Violet diode laser for metal ion determination by capillary electrophoresis-laser induced fluorescence

Fluorescence sensor using a molecularly imprinted polymer as a recognition receptor for the detection of aluminium ions in aqueous media

This paper describes the investigation of a molecularly imprinted polymer (MIP) as a sensing receptor for Al(3+) ion detection by using an optical approach. Al(3+) ion was adopted as the template molecule and 8-hydroxyquinoline sulfonic acid ligand as the fluorescence tag. The polymer was synthesised using acrylamide as monomer, 2-hydroxyethyl methacrylate as co-monomer and ethylene glycol dimethracylate as cross-linker. The free radical polymerisation was performed in methanol and initiated by 2,2'-azobisisobutyronitrile at 70 degrees C. The imprinted polymer was fluorometrically characterised using a fibre optic attachment in a self-designed flow-cell. NaF was used to leach the Al(3+) ion from the MIP. The optimum pH for the rebinding of Al(3+) ion with the leached polymer was found to be pH 5 and the fluorescence response was found to be stable within the buffer strength range of 0.05-0.10 M. The fluorescence intensity during Al(3+) ion rebinding was inversely dependent on temperature, and a low interference response (<3%) toward metal ions except for Cu(2+) and Zn(2+) ions was observed. The polymer rebinding repeatability study conducted over 9 cycles with Al(3+) ion (0.8 x 10(-4) M) was found to give an RSD value of 2.82% with a standard deviation of 0.53. The dynamic range of the system was found to be linear up to 1.0 x 10(-4) M Al(3+) ion with a limit of detection of 3.62 microM.

Determination of Pb(II), Cu(II) and Fe(III) with Capillary Electrophoresis Using Ethylenediaminetetraacetic Acid as a Complexing Agent and Vancomycin as a Complex Selector

The simultaneous determination of metal ions using ethylenediaminetetraacetic acid (EDTA) as a complexing agent and vancomycin as a complex selector was successfully studied by capillary electrophoresis with the U-shaped cell. The partial filling method (counter current mode) was used in order to gain selectivity of the separation, and also to increase the detection sensitivity. The effect of the vancomycin concentration on the separation behavior of free EDTA and metal products, and the effect of the EDTA concentration on the stability of metal-EDTA products were considered. Under the optimal condition, the reproducibilities (RSD) of the migration time and the peak area were less than 3.39% and 9.61%, respectively. With the high sensitivity of the method, Pb(II), Cu(II) and Fe(III) in tap water were successfully determined, and the recoveries were 99 - 105%. The concentrations of these metal ions found in tap water did not exceed the maximum allowed concentrations regulated by the U.S. Environmental Protection Agency.

High-performance liquid chromatographic separation and indirect fluorescence detection of thiols

A fluorescent post-column reaction detection scheme has been devised for selective determination of thiols. The post-column reagent is 40 microM Cd2+ and 100 microM 8-hydroxyquinoline-5-sulfonic acid (HQS) in non-complexing buffer at pH 10. HQS complexes Cd2+ to form a fluorescent product. Thiols in the HPLC effluent compete for complexation of the Cd2+, resulting in a decrease in the fluorescence response. Detection limits of 0.2 microM (0.04 ppm) are achieved for cysteine, homocysteine and glutathione in a 5 min separation. Recoveries from spiked synthetic urine samples are 87-120%.