Method of propionic acid–based preservative addition and its effects on nutritive value and fermentation characteristics of wet brewers grains ensiled in the summertime

Effect of chemical and biological preservatives and ensiling stage on the dry matter loss, nutritional value, microbial counts, and ruminal in vitro gas production kinetics of wet brewer's grain silage

This study evaluated the effects of chemical and biological preservatives and ensiling stage on spoilage, ruminal in vitro fermentation, and methane production of wet brewer's grain (WBG) silage. Treatments (TRT) were sodium lignosulfonate at 10 g/kg fresh WBG (NaL1) and 20 g/kg (NaL2), propionic acid at 5 g/kg fresh WBG (PRP, 99%), a combination inoculant (INO; Lactococcus lactis and Lactobacillus buchneri each at 4.9 log cfu/fresh WBG g), and untreated WBG (CON). Fresh WBG was treated and then ensiled for 60 d, after which mini silos were opened and aerobically exposed (AES) for 10 d. Data were analyzed as a RCBD (5 blocks) with a 5 TRT × 3 stages (STG; Fresh, Ensiled, and AES) factorial arrangement. Results showed that Ensiled PRP-treated WBG markedly preserved more water-soluble carbohydrates and starch than all other Ensiled TRT (P<0.001). Dry matter losses of Ensiled PRP-treated WBG were 48% lower than all other Ensiled TRT (P=0.009) but were not different than CON in AES (P=0.350). Due to its greater concentration of digestible nutrients, PRP-treated AES was less aerobically stable than CON (P=0.03). Preservation was not improved by INO, NaL1 or NaL2 but the latter prevented the increase of neutral detergent fiber across STG (P=0.392). Apparent in vitro DM digestibility (IVDMD) decreased only in Ensiled CON, INO and NaL1 relative to Fresh WBG and AES NaL2 had greater IVDMD than all other AES TRT (P≤0.032). In vitro ruminal fermentation of Fresh WBG resulted in a greater methane concentration and yield than the other STG (P<0.033). In conclusion, PRP was the most effective at preserving WBG during ensiling but failed to improve aerobic stability under the conditions tested.

Soybean hulls inclusion on silage of wet brewery waste

This study aimed to evaluate the effects of soybean hulls inclusion in the silage of wet brewery waste. The experimental design was randomized in block, where the treatments were constituted by four levels of soybean hulls on the silage (0, 15, 25, and 35%), with three (silos) replicates per treatment. All data collected were subjected to ANOVA and subsequent polynomial regression at 5%. Soybean hulls inclusion caused a linear increase (p < 0.05) in the pH, dry matter, acid detergent fiber, neutral detergent fiber and total carbohydrates content of the silage. This inclusion also caused a significant reduction (p < 0.05) in the effluent losses and percentages of crude protein, fats, hemicellulose, non-fibrous carbohydrates and total digestible nutrients. Thus, it was concluded that soybean hulls can be used as an additive in the silage of wet brewery waste. Up to 35% of inclusion, there was a significant reduction in the effluent losses, a little increase on pH and enrichment of nutritional content, especially in the dry matter.

Silage review: Silage feeding management: Silage characteristics and dairy cow feeding behavior

Feeding environment and feed accessibility influence the dairy cow's response to the ration and forage composition. Fiber content, physical form, and fermentability influence feeding behavior, feed intake, and overall cow metabolic and lactational responses to forage. It is possible to vary eating time of lactating dairy cattle by over 1 h/d by changing dietary silage fiber content, digestibility, and particle size. Optimizing silage particle size is important because excessively long particles increase the necessary chewing to swallow a bolus of feed, thereby increasing eating time. Under competitive feeding situations, excessively coarse or lower fiber digestibility silages may limit DMI of lactating dairy cows due to eating time requirements that exceed available time at the feed bunk. Additionally, greater silage particle size, especially the particles retained on the 19-mm sieve using the Penn State Particle Separator, are most likely to be sorted. Silage starch content and fermentability may influence ruminal propionate production and thereby exert substantial control over meal patterns and feed consumption. Compared with silage fiber characteristics, relatively little research has assessed how silage starch content and fermentability interact with the feeding environment to influence dairy cow feeding behavior. Finally, voluminous literature exists on the potential effects that silage fermentation end products have on feeding behavior and feed intake. However, the specific mechanisms of how these end products influence behavior and intake are poorly understood in some cases. The compounds shown to have the greatest effect on feeding behavior are lactate, acetate, propionate, butyrate, ammonia-N, and amines. Any limitation in the feeding environment will likely accentuate the negative response to poor silage fermentation. In the future, to optimize feeding behavior and dry matter intake of silage-based diets fed to dairy cattle, we will need to consider the chemical and physical properties of silage, end products of silage fermentation, and the social and physical components of the feeding environment.

Effect of ensiling time on fermentation profile and ruminal in vitro starch digestibility in rehydrated corn with or without varied concentrations of wet brewers grains

The objective of this study was to evaluate the effect of rehydrating and ensiling dry ground corn (DGC) with varying concentrations of wet brewers grain (WBG) on fermentation profile and ruminal in vitro starch digestibility (ivSD; 7-h incubations on dried and 4-mm ground samples). Samples of DGC and WBG were weighed separately and mixed into 100% WBG (WBG); mixture of DGC and WBG targeting 60 (RC60), 65 (RC65), or 70% (RC70) of dry matter (DM); and DGC rehydrated with distilled water targeting for 70% of DM (REH). Samples were ensiled in vacuum-sealed bags and allowed to ferment for 0, 1, 3, 7, 14, and 28 d. The experiment consisted of 30 treatments (5 mixtures of DGC and WGB × 6 ensiling time points) and 120 mini-silos (4 silos per treatment). All samples were analyzed for fermentation profile and water-soluble carbohydrates. Except for WBG, samples from 0 and 28 d were analyzed for ivSD. Content of DM was greater for REH (70.0%), followed by RC70 (69.2%), RC65 (63.9%), RC60 (58.4%), and WBG (17.5%) on d 0, with a slight decrease (1 to 2 percentage units) observed for all treatments until 28 d. Measurements of pH were highest for REH (6.19) and lowest for WBG (4.68) on 0 d, but all other treatments were lower than WBG on 14 and 28 d (3.83 vs. 4.14, on average). Except for WBG, all treatments had a gradual increase in lactic acid concentration from 0 to 28 d. In contrast, butyric acid gradually increased from 0 (0.25%) to 28 d (2.16% of DM) in WBG but not the other treatments. Fermentation patterns were related to water-soluble carbohydrates concentration, which was greater for all treatments except WBG from 0 (1.41% on average vs. 0.38% of DM, respectively) to 28 d (0.37% on average vs. 0.19% of DM, respectively). Except for RC60, greater ivSD was observed for all treatments on 28 than 0 d, but magnitude of the difference was greater for REH and RC70 (14.5 percentage units on average). Rehydration and ensiling of DGC with WBG resulted in adequate fermentation and enhanced starch digestibility.