Effect of Spray Drying Conditions on Physical Properties of Panax notoginseng Saponin (PNS) Powder and the Intra-Batch Dissolution Variability of PNS Hydrophilic Matrix Tablet

Leveraging the Exploratory and Predictive Capabilities of Design of Experiments in Development of Intraarticular Injection of Imatinib Mesylate Containing Lipospheres

An intraarticular, liposphere-based, formulation of Imatinib mesylate for weekly administration was developed. Lipospheres were prepared using double emulsion technique using dierucoyl phosphatidylcholine, 1,2-dipalmitoyl-sn-glycero-3-phospho-rac-(1-glycerol) sodium salt), cholesterol, and tricaprylin as lipid phase in dichloromethane in a four-step process. Primary emulsion, formed using a high-pressure homogenizer, was diluted using a secondary aqueous phase in an Inline mixer to form the liposomal dispersion. Nitrogen flushing was done to remove dichloromethane, and the dispersion was finally centrifuged and adjusted for potency. The amount of cholesterol and triglyceride was taken as formulation variables, and speed of homogenization was used as a process variable in the Box-Behnken design while particle size, % drug entrapment, and drug release at the end of 4 h and 5 days were taken as response variables. Multivariate data analysis grouped the variables in two latent variable sets, one based on the speed and the other on the composition of lipospheres. Multiple linear regression analysis was used to generate mathematical model for each response. Constraints were put on the values of responses, as per the requirements of the final product, and the "freedom to operate" design space was located using an overlay plot. The center point batch sufficed all the set criteria, and Monte Carlo simulations on the factor variables indicated a defect rate of 5%. The center point batch was characterized for viscosity, osmolality, pH, drug release, and lipocrit value. The dispersion was charged in a prefilled syringe and studied for stability. The product was found to be stable at 2-8°C over a period of 6 months.

Preparation and Characterization of Hydrophilic Polymer Based Sustained-Release Matrix Tablets of a High Dose Hydrophobic Drug

The objective of this study was the preparation and characterization of a sustained-release matrix tablet containing a high-dose hydrophobic drug and its comparison with marketed products. In the present study, HPMC was applied as the matrix-forming polymer for the sustained release of clarithromycin (500 mg). The compatibility of clarithromycin and excipients was studied using a binary mixture approach and compatible excipients were selected. Matrix tablets were prepared using the high-shear wet granulation technique. Tablets were compressed using oblong (19 mm), shallow concave punches, under a compression weight of 900 mg/tablet. The flow of granules was evaluated by determining their bulk density, tapped density, angle of repose, Hausner ratio, and Car’s index. Compressed tablets were tested for their physical parameters, mechanical characteristics, drug content, and in vitro drug release, as per United States Pharmacopeia (USP). Clarithromycin is a drug having poor water solubility and showed compatibility with all the excipients used in the formulation of polymeric matrix tablets. FTIR spectra of clarithromycin, before and after being subjected to the stress conditions, confirmed the compatibility of clarithromycin and other ingredients of the matrix tablets. All the formulations exhibited good rheological characteristics and all the parameters related to flow showed results in the acceptable range. Physically, matrix tablets were smooth and shiny, without any surface defects. Weight variation (±5%) and drug content of the tablets (95–102%) were within the pharmacopeial limits. HPMC successfully sustained the drug release for 24 h. It is concluded from the study that dissolution rate of clarithromycin can be sustained using hydrophilic polymer (HPMC) as a release-controlling agent.