Parameterization of daily solar global ultraviolet irradiation

Phototoxic versus photoprotective effects of tattoo pigments in reconstructed human skin models: In vitro phototoxicity testing of tattoo pigments: 3D versus 2D

The increasing number of tattooed persons urges the development of reliable test systems to assess tattoo associated risks. The alarming prevalence of 60 % phototoxic reactions in tattoos ask for a more comprehensive investigation of phototoxic reactions in tattooed skin. Here, we aimed to compare the cellular responses of human skin cells to ultraviolet (UV)A and UVB irradiation in doses of short to intermitted sun exposure (3-48 J/cm² and 0.05-5 J/cm², respectively) in the presence of tattoo pigments. Therefore, we used fibroblast monolayer culture (2D), our recently developed three dimensional full-thickness skin model with dermal-located tattoo pigments (TatS_FT) and its dermal equivalents (TatS_DE) that lack keratinocytes. We tested the most frequently used tattoo pigments carbon black, titanium dioxide (TiO₂) anatase and rutile as well as Pigment Orange (P.O.)13 in ranges from 0.067 to 2.7 ng/cell in 2D. For TatS_DE and TatS_FT, concentrations were 1.3 ng/cell for TiO₂, 0.67 ng/cell for P.O.13 and 0.067 ng/cell for carbon black. We assessed cell viability and cytokine release in all systems, and cyclobutane pyrimidine dimer (CPD) formation in TatS_FT. Phototoxicity of tattoo pigments was exclusively observed in 2D, where especially TiO₂ anatase induced phototoxic effects in all concentrations (0.067-2.7 ng/cell). In contrast, fibroblasts were protected from UV irradiation in TatS_DE by TiO₂ and carbon black. Neither toxic nor protective effects were recorded in TatS_FT. P.O.13 showed altered cytokine secretion in 2D (0.067-1.3 ng/cell) and TatS_DE, despite the absence of significant effects on viability in all systems. All pigments reduced the number of CPDs in TatS_FT compared to the pigment-free controls. In conclusion, our study shows that within a 3D arrangement, intradermal tattoo pigments may act photoprotective despite intrinsic phototoxic properties in 2D. Thus, dermal 3D equivalents should be considered to evaluate acute tattoo pigment toxicology.

Reconstruction of solar spectral surface UV irradiances using radiative transfer simulations

UV radiation exerts several effects concerning life on Earth, and spectral information on the prevailing UV radiation conditions is needed in order to study each of these effects. In this paper, we present a method for reconstruction of solar spectral UV irradiances at the Earth's surface. The method, which is a further development of an earlier published method for reconstruction of erythemally weighted UV, relies on radiative transfer simulations, and takes as input (1) the effective cloud optical depth as inferred from pyranometer measurements of global radiation (300-3000 nm); (2) the total ozone column; (3) the surface albedo as estimated from measurements of snow depth; (4) the total water vapor column; and (5) the altitude of the location. Reconstructed daily cumulative spectral irradiances at Jokioinen and Sodankylä in Finland are, in general, in good agreement with measurements. The mean percentage difference, for instance, is mostly within +/-8%, and the root mean square of the percentage difference is around 10% or below for wavelengths over 310 nm and daily minimum solar zenith angles (SZA) less than 70 degrees . In this study, we used pseudospherical radiative transfer simulations, which were shown to improve the performance of our method under large SZA (low Sun).

Optical detection of singlet oxygen produced by fatty acids and phospholipids under ultraviolet A irradiation

Ultraviolet A (UVA) radiation has been known to generate reactive oxygen species, such as singlet oxygen, in skin, leading to the oxidation of lipids and proteins. This oxidation influences cellular metabolism and can trigger cellular signaling cascades, since cellular membranes and the stratum corneum contain a substantial amount of fatty acids and lipids. Using highly sensitive IR-photomultiplier technology, we investigated the generation of singlet oxygen by fatty acids and lipids. In combination with their oxidized products, the fatty acids or lipids produced singlet oxygen under UVA radiation at 355 nm that is directly shown by luminescence detection. Linolenic or arachidonic acid showed the strongest luminescence signals, followed by linoleic acid and docohexaenoic acid. The amount of singlet oxygen induced by lipids such as phosphatidylcholine was significantly higher compared to the corresponding fatty acids within phospholipids. This result indicates a synergistic process of oxygen radicals and singlet oxygen during irradiation. UVA radiation initiates singlet oxygen generation, which subsequently oxidizes other fatty acids that in turn produce additional singlet oxygen. This leads to an enhancement of UVA-induced damage of fatty acids and lipids, which must enhance the oxidative damages in cells.

Testing the applicability of artificial intelligence techniques to the subject of erythemal ultraviolet solar radiation. Part two: an intelligent system based on multi-classifier technique

The problem we address here describes the on-going research effort that takes place to shed light on the applicability of using artificial intelligence techniques to predict the local noon erythemal UV irradiance in the plain areas of Egypt. In light of this fact, we use the bootstrap aggregating (bagging) algorithm to improve the prediction accuracy reported by a multi-layer perceptron (MLP) network. The results showed that, the overall prediction accuracy for the MLP network was only 80.9%. When bagging algorithm is used, the accuracy reached 94.8%; an improvement of about 13.9% was achieved. These improvements demonstrate the efficiency of the bagging procedure, and may be used as a promising tool at least for the plain areas of Egypt.

Reconstruction of daily solar UV irradiation from 1893 to 2002 in Potsdam, Germany

Long-term records of solar UV radiation reaching the Earth's surface are scarce. Radiative transfer calculations and statistical models are two options used to reconstruct decadal changes in solar UV radiation from long-term records of measured atmospheric parameters that contain information on the effect of clouds, atmospheric aerosols and ground albedo on UV radiation. Based on earlier studies, where the long-term variation of daily solar UV irradiation was derived from measured global and diffuse irradiation as well as atmospheric ozone by a non-linear regression method [Feister et al. (2002) Photochem Photobiol 76:281-293], we present another approach for the reconstruction of time series of solar UV radiation. An artificial neural network (ANN) was trained with measurements of solar UV irradiation taken at the Meteorological Observatory in Potsdam, Germany, as well as measured parameters with long-term records such as global and diffuse radiation, sunshine duration, horizontal visibility and column ozone. This study is focussed on the reconstruction of daily broad-band UV-B (280-315 nm), UV-A (315-400 nm) and erythemal UV irradiation (ER). Due to the rapid changes in cloudiness at mid-latitude sites, solar UV irradiance exhibits appreciable short-term variability. One of the main advantages of the statistical method is that it uses doses of highly variable input parameters calculated from individual spot measurements taken at short time intervals, which thus do represent the short-term variability of solar irradiance.

Measured Solar Ultraviolet Radiation Exposures of Outdoor Workers in Queensland in the Building and Construction Industry¶

The risk to outdoor workers of exposure to solar ultraviolet radiation (UVR) has been known for some time, particularly in the building and construction industry, where workers often use little in the way of protection against solar UVR. In recent years there have been attempts by authorities in Australia and in Queensland in particular, where UVR levels in spring and summer are very high to extreme, to instigate and to encourage the use of personal UVR protection by outdoor workers. To quantify UVR exposure of building and construction industry workers involved in typical outdoor work, a study was conducted using UVR-sensitive polysulphone film badges. The results indicated that the doses were significant, often well in excess of recommended exposure limits. The measured exposures varied between trades. Data on the use of personal UVR-protective equipment and the skin type of workers were also collected. Many of the workers had skin types that were sensitive to UVR and showed signs of sunburn. In summary, the study found that at-risk individuals were exposed to extreme levels of UVR, in most cases without adequate and appropriate sun protection.