Photocatalyst of manganese ferrite and reduced graphene oxide supported on activated carbon from cow bone for wastewater treatment

The present research aimed to evaluate the photocatalytic activity of manganese ferrite (M) and reduced graphene oxide (G) supported on pulverized activated carbon from cow bone waste (PAC-MG). PAC-MG was characterized by different instrumental techniques. The efficiency of PAC-MG was evaluated using solar irradiation under different conditions of photocatalyst concentration, H2O2 concentration, and pH ranges for the discoloration of methylene blue dye (MB). The synergy between the nanomaterials potentiated the photocatalytic activity, reaching 85.5% of MB discoloration when using 0.25 g L-1 of catalyst at neutral pH with no oxidant needed. Furthermore, PAC-MG demonstrated excellent stability in 6 consecutive cycles. Finally, it is expected that the present study can add value to industrial waste and contribute to the development of novel water and wastewater treatment methods, ensuring water quality for human consumption and the environment.

Cationic distributions and dielectric properties of magnesium ferrites fabricated by sol-gel route and photocatalytic activity evaluation

Sol-gel auto combustion method was adopted to fabricate magnesium ferrite (MgFe2O4) nanoparticles. The structural and morphological properties was studied by XRD, FTIR, and SEM analysis. The average particle sizes of MgFe2O4 was in the range of 35–55 nm. The octahedral & Tetrahedral bond lengths, R AE (tetrahedral edge length), R BE (shared octahedral edge length) and R BEU (individual octahedral edge length), cationic radii (tetra and octa-sites) were also determined. The magnetic strength also showed direct reliance on bond angle and indirect to bond length. Hoping length L a and L b and bond angles are also measured. The frequency dependent conductivity and dielectric properties of MgFe2O4 were investigated by Impedance analyzer. The photocatalytic activity (PCA) is appraised against MB (methylene blue) dye and MgFe2O4 calcined at 800 °C showed promising degradation (78%) under visible light irradiation. The findings revealed that MgFe2O4 is can harvest the solar light, which could be employed for the remediation of wastewater contains textile dyes.

Photocatalytic hydrogen generation using TiO2: a state-of-the-art review

This review is focusing on photocatalytic hydrogen (H2) production as a viable fuel. The limitations of different production methods for H2 generation and the importance of photocatalytic process are discussed, which renders this process as highly promising to meet the future energy crises. TiO2 is one of most effective material to generate the H2 via photocatalytic processes. Therefore, advantages of the catalyst over other semiconductors have been thoroughly analyzed. Starting from synthesis of TiO2 and factors affecting the whole process of photocatalytic H2 production have been discussed. Modifications for improvement in TiO2 and the photocatalytic reaction are critically reviewed as well as the mechanism of TiO2 modification has been described. Metal doping, non-metal doping, impurity addition and defect introduction processes have been analyzed and the comparison of experimental results is developed based on H2 production efficiency. A critical review of the literature from 2004 to 2021 concludes that H2 production as fuel using TiO2 photocatalytic method is efficient and environment friendly, which have potential for practical applications for H2 generation.

Synergistic Mechanism of Photocatalysis and Photo-Fenton by Manganese Ferrite and Graphene Nanocomposite Supported on Wood Ash with Real Sunlight Irradiation

The present research aimed to evaluate the photocatalytic activity of reduced graphene oxide and manganese ferrite nanocomposite supported on eucalyptus wood ash waste (WA) from industrial boilers, for the decolorization of methylene blue (MB) solutions, using sunlight as an irradiation source. For this, the photocatalyst named MnFe2O4-G@WA was synthesized by a solvothermal method and characterized by analyzes of scanning electron microscopy, transmission electron microscopy, X-ray diffraction, Fourier-transform infrared spectroscopy, Brunauer–Emmett–Teller and zeta potential. Firstly, the photocatalyst was evaluated for photocatalytic decolorization of MB under different reaction conditions. Then, the influence of pH, photocatalyst dose and H2O2 was evaluated. MnFe2O4-G@WA showed 94% of efficiency for photocatalytic decolorization of MB under operating conditions of solar irradiation, 0.25 g/L of catalyst, 300 mg/L of H2O2. The proposed degradation reaction mechanism suggested that the photodegradation of MB was through a synergistic mechanism of photocatalysis and photo-Fenton reactions, with the combined action of the three materials used. The data adjusted to the first order kinetics from the Langmuir–Hinshelwood model. In addition, MnFe2O4-G@WA showed high stability, maintaining its efficiency above 90% after 5 cycles. The results indicated that the nanophotocatalyst is a potential technology for the decolorization of MB solutions.

Application of Spinel and Hexagonal Ferrites in Heterogeneous Photocatalysis

Semiconducting materials display unique features that enable their use in a variety of applications, including self-cleaning surfaces, water purification systems, hydrogen generation, solar energy conversion, etc. However, one of the major issues is separation of the used materials from the process suspension. Therefore, chemical compounds with magnetic properties have been proposed as crucial components of photocatalytic composites, facilitating separation and recovery of photocatalysts under magnetic field conditions. This review paper presents the current state of knowledge on the application of spinel and hexagonal ferrites in heterogeneous photocatalysis. The first part focuses on the characterization of magnetic (nano)particles. The next section presents the literature findings on the single-phase magnetic photocatalyst. Finally, the current state of scientific knowledge on the wide variety of magnetic-photocatalytic composites is presented. A key aim of this review is to indicate that spinel and hexagonal ferrites are considered as an important element of heterogeneous photocatalytic systems and are responsible for the effective recycling of the photocatalytic materials.