Passive sampling of polar emerging contaminants in Irish catchments

17β-estradiol (E2) removal in anode-electrodialysis (anode-ED) during nutrient recovery from pig manure digestate

Nutrient recovery from anaerobic digestate through electrodialysis technology (ED) has been investigated and shown high promise, but the removal of 17β-estradiol (E2), which is a natural estrogen and widely found in manure digestate, is not clear. This study examined the mechanism of membrane adsorption and anodic oxidation of E2 during recovering nutrient from manure digestate, and further investigated the performance of Anode-ED in E2 removal. The results showed that the removal of E2 in conventional ED was primarily attributed to membrane adsorption, resulting in no detectable E2 in the product solution. The adsorption capacity of the anion exchange membrane for E2 was significantly higher compared to that of the cation exchange membrane. During Anode-ED operation, E2 was efficiently removed by electrochemical oxidation, in which the chlorination played a primary role. Moreover, the oxidation intermediates of E2 were further removed after 40 min. Even though the carbonate, volatile fatty acid (VFA), and humic acid in the real wastewater have a negative impact on E2 oxidation, the E2 was completely removed from digestate during nutrient recovery in the anode-ED. This study indicates that anode-ED is a promising technology for the removal of E2 during nutrient recovery from digestate.

A Review of In Situ Methods-Solid Phase Adsorption Toxin Tracking (SPATT) and Polar Organic Chemical Integrative Sampler (POCIS) for the Collection and Concentration of Marine Biotoxins and Pharmaceuticals in Environmental Waters

Solid Phase Adsorption Toxin Tracking (SPATT) and Polar Organic Chemical Integrative Sampler (POCIS) are in situ methods that have been applied to pre-concentrate a range of marine toxins, pesticides and pharmaceutical compounds that occur at low levels in marine and environmental waters. Recent research has identified the widespread distribution of biotoxins and pharmaceuticals in environmental waters (marine, brackish and freshwater) highlighting the need for the development of effective techniques to generate accurate quantitative water system profiles. In this manuscript, we reviewed in situ methods known as Solid Phase Adsorption Toxin Tracking (SPATT) and Polar Organic Chemical Integrative Sampler (POCIS) for the collection and concentration of marine biotoxins, freshwater cyanotoxins and pharmaceuticals in environmental waters since the 1980s to present. Twelve different adsorption substrates in SPATT and 18 different sorbents in POCIS were reviewed for their ability to absorb a range of lipophilic and hydrophilic marine biotoxins, pharmaceuticals, pesticides, antibiotics and microcystins in marine water, freshwater and wastewater. This review suggests the gaps in reported studies, outlines future research possibilities and guides researchers who wish to work on water contaminates using Solid Phase Adsorption Toxin Tracking (SPATT) and Polar Organic Chemical Integrative Sampler (POCIS) technologies.

The study of polar emerging contaminants in seawater by passive sampling: A review

Emerging Contaminants (ECs) in marine waters include different classes of compounds, such as pharmaceuticals and personal care products, showing "emerging concern" related to the environment and human health. Their measurement in seawater is challenging mainly due to the low concentration levels and the possible matrix interferences. Mass spectrometry combined with chromatographic techniques represents the method of choice to study seawater ECs, due to its sensitivity and versatility. Nevertheless, these instrumental techniques have to be preceded by suitable sample collection and pre-treatment: passive sampling represents a powerful approach in this regard. The present review compiles the existing occurrence studies on passive sampling coupled to mass spectrometry for the monitoring of polar ECs in seawater and discusses the availability of calibration data that enabled quantitative estimations. A vast majority of the published studies carried out during the last two decades describe the use of integrative samplers, while applications of equilibrium samplers represent approximately 10%. The polar Chemcatcher was the first applied to marine waters, while the more sensitive Polar Organic Chemical Integrative Sampler rapidly became the most widely employed passive sampler. The organic Diffusive Gradients in Thin film technology is a recently introduced and promising device, due to its more reliable sampling rates. The best passive sampler selection for the monitoring of ECs in the marine environment as well as future research and development needs in this area are further discussed. On the instrumental side, combining passive sampling with high resolution mass spectrometry to better assess polar ECs is strongly advocated, despite the current challenges associated.

Substances of emerging concern in Baltic Sea water: Review on methodological advances for the environmental assessment and proposal for future monitoring

The Baltic Sea is among the most polluted seas worldwide. Anthropogenic contaminants are mainly introduced via riverine discharge and atmospheric deposition. Regional and international measures have successfully been employed to reduce concentrations of several legacy contaminants. However, current Baltic Sea monitoring programs do not address compounds of emerging concern. Hence, potentially harmful pharmaceuticals, UV filters, polar pesticides, estrogenic compounds, per- and polyfluoroalkyl substances, or naturally produced algal toxins are not taken into account during the assessment of the state of the Baltic Sea. Herein, we conducted literature searches based on systematic approaches and compiled reported data on these substances in Baltic Sea surface water and on methodological advances for sample processing and chemical as well as effect-based analysis of these analytically challenging marine pollutants. Finally, we provide recommendations for improvement of future contaminant and risk assessment in the Baltic Sea, which revolve around a combination of both chemical and effect-based analyses.

Pesticides in surface freshwater: a critical review

The objective of this study was to critically review studies published up to November 2021 that investigated the presence of pesticides in surface freshwater to answer three questions: (1) in which countries were the studies conducted? (2) which pesticides are most evaluated and detected? and (3) which pesticides have the highest concentrations? Using the Prisma protocol, 146 articles published from 1976 to November 2021 were included in this analysis: 127 studies used grab sampling, 10 used passive sampling, and 9 used both sampling techniques. In the 45-year historical series, the USA, China, and Spain were the countries that conducted the highest number of studies. Atrazine was the most evaluated pesticide (56% of the studies), detected in 43% of the studies using grab sampling, and the most detected in passive sampling studies (68%). The compounds with the highest maximum and mean concentrations in the grab sampling were molinate (211.38 µg/L) and bentazone (53 µg/L), respectively, and in passive sampling, they were oxyfluorfen (16.8 µg/L) and atrazine (4.8 μg/L), respectively. The levels found for atrazine, p,p'-DDD, and heptachlor in Brazil were higher than the regulatory levels for superficial water in the country. The concentrations exceeded the toxicological endpoint for at least 11 pesticides, including atrazine (Daphnia LC₅₀ and fish NOAEC), cypermethrin (algae EC50, Daphnia and fish LC₅₀; fish NOAEC), and chlorpyrifos (Daphnia and fish LC₅₀; fish NOAEC). These results can be used for planning pesticide monitoring programs in surface freshwater, at regional and global levels, and for establishing or updating water quality regulations.

Passive Sampling of Organic Contaminants as a Novel Approach to Monitor Seawater Quality in Aquarium Ocean Tanks

The determination of trace pollutants in seawater is challenging, and sampling is a crucial step in the entire analytical process. Passive samplers combine in situ sampling and preconcentration, thus limiting the tedious treatment steps of the conventional sampling methods. Their use to monitor water quality in confined marine environment could bring several advantages. In this work, the presence of organic contaminants at trace and ultra-trace levels was assessed in the Genoa Aquarium supply-and-treated water using Polar Organic Integrative Samplers (POCIS). Both untargeted gas chromatography-mass spectrometry and targeted liquid chromatography-tandem mass spectrometry were employed. The untargeted approach showed the presence of hydrocarbons, diphenyl sulfone and 2,4-di-tert-butyl-phenol. Only hydrocarbons were detected in all the samples. Nineteen emerging contaminants, belonging to different classes (pharmaceuticals, UV-filters, hormones and perfluorinated compounds), were selected for the target analysis. Thirteen analytes were detected, mainly in supply water, even though the majority of them were below the quantitation limit. It is worthy to note that two of the detected UV-filters had never been reported in seawater using the POCIS samplers. The comparison of the analytes detected in supply and treated water indicated a good performance of the Aquarium water treatment system in the abatement of seawater contaminants.

Detection, occurrence, and fate of emerging contaminants in agricultural environments (2020)

A review of 79 papers published in 2019 is presented. The topics ranged from detailed descriptions of analytical methods, to fate and occurrence studies, to ecological effects and sampling techniques for a wide variety of emerging contaminants likely to occur in agricultural environments. New methods and studies on veterinary pharmaceuticals, antibiotics, anthelmintics, and engineered nanomaterials in agricultural environments continue to expand our knowledge base on the occurrence and potential impacts of these compounds. This review is divided into the following sections: Introduction, Analytical Methods, Antibiotics in Agroecosystems, Pharmaceutical Fate and Occurrence, Anthelmintics and Engineered Nanomaterials. PRACTITIONER POINTS: New research describes innovative new techniques for emerging contaminant detection in agricultural settings Newer classes of contaminants include human and veterinary pharmaceuticals Research in nanomaterials show that these also occur in agricultural environments and will likely be topics of future work.

Use of Chemcatcher® passive sampler with high-resolution mass spectrometry and multi-variate analysis for targeted screening of emerging pesticides in water

Pesticides present at trace concentrations are a common cause of poor water quality. Their concentrations can change dynamically, due to the stochastic nature of pesticide pollution. Consequently, characterisation of pesticide residues that are intermittently present, poses significant monitoring and analytical challenges. Traditional approaches rely on quantitation of a limited number of pesticides present in a discrete water sample. Expanding the analytical suite and/or the frequency of sampling to meet these challenges is often impractical. Comprehensive methods are needed, with selectivity and sensitivity for the hundreds of pesticides potentially present, and temporal representativeness to ensure changing conditions are understood, in order to identify and prioritise risk. Recent analytical advances have enabled the targeted screening of hundreds of compounds in the same run, and automated work-flows can now reliably identify compounds through the comparison of retention time and accurate mass with spectral libraries. Screening generates large qualitative data sets, therefore, there is a need for improved monitoring methods and data interpretation strategies to reduce the need for repetition, and increase the quality of information for end-users. Passive sampling is an in situ time integrative technique, increasingly used for monitoring pesticides in water. Here, we describe a method using the Chemcatcher® passive sampler, coupled to targeted screening using liquid chromatography-quadrupole-time-of-flight mass spectrometry, and a commercially available library. Statistical analysis was performed using Agilent Mass Profiler Professional software. Water sampling took place over one year, at three riverine sites in the south of England, UK. Statistical interpretation of time integrative data from passive sampling could distinguish regular and episodic pesticide inputs, and detected compounds neglected by routine monitoring methods. One hundred and eleven pesticides were identified including legacy and current use compounds with diverse origins and uses. Spatial and temporal trends were identified enabling prioritisation of seasonal monitoring at each site. This approach maximises the utility of qualitative assessment and may help water quality managers to rationalise pesticide fate in future, providing significant additional insight without the need to increase the scope and cost of monitoring.