Humerus Fractures After Open Subpectoral Biceps Tenodesis: Three Cases with 2-year Functional Outcome Data and Review of the Literature

Arthroscopic Subdeltoid Transfer of the Long Head of the Biceps Tendon to the Conjoint Tendon

Surgical intervention is often recommended for refractory pathology affecting the biceps-labrum complex. Tenodesis of the long head of the biceps tendon (LHBT) is a widely accepted treatment modality; however, the optimal technique remains elusive. Arthroscopic subdeltoid transfer of the LHBT to the conjoint tendon, as described in this technical note, continues to demonstrate excellent clinical results. Its advantages include soft tissue-to-soft tissue healing, an advantageous biomechanical construct, and comprehensive evaluation and decompression of the LHBT including the extra-articular bicipital tunnel. The primary limitation of this procedure is the perceived learning curve for safe navigation within the subdeltoid space.

Biomechanical properties of suprapectoral biceps tenodesis with double-anchor knotless luggage tag sutures vs. subpectoral biceps tenodesis with single-anchor whipstitch suture using all-suture anchors

Background

As the use of all-suture anchors continues to increase, limited biomechanical data on the use of these anchors in various configurations for tenodesis of the long head biceps tendon (LHBT) exists. The aim of this study was to compare the biomechanical properties of a 2-anchor luggage tag suprapectoral biceps tenodesis (Sup-BT) vs. a single-anchor whipstitch subpectoral biceps tenodesis (Sub-BT) using all-suture anchors. The hypothesis was that the Sub-BT will have a higher ultimate load to failure and less creep relative to the Sup-BT construct.

Methods

Eighteen fresh frozen cadaveric humeri were used. The specimens were randomly divided into 2 groups of 9; i) The Sup-BT were performed with 2 1.8 mm knotless all-suture anchors using a luggage-tag fixation configuration, ii) The Sub-BT were performed using a single 1.9 mm all-suture anchor and a whipstitch suture configuration with a tied knot. The humeri were tested on a hydraulic MTS machine where the specimens were preloaded at 5 N for 2 minutes and then cyclically loaded from 5 to 50 N for 1000 cycles at 1 Hz while maximum displacement was recorded with a motion system and markers attached to the bone and bicep tendon. The tendon was then tensioned at a rate of 1 mm/s to obtain the ultimate load to failure. CT scans of the specimens were used to calculate the bone mineral density at the site of the anchor/bone interface and video recordings were captured during load to failure to document all modes of failure.

Results

There was no significant difference in the average load to failure of the Sup-BT and Sub-BT groups (197 N ± 45 N (SD), 164 N ± 68 N (SD) respectively; P = .122) or creep under fatigue between the Sup-BT vs. Sub-BT specimens (3.1 mm, SD = 1.5 vs. 2.2 mm, SD = 0.9; P = .162). The bone mineral density was statistically different between the 2 groups (P < .001); however, there were no observed failures at the anchor/bone interface and no correlation between failure load and bone mineral density.

Conclusion

The ultimate load to failure and creep between a Sup-BT with 2 knotless all-suture anchors using a luggage tag suture configuration was equivalent to a Sub-BT with 1 all-suture anchor using a whipstitched suture configuration and a tied knot. Surgeons can perform either technique confidently knowing that they are biomechanically equivalent in a cadaver model at time zero, and they offer similar strength to other fixation methods cited in the literature.

Increased Load to Failure in Biceps Tenodesis With All-Suture Suture Anchor Compared With Interference Screw: A Cadaveric Biomechanical Study

PURPOSE

To compare the biomechanical characteristics of a single radially expanding all-suture anchor with an interference screw for open subpectoral long head of biceps tendon (LHBT) tenodesis.

METHODS

Eighteen fresh-frozen matched-pair human cadaveric humeri were used for this biomechanical study. The matched pair humeri were randomly assigned into 2 experimental biceps tenodesis groups: conventional interference screw (CIS) or all-suture suture anchor (ASSA). Open subpectoral LHBT tenodesis was then performed and biomechanical testing was performed using a servohydraulic test frame. A preload of 5 N was applied for 2 minutes before cyclic loading. Displacement was recorded at cycle 300 (D300) and cycle 500 (D500) and at ultimate failure. Data recorded included displacement, load to failure, displacement at failure. Paired t test was used for analysis.

RESULTS

Decreased displacement was observed for the CIS group at D300 (1.67 ± 0.57 mm vs 3.35 ± 2.24 mm; P = .04), D500 (2.00 ± 0.76 mm vs 3.87 ± 2.20 mm; P = .04), and at failure (5.17 ± 3.05 mm vs 10.76 ± 2.66 mm; P < .001). Load to failure was lower in CIS specimens (170 ± 24.5 N vs 217.8 ± 51.54 N; P = .02). Failure in each case was tendon pullout for all CIS specimens; in ASSA 6 specimens failed as the suture pulled through the tendon, 2 specimens failed by suture breakage. No difference in stiffness was observed between the 2 groups (CIS = 98.33 ± 22.98 N/m vs ASSA = 75.94 ± 44.83 N/m; P = .20).

CONCLUSIONS

Our study found that open subpectoral biceps tenodesis performed with an ASSA construct results in increased load to failure as compared with CIS. However, the CIS did demonstrate decreased displacement as compared to ASSA in this cadaveric biomechanical study.

CLINICAL RELEVANCE

ASSA and CIS at time zero provide fixation as indicated by the provider intraoperatively for LHBT tenodesis. ASSA, however, does remove less cortical bone than does CIS and therefore produces a smaller stress riser in the proximal humerus. Further testing as to the integrity of ASSA is warranted to determine the integrity of the tenodesis with cyclical loading.

All-Arthroscopic Anatomic Length-Tension Biceps Tenodesis With Unicortical Button

The long head of the biceps tendon is a frequent cause of persistent anterior shoulder pain. Biceps tenodesis is a popular choice for surgical management of this pathology, with myriad approach and fixation variations described. We describe an all-arthroscopic suprapectoral biceps tenodesis in the anatomic length-tension relation using a unicortical button. This technique offers an alternative method that provides proper tendon fixation at anatomic length with minimized additional surgical morbidity and postoperative complications.