Enhanced adsorption of nitrate from water by modified wheat straw: equilibrium, kinetic and thermodynamic studies

Insight into the wheat residues-derived adsorbents for the remediation of organic and inorganic aquatic contaminants: A review

Wheat is a major grain crop of the world that provides a stable food for human consumption. Large amounts of by-products/waste materials are produced after the harvesting and processing of wheat crop. Such materials can cause an environmental issue if not disposed of properly. Several studies have shown that wheat residues can be efficient precursors for adsorbents because of their availability, renewability, lignocellulosic composition, and surface active groups enriched structure. In the literature, there are few review articles that address wheat residues-based adsorbents. However, these reviews were specific in terms of adsorbate or adsorbent and did not provide detailed information about the modification, properties, and regeneration of these adsorbents. This article extensively reviews the utilization of wheat biomass/waste including straw, bran, husk, and stalk as precursors for raw or untreated, chemically treated, carbonaceous, and composite adsorbents against various environmental pollutants. The influences of inlet pollutant amount, adsorbent dose, pH, temperature, and time on the performance of adsorbents against pollutants were considered. The maximum uptakes, equilibrium time, and adsorption nature were identified from isotherms, kinetic, and thermodynamic studies. The highest adsorbed amounts of most tested contaminants were 448.20, 322.58, and 578.13 mg/g for lead, chromium, and copper, 1374.6 and 1449.4 mg/g for methylene blue and malachite green, and 854.75, 179.21, and 107.77 mg/g for tetracycline, phosphate, and nitrate, respectively. For the studied adsorbate/adsorbent systems the adsorption mechanism and regeneration were also discussed. Significant results and future directions are finally presented.

Effective removal of nitrate and phosphate using graphene nanosheets synthesized from waste plastics

In this work, waste plastics have been used with bentonite clay to produce silica-containing graphene nanosheets (GNs) for adsorption of nitrate and phosphate from synthetic water. The GNs were obtained by the two steps process, namely (1) pyrolysis at 750 °C and (2) ball milling. Then, GNs were characterized by Raman spectroscopy, FTIR, XRD, FESEM, HRTEM and EDX spectroscopy, which provided the details of material's morphology, surface properties, and composition. From Raman spectroscopy, D and G bands were found at 1342 cm-1 and 1594 cm-1, respectively, which confirmed the presence of nanosheets on the graphene surface. Furthermore, the layers of nanosheets were confirmed by the HRTEM analysis and XRD peaks. In analytical study, the batch experiment was conducted to investigate the influence of operational parameters such as pH (03-12), contact time (05-120 min), adsorbent dosage (0.01-0.06 g), and initial concentrations of adsorbates (10-50 mg/L for nitrate and 03-15 mg/L for phosphate) on adsorption process. The removal percentage of nitrate and phosphate at optimum dosage = 0.05 g, pH = 6.5, contact time = 60 min, nitrate concentration = 30 mg/L, and phosphate concentration = 09 mg/L were found to be 85 and 91, respectively. The highest adsorption capacity of nitrate and phosphate was found to be 53 mg/g and 16.4 mg/g, respectively. The adsorption behaviour of both nitrate and phosphate showed chemisorption as the experimental data were well fitted by the pseudo-2nd-order kinetic and Langmuir isotherm model. Life cycle cost analysis (LCCA) of the synthesis process was conducted to evaluate the cost-benefit analysis for commercial feasibility. The estimated price for the synthesis of GNs using 1 kg of waste plastics and bentonite clay as precursor was $4.21, suggesting commercialization.

Competitive adsorption of nitrate, phosphate, and sulfate on amine-modified wheat straw: In-situ infrared spectroscopic and density functional theory study

Amine-modified wheat straw (AMWS) has already been reported as a promising adsorbent for nitrate (NO₃) removal due to its cost-effectiveness and high efficiency. However, the NO₃ removal mechanism has not been well understood, especially in the presence of co-existing ions. Here, the effect of co-existing anions on NO₃ removal by AMWS was investigated and the underlying mechanisms were revealed using a combination of in-situ infrared (IR) spectroscopy and computational modeling. The in-situ IR results indicated that NO₃, sulfate (SO₄), and phosphate (PO₄) are all adsorbed as outer-sphere complexes on AMWS. The two-dimensional-correlation spectroscopy analysis implied the adsorption sequence of SO₄ > PO₄ > NO₃. The adsorption energies obtained from density functional theory calculation range from -0.24 to 0.51 eV (-23.2 to 49.2 kJ/mol), confirming that these anions adsorb on AMWS as outer-sphere complexes. For the first time, this study provides direct spectroscopic evidence of the outer-sphere adsorption of NO₃ on AMWS, as well as identifies the adsorption sequence, confirmed by computational modeling. The competitive mechanism of NO_3, SO₄, and PO₄ revealed in this study is helpful to understand and predict the applications of AMWS.

Sensitivity analysis of factors influencing pollutant removal from shallow groundwater by the PRB method based on numerical simulation

Permeable reactive barrier (PRB) is one of the most promising in situ treatment methods for shallow groundwater pollution. However, optimal design of PRB is very difficult due to a lack of comprehensive understanding of various complex influencing factors of PRB remediation. In this study, eight of the main factors of PRB, including hydraulic gradient I, permeability coefficient KPRB of PRB material, PRB length L, PRB width W, PRB distance from pollution source Dist., the ratio of the maximum adsorption capacity to Langmuir constant of PRB material Qmax/KL, the discharge rate of pollution source DR, and recharge concentration RC were investigated, to carry out the sensitivity analysis of PRB removal efficiency. The simulation experiments for Morris analysis were designed, and pollutant removal efficiency was numerically simulated by coupling MODFLOW and MT3DMS under two scenarios of high and low permeability and dispersivity. For a typical low permeability with low dispersity medium, the sensitivity ranking of factors from high to low is DR, RC, I, W, L, Dist., Qmax/KL, and KPRB, and for a typical high permeability with a high dispersity medium, the sensitivity ranking of factors from high to low is I, W, DR, Qmax/KL, L, RC, Dist., and KPRB. When considering multiple factors in PRB design, the greater the KPRB, L, W, Qmax/KL is, the higher the removal efficiency is; the greater the RC, I is, the lower the removal efficiency is. The rest factors remain ambiguous enhancement to removal efficiency.

Efficient Nitrate Adsorption from Groundwater by Biochar-Supported Al-Substituted Goethite

Groundwater nitrate contamination is challenging and requires efficient solutions for nitrate removal. This study aims to investigate nitrate removal using a novel adsorbent, biochar-supported aluminum-substituted goethite (BAG). The results showed that an increase in the initial Al/(Al + Fe) atomic ratio for BAGs from 0 to 20% decreased the specific surface area from 115.2 to 75.7 m2/g, but enhanced the surface charge density from 0.0180 to 0.0843 C/m2. By comparison, 10% of Al/(Al + Fe) led to the optimal adsorbent for nitrate removal. The adsorbent’s adsorption capacity was effective with a wide pH range (4–8), and decreased with increasing ionic strength. The descending order of nitrate adsorption inhibition by co-existing anions was SO42−, HCO3−, PO43−, and Cl−. The adsorption kinetics and isotherms agreed well with the pseudo-first-order equation and Langmuir model, respectively. The theoretical maximum adsorption capacity was 96.1469 mg/g. Thermodynamic analysis showed that the nitrate adsorption was spontaneous and endothermic. After 10-cycle regeneration, the BAG still kept 92.6% of its original adsorption capacity for synthetic nitrate-contaminated groundwater. Moreover, the main adsorption mechanism was attributed to electrostatic attraction due to the enhancement of surface charge density by Al substitution. Accordingly, the BAG adsorbent is a potential solution to remove nitrate from groundwater.

A critical review of various adsorbents for selective removal of nitrate from water: Structure, performance and mechanism

Nitrate is ubiquitous pollutant due to its high water solubility, usually contributing to eutrophication, and posing a threat to aquatic ecosystem and human health. Adsorption approach has been widely used for nitrate removal because of the simplicity, easy operation, and low cost. Adsorbent plays a key role in the adsorptive removal of nitrate. The adsorption performance and adsorption mechanism are determined by the structural feature of adsorbent that is dependent on the preparation method. In this review, various types of adsorbents for nitrate removal were systematically summarized, their preparation, characterization, and adsorption performance were evaluated; the factors influencing the nitrate adsorption performance were discussed; the adsorption isotherm models, kinetic models and thermodynamic parameters were examined; and the possible adsorption mechanisms responsible for nitrate adsorption were categorized; the possible correlation of adsorbent structure to adsorption performance and adsorption mechanism were explained; the potential applications of adsorbents were discussed; finally, the strategies for improving adsorption capacity and selectivity towards nitrate, the challenges and future perspectives for developing novel adsorbent were also proposed. This review will deepen the understanding of nitrate removal by adsorption process and help the development of high-performance adsorbents for selective nitrate removal from water and wastewater.

A review on water treatment technologies for the management of oxoanions: prospects and challenges

Oxoanions are a class of contaminants that are easily released into the aquatic systems either through natural or anthropogenic activities. Depending on their oxidation states, they are highly mobile, resulting in the contamination of underground water. Above the permissible level in groundwater, they pose as threats to mammals when the contaminated water is consumed. Some of the health challenges caused are cancer, neurological, cardiac, gastrointestinal, and skin disorders. Several treatment technologies have been adopted over the years for the management of these oxoanions present in the aquatic systems. However interesting these treatment technologies might be, they also have their limitations such as cost-effectiveness, the complexity of the process, and generation of secondary pollutants. This work focused on some of the water treatment technologies applied for the removal of oxoanions. Some of the advantages and disadvantages of these treatment technologies are also highlighted. Amongst all the treatment technologies, adsorption is the most applied method for the removal of oxoanions. However, photocatalysis has a higher prospect since it is non-selective and secondary pollutants are not generated after the treatment process. Also, photocatalysis can simultaneously reduce and oxidise oxoanions as well as organic pollutants respectively.

Recycling rice husk for removal of phosphate and nitrate from synthetic and swine wastewater: Adsorption study and nutrient analysis of modified rice husk

The objective of this study was to determine the adsorbent potential of rice husk and its modified form for phosphate and nitrate removal from synthetic and swine-farm wastewater. The mechanism of adsorption as well as the potential of phosphate-/nitrate- adsorbed rice husk as nutrient rich residue was also investigated. Two-step modification of RH (using base-washing (BW) and chemical modification (CM) was conducted to compare the phosphate and nitrate removal. The effects of several factors (pH, sorbent dosage, contact time, initial concentration, and coexistence of both ions) were investigated to gain insight into the adsorption rate, behavior, and mechanism of the modified RH regarding phosphate and nitrate removal. The results of Fourier-transform infrared spectroscopy showed that the modification was successful by crosslinking with the amine group of the chemical agent. Fitting the adsorption kinetic data of phosphate showed physical adsorption, intraparticle diffusion, and chemisorption, whereas for nitrate, the data indicated mainly chemisorption. Fitting the adsorption isotherm data of phosphate and nitrate together showed adsorption on a monolayer coating of anions on the homogeneous sorbent's surface. The maximum phosphate and nitrate adsorption capacities were 6.94 and 2.46 mg/g, respectively, for a single adsorbate and 11.14 and 1.76 mg/g, respectively, for the binary solution. In real swine wastewater, removal efficiencies of phosphate, nitrite, nitrate, sulfate, and ammonia were 83.8%, 65.0%, >45.0%, 36.6%, and 2.6%, respectively, indicating that the modified RH would be effective for phosphate and nitrate removal from real wastewater. Finally, nutrient analysis of the phosphate- and nitrate-sorbed RH showed increases in nitrogen and phosphorus, which would be beneficial for further use of the RH as nutrient or fertilizer after adsorption.