fly ash in cement and concrete production and its storage

As a result of firing pulverized coal in thermal power plants, enormous amounts of fly ash (FA) are produced as industrial waste. The release into the atmosphere and storage of this industrial waste remains one of the major environmental problems that threaten human health by contributing to air, water, and soil pollution. The recovery and reuse of FA in the construction industry is the only economic solution to the existing problem. In this study, the potential radiological risk caused by the usage of FA in concrete and cement production as a main component and its storage in landfill sites was evaluated for people and works by estimating radiological parameters (activity concentration and alpha index, annual effective doses, and the corresponding excess lifetime cancer risks) based on activity concentrations of terrestrial radionuclides in FA. Also, the radiological risk to the workers working in the FA landfill site was evaluated using the Residual Radioactivity Onsite 7.2 code. The average activity concentrations of terrestrial radionuclides in FA samples from the Tunçbilek lignite coal-fired thermal power plant at Kütahya province of Turkey were measured as 417, 156 and 454 Bq kg-1 for 226Ra, 232Th and 40K, respectively. When using up to 35% by mass of FA in cement and concrete, the average values of the radiological parameters revealed that they were within the recommended safety limits. However, code estimations showed that a regular worker in FA storage would be exposed to a total effective dose rate greater than 3 mSv y-1.

Trace Elements Anomalous Concentrations in Building Materials-The Impact of Secondary Mineralisation Processes

The Pb, Cr, Cd, Ni, Zn, Cu, Co, As, Sr, Ba, and Zr content has been determined in the tested rock raw materials. The concentration of cadmium (Cd) was found to be elevated in all types of rock materials and was found on average to be: 1.39 mg/kg in limestones, 0.86 mg/kg-sandstones, 0.44 mg/kg-diatomites, 0.55 mg/kg-opoka rocks, 0.89 mg/kg-marls, 0.21 mg/kg-gaizes 0.42 mg/kg-kaolin clays, and 2.13 mg/kg-decalcified opoka rocks. Higher concentrations of arsenic (As) have also been recorded in sandstones and diatomites, as well as lead (Pb) in limestones and sandstones. The results obtained indicate that the anomalous level of elements is of natural origin and the results of identified secondary mineralisation processes that have affected the tested materials. Pyritization and sulfatization processes have been detected. Mineralogical research has shown that these processes can be associated with the activity of biochemical processes caused by the decomposition of the soft tissues of animal organisms and the organic substances of plant origin that fill the stylolites. It has been shown that the content of strontium (Sr) increases in geologically older Jurassic formations compared to younger Cretaceous formations, which can be used in the monitoring of building materials.

Evaluation of terrestrial radionuclide levels and concomitant radiological risks of bentonites used in many industries

Bentonite is a soft, porous, easily shaped, and absorbent material rich in aluminum, sodium, and potassium. Bentonite is a mineral widely utilized as drilling mud, ore pelletizing, absorbent/adsorbent, bleaching agent, water impedance, coating, and raw material in various industries. In this study, radiometric measurements of 90 bentonite samples collected from 21 quarries in Turkey were performed using gamma-ray spectrometry. The radiological hazards caused by indoor exposure to adults due to the utilization of bentonites as raw materials in the construction industry and outdoor external exposures to quarry workers were evaluated by estimating the activity concentration index, annual effective doses, and lifetime cancer risk. The average activity concentrations of 226Ra, 232Th and 40K measured in bentonite samples were found as (50 ± 5) Bq/kg, (76 ± 4) Bq/kg and (373 ± 19) Bq/kg, respectively. The evaluation results reveal that the bentonites examined could be safely utilized as raw materials.