Assessing the strengths and limitations of quantitative micromorphometry for the forensic examination of small arms propellant towards brand identification

Smalls arms propellants (SAP) also known as canister powders are readily accessible and cost-effective materials that firearms enthusiasts can acquire for the legitimate assembly of ammunition. These attributes also make SAPs advantageous for the construction of improvised explosive devices (IEDs). Thus, there is a need to develop robust metrics for the characterization of propellants to provide investigative leads as well as for comparisons between known and recovered residues. The goal of this research was to investigate the utility of a high-throughput, non-destructive, and low-cost quantitative automated image analysis routine for the characterization and discrimination of SAP. For this project, 204 one-pound canisters of smokeless propellant (powder) were acquired from local and online sources. These samples represent nine manufacturers and 154 unique brands. From this set, five brands were selected to assess the intra- and inter-lot variability. Eight parameters, which encompass size- and shape-dependent metrics were measured for each sample. A total of ∼85,000 granules (∼680,000 measurements) were analyzed using linear discriminant analysis. A detailed assessment of the variables shows that the size-dependent metrics provide the greatest amount of sample discrimination. Overall accuracy of the method to correctly classify a test subset of data to the brand level is ∼84.72%. The results from this study provide a framework in which to interpret smokeless propellant micromorphometry in the context of intelligence purposes for initial stages of criminal investigations, and for traditional comparisons between known and unknown samples.

Quantitative analysis of smokeless powder particles in post‐blast debris via gas chromatography/vacuum ultraviolet spectroscopy ( GC / VUV )

Forensic analysis of smokeless powder particles recovered from the debris of an improvised explosive device can provide information about the type of smokeless powder used and can aid investigation efforts. In this study, quantitative methods were used to yield information about the difference in the chemical composition of the particles pre‐ and post‐blast. The technique, gas chromatography/vacuum ultraviolet spectroscopy (GC/VUV), was able to quantify nitroglycerin, 2,4‐dinitrotoluene, diphenylamine, ethyl centralite, and di‐n‐butyl phthalate in pre‐ and post‐blast smokeless powder particles using heptadecane as an internal standard. Post‐blast debris was obtained via controlled explosions with assistance from the Indiana State Police Bomb Squad. Two galvanized steel and two polyvinyl chloride pipe bombs were assembled. Two devices contained single‐base smokeless powder and two contained double‐base smokeless powder. 2,4‐dinitrotoluene and diphenylamine were successfully quantified in the single‐base smokeless powder post‐blast debris while nitroglycerin, diphenylamine, and ethyl centralite were successfully quantified in the double‐base smokeless powder post‐blast debris. Compounds were detected at concentrations as low as 9 μg of 2,4‐dinitrotoluene per mg, <3 μg of diphenylamine per mg, 131 μg of nitroglycerin per mg, and <3 μg of ethyl centralite per mg. Concentration changes between pre‐ and post‐blast smokeless powder particles were determined as well as microscopic differences between pre‐ and post‐blast debris for both smokeless powders in all devices. To our knowledge, this is the first use of GC/VUV for the quantification of explosives.