Supporting materials that improve the stability of enzyme membranes

Direct Electrochemical Detection of Glutamate, Acetylcholine, Choline, and Adenosine Using Non-Enzymatic Electrodes

Non-electroactive neurotransmitters such as glutamate, acetylcholine, choline, and adenosine play a critical role in proper activity of living organisms, particularly in the nervous system. While enzyme-based sensing of this type of neurotransmitter has been a research interest for years, non-enzymatic approaches are gaining more attention because of their stability and low cost. Accordingly, this focused review aims to give a summary of the state of the art of non-enzymatic electrochemical sensors used for detection of neurotransmitter that lack an electrochemically active component. In place of using enzymes, transition metal materials such as those based on nickel show an acceptable level of catalytic activity for neurotransmitter sensing. They benefit from fast electron transport properties and high surface energy and their catalytic activity can be much improved if their surface is modified with nanomaterials such as carbon nanotubes and platinum nanoparticles. However, a general comparison reveals that the performance of non-enzymatic biosensors is still lower than those that use enzyme-based methods. Nevertheless, their excellent stability demonstrates that non-enzymatic neurotransmitter sensors warrant additional research in order to advance them toward becoming an acceptable replacement for the more expensive enzyme-based sensors.

Enzyme and Mediator-coadsorbed Carbon Felt Electrode for Electrochemical Detection of Glucose Covered with Polymer Layers Based on Layer-by-Layer Technique

Glucose dehydrogenase (GlDH) and ferrocene were coadsorbed on a carbon felt (CF) sheet (5 × 10 mm, 2 mm thickness), which was used to construct an electrode for the electrochemical detection of glucose. A potential of +0.3 V vs. Ag/AgCl was applied on the base CF, and the current was measured. After the addition of glucose, the current increased and reached a steady state within 50 s. The current response was proportional to the glucose concentration up to 20 μM, with a lower detection limit of 1 μM. The surface of the CF electrode was covered by layers of polystyrene sulfonate and poly-L-lysine using layer-by-layer technique. Again the current response was proportional to glucose concentration up to 20 μM, with a lower detection limit of 2 μM. The oxidation current owing to electrochemical interferents such as L-ascorbate and acetaminophen was 1/8 times of the current observed on the unprotected electrode. In addition, the protection imparted stability to the electrode. Our work demonstrates that a GlDH/ferrocene CF electrode, protected with polystyrene sulfonate and poly-L-lysine, could be used for the electrochemical detection of glucose.

Immobilized lipase on porous ceramic monoliths for the production of sugar-derived oil gelling agent

Lipase from Candida sp. 99-125 was immobilized on porous ceramic monoliths for the production of sugar-derived oil gelling agent.

Long-Term Stability of a Cellulose-Based Glucose Oxidase Membrane

A cellulose-based glucose oxidase membrane was prepared on a glassy carbon (GC) electrode. The current response of the electrode to glucose was measured by applying a potential of 1.0 V vs. Ag/AgCl on the base GC and was proportional to the concentration of glucose up to 1 mM. The long-term stability of the electrode was examined by measuring the daily glucose response. Over four months, the response magnitude was maintained and then gradually decreased. After 11 months, though the response magnitude decreased to 50% of the initial value, the linear response range did not change. Therefore, the electrode could be used as a glucose biosensor even after 11 months of use. The entrapment of the enzyme in the cellulose matrix promoted the stability of the enzyme, as revealed by data on the enzyme activity after the enzyme electrode was immersed in urea. Therefore, the cellulose matrix may be used to improve the performance of biosensors, bioreactors and bio-fuel cells.