Effects of alpha-tocopherol on fracture resistance after endodontic treatment, bleaching and restoration

Protocols for Mechanical Cleaning of the Post Space on the Bond Strength Between Root Dentin and Cementation System

OBJECTIVE

To evaluate the effects of mechanical versus chemical cleaning protocols for cleaning the root dentin surface before cementation of fiberglass posts for their effect on the bond strength, failure mode, and dentinal penetration of the cementing agent using an etch-and-rinse adhesive system on dentin prepared to receive a fiberglass post.

METHODS

Forty roots of bovine teeth were endodontically treated and prepared for fiber post cementation. The specimens were randomized into 4 groups of 10: Control group (CO) - irrigation with 2.5% NaOCl; DW group- irrigation with distilled water; RB group - rotating brush for cleaning root canals, and CUI group - continuous ultrasonic irrigation. The fiberglass posts were cemented, and the specimens were immersed in distilled water for 6 months. A push-out test was performed on the cervical, middle, and apical thirds of the samples. Dentinal penetration of the cementing agent and the fracture pattern were evaluated by laser confocal microscopy. Statistical analysis was performed using analysis of variance (ANOVA) and post hoc Tukey tests (α=0.05). Results: The RB and CUI groups showed significantly higher bond strength values when compared to the Control and DW groups (p<0.05). In addition, in the control and DW groups, the apical third presented lower bond strength values when compared to middle and cervical thirds.

CONCLUSION

While DW showed the highest incidence of adhesive type failure, CUI resulted in the highest dentinal penetration of the cementing agent (p<0.05). RB and CUI resulted in the highest bond strength between cementation system and root dentin. In addition, CUI favored greater dentinal penetration of fiberglass post cementing agent.

Use of antioxidants to restore bond strength after tooth bleaching with peroxides

This review compiles the literature on the antioxidants used after tooth bleaching with either low or high-concentrated carbamide and hydrogen peroxide to recover the bond strength. Antioxidants used in bleached teeth are mainly natural and non-enzymatic, except for catalase. Commonly, antioxidants are applied to remove any reactive oxygen species (ROS) residues left from bleaching gels, which adversely affect adhesive procedures, such as restorations or orthodontic brackets bonding. Even though sodium ascorbate, the most thoroughly investigated antioxidant, showed the most efficient bond strength recovery at 10% concentration, its performance depends on the type of solution and the application time. Natural extracts, such as proanthocyanidins and green tea, showed satisfactory results in the reversal of bond strength at 5% and 10% concentrations, respectively. Sodium ascorbyl phosphate, α-tocopherol, and catalase exhibited promising results, but further research is required. The adhesive system type plays an important role in the outcome of enamel bond strength after the antioxidant application. The postponement of either restorations or orthodontic brackets cementation following bleaching procedures seems to be efficiently replaced by antioxidant application prior to bonding procedures. However, the efficacy of using an antioxidant to recover bond strength depends on its type and application time.

Effects of the Ratio between Pigment and Bleaching Gel on the Fracture Resistance and Dentin Microhardness of endodontically treated Teeth

INTRODUCTION

The aim of this study was to evaluate the effects of bleaching gel using 35% hydrogen peroxide (HP), associated with red carmine pigment (RC), in the 3:1 or 1:1 ratio, on fracture resistance and dentin microhardness of endodontically treated teeth.

MATERIALS AND METHODS

A total of 40 lower incisors were endodontically treated and divided into four groups (n = 10), according to the bleaching protocol: G1 (HP3), 35% HP + RC (3:1); G2 (HP1), 35% HP + RC (1:1); G3 (positive), 38% HP; and G4 (negative), unbleached. Four dental bleaching sessions were performed. The dental crowns were restored after the last session and submitted to the fracture resistance test. Totally, 60 specimens from the endodontically treated lower incisor crowns were prepared to evaluate the effects on dentin microhardness. The analysis was measured (in Knoop) prior to and after the last dental bleaching session using similar bleaching protocols.

RESULTS

G2 presented the lowest fracture resistance (p < 0.05). The other groups were similar to each other (p > 0.05). No difference was observed in the reduction of dentin microhardness among the groups (p > 0.05).

CONCLUSION

A 1:1 ratio (bleaching gel:pigment) caused a significant fracture resistance reduction in relation to the other protocols. No effect on the dentin microhardness reduction was observed.

CLINICAL SIGNIFICANCE

The pigment addition to the bleaching agent accelerates the bleaching chemical reaction. However, no studies have evaluated the ideal proportion to optimize tooth bleaching.