Preparation of Nanoparticles Including Antisolvent Drugs by the Combination of Roll Milling and High-pressure Homogenization

Effects of Electrostatic Force and Network Structure on the Stability of Proton-Exchange Membrane Fuel Cell Catalyst Ink

The stability of the catalyst slurry of a proton-exchange membrane fuel cell (PEMFC) is of great significance to its large-scale production and commercialization. In this study, three kinds of slurries with different stabilities were prepared using different probe ultrasonic powers. The influence of electrostatic force and network structure on slurry stability was also studied. In addition, the catalyst layer (CL) and membrane electrode assembly (MEA) were further tested to determine the relationship between slurry stability, CL, and MEA performance. The results showed that the slurry prepared with 600 W dispersion power had the least agglomeration on day 12, which is due to the clusters in the slurry having the smallest average particle size and the largest surface area, thereby allowing them to absorb the most Nafion and have the largest electrostatic force to inhibit agglomeration. However, the slurry with 1200 W dispersion power had the least sedimentation after 9.4 days because the strength of the network structure in the slurry strengthened the most, resulting in a significant increase in viscosity and inhibition of sedimentation. Electrochemical tests showed that the MEA gradually exhibited worse electrical performance and higher impedance due to the agglomeration of catalyst particles caused by the standing process. Altogether, this study provides insights to better understand and regulate the stability of catalyst slurries.

Preparation and Evaluation of a Powdered Rebamipide Mouthwash as In-Hospital Formulation: Considering Dispersion before Use in Patients

In Japan, rebamipide (RB) mouthwash (RB-MW) for oral mucositis induced by cancer chemotherapy has been prepared using in-hospital formulation. Usually, RB-MW is prepared by dispersing crushed commercial RB tablets in the dispersion medium; however, uniformity is difficult to obtain due to low solubility. The current study aims is to prepare homogenously dispersed formulations using the fine particles of crushed tablets by a method that is convenient for hospital use. Commercial RB tablets were pre-milled at different milling times as "RB-Ts". A ground mixture was then prepared by co-grinding the RB-Ts with HPC-L or PVP K30 via a benchtop ball milling machine (MM400). The physicochemical properties of samples were evaluated for PXRD, FTIR, turbidity, particle size, and solubility. Although the milling of RB tablets decreased the crystallinity, the length of milling time did not affect them. In contrast, grinding using MM400 significantly decreased RB crystallinity; their PXRD patterns showed a halo, suggesting the amorphization of RB crystals by grinding. Although solubility and turbidity seemed to be affected by the type of polymer rather than the particle size, every ground mixture showed high dispersibility. Thus, grinding the RB-Ts with polymers appeared to be the most promising way to obtain stable dispersion as an in-hospital formulation.