Cheese yield in Brazil: state of the art

Nutritional and physicochemical quality of formulations based on colostrum and bovine whey

The objective of this study was to investigate the nutritional quality of bovine colostrum and whey mixtures. Five whey with bovine colostrum formulations were prepared (90:10; 80:20; 70:30; 60:40 and 50:50 whey:colostrum v:v) to be subjected to low-temperature pasteurization (63°C to 65°C for 30 minutes) and freeze-drying. The samples underwent chemical composition characterization, fatty acid profile analysis, determination of contamination by Enterobacteriaceae, pH, and Dornic acidity measurements before and after vat pasteurization. The amount of protein, fat, total solids, defatted dry extract, Brix and density increased as the bovine colostrum concentration increased. The level of saturated fatty acids and the thrombogenicity and atherogenicity indices reduced, while unsaturated fatty acids increased as the level of added bovine colostrum increased. The low-temperature pasteurization of the formulations was possible and effective, eliminating contamination by Enterobacteriaceae in the samples. Mixing bovine colostrum and whey reduced the colostrum viscosity, allowing a successful pasteurization procedure. Due to colostrum composition, the formulations yielded a higher nutritional value when compared to whey alone. The parameters applied in the formulation of mixtures of bovine colostrum and whey resulted in valuable ingredients for preparing novel dairy products.

The effect of milk fat substitution on the rheological properties of Edam-type cheese

In cheese-like products, milk components (in particular fat) are partially or completely replaced with non-dairy substitutes. An attempt was made in this study to determine whether Edam-type cheese can be distinguished from its substitute, where milk fat was replaced with palm oil, based on rheological properties. The rheological properties of Edam cheese and its substitute were analyzed during a 16-week ripening period, based on the results of a stress-relaxation test. The values of the rheological parameters were estimated with the use of the generalized Maxwell model and a non-linear model proposed by the authors, which accounted for the plastic deformation of the analyzed samples. The study revealed that both methods were equally effective in describing the stress relaxation process; therefore, they can be regarded as equivalent. Excluding the initial stage of ripening (which is not important from the consumers’ point of view), the replacement of milk fat with palm oil did not influence the rheological properties of Edam-type cheese and the cheese-like product. In subsequent stages of ripening, no significant differences were found in the rheological properties of both products, which could only be used to evaluate their ripeness.