P-chlorophenol wastewater treatment by microwave-enhanced catalytic wet peroxide oxidation

Performance of Iron-Functionalized Activated Carbon Catalysts (Fe/AC-f) on CWPO Wastewater Treatment

Two commercial activated carbon were functionalized with nitric acid, sulfuric acid, and ethylenediamine to induce the modification of their surface functional groups and facilitate the stability of corresponding AC-supported iron catalysts (Fe/AC-f). Synthetized Fe/AC-f catalysts were characterized to determine bulk and surface composition (elemental analysis, emission spectroscopy, XPS), textural (N2 isotherms), and structural characteristics (XRD). All the Fe/AC-f catalysts were evaluated in the degradation of phenol in ultrapure water matrix by catalytic wet peroxide oxidation (CWPO). Complete pollutant removal at short reaction times (30–60 min) and high TOC reduction (XTOC = 80 % at ≤ 120 min) were always achieved at the conditions tested (500 mg·L−1 catalyst loading, 100 mg·L−1 phenol concentration, stoichiometric H2O2 dose, pH 3, 50 °C and 200 rpm), improving the results found with bare activated carbon supports. The lability of the interactions of iron with functionalized carbon support jeopardizes the stability of some catalysts. This fact could be associated to modifications of the induced surface chemistry after functionalization as a consequence of the iron immobilization procedure. The reusability was demonstrated by four consecutive CWPO cycles where the activity decreased from 1st to 3rd, to become recovered in the 4th run. Fe/AC-f catalysts were applied to treat two real water matrices: the effluent of a wastewater treatment plant with a membrane biological reactor (WWTP-MBR) and a landfill leachate, opening the opportunity to extend the use of these Fe/AC-f catalysts for complex wastewater matrices remediation. The degradation of phenol spiked WWTP-MBR effluent by CWPO using Fe/AC-f catalysts revealed pH of the reaction medium as a critical parameter to obtain complete elimination of the pollutant, only reached at pH 3. On the contrary, significant TOC removal, naturally found in complex landfill leachate, was obtained at natural pH 9 and half stoichiometric H2O2 dose. This highlights the importance of the water matrix in the optimization of the CWPO operating conditions.

Fabrication of iron-dipicolinamide catalyst with Fe-N bonds for enhancing non-radical reactive species under alkaline Fenton process

Iron dipicolinamide (Fedpa), as an efficient Fenton-like catalyst, was fabricated to excite hydrogen peroxide (H₂O₂) for the removal of 2,4-dichlorophenol (2,4-DCP). The unique structures and the electronic properties of Fedpa were contributed to its excellent catalytic performance in alkaline Fenton process. Fe was chelated with dpa by four Fe-N bonds leaved two labile sites, which reduced the oxidation potential of dpa[Fe^III/Fe^II], dpa[Fe^V/Fe^III] or dpa[Fe^IV/Fe^II] to 0.316 V and 1.189 V respectively, and made it easily be bound with H₂O₂ to initiate the reaction. The results showed that 99.5% removal rate of 2,4-DCP (0.58 mM) was achieved by using 0.027 g/L Fedpa and 5.8 mM H₂O₂ in 60 min at pH 9.9. The coordination between Fe and dpa enhanced the catalytic efficiency of Fe^II. The active species generated in Fedpa/H₂O₂ system contained the iron-oxo species (dpaFe^V = O or dpa^IV = O), O₂^- and HO. The iron-oxo species was the main non-radical reactive species for the degradation of 2,4-DCP and some degradation intermediates were detected by GC-QTOF. Furthermore, the influence of factors, such as Fedpa loading, solution pH, temperature and anions (F^-, Cl^-, SO₄^2-, NO₃^- and PO₄^3-) on the catalytic performance of Fedpa were also discussed. This process of complexation between Fe and dpa combined with a green oxidant H₂O₂ presents a new insight for the use of Fenton-like system in the degradation of refractory organics.

Microwave-enhanced catalytic wet peroxide oxidation of quinoline: the influence of pH and H2O2dosage and identification of reactive oxygen species

This article presents a study about the initial pH and H₂O₂dosage influence on TOC abatement by MW-CWPO with Cu/Ni-catalyst and reactive oxygen identification based on quinoline mineralization inhibition using the specific radical scavengers.

Microwaves and their coupling to advanced oxidation processes: enhanced performance in pollutants degradation

This review assesses microwaves (MW) coupled to advanced oxidation processes (AOPs) for pollutants degradation, as well as the basic theory and mechanisms of MW dielectric heating. We addressed the following couplings: MW/H2O2, MW/UV/H2O2, MW/Fenton, MW/US, and MW/UV/TiO2, as well as few studies that tested alternative oxidants and catalysts. Microwave Discharge Electrodeless Lamps (MDELs) are being extensively used with great advantages over ballasts. In their degradation studies, researchers generally employed domestic ovens with minor adaptations. Non-thermal effects and synergies between UV and MW radiation play an important role in the processes. Published papers so far report degradation enhancements between 30 and 1,300%. Unfortunately, how microwaves enhance pollutants is still obscure and real wastewaters scarcely studied. Based on the results surveyed in the literature, MW/AOPs are promising alternatives for treating/remediating environmental pollutants, whenever one considers high degradation yields, short reaction times, and small costs.

Screening of three commercial plant peroxidases for the removal of phenolic compounds in membrane bioreactors

A comparative study of three plant peroxidases, horseradish (HRP), soybean (SBP) and artichoke (AKPC), was carried out to select the most appropriate one for 4-chlorophenol treatment in an ultrafiltration membrane reactor. Soybean peroxidase showed the highest enzymatic activity, followed by HRP and AKPC. The same tendency was observed in a discontinuous tank reactor, where SBP attained more than 90% of4-chlorophenol removal within the pH range tested. The optimum temperature was 30 degrees C, with SBP showing highest thermostability. With the ultrafiltration membrane reactor, SBP attained the highest operational stability, with 4-chlorophenol conversions of around 90% in the permeate stream for up to 200 minutes. Finally, permeate samples were analysed and no significant amount of enzyme was detected, so the observed loss of activity, less pronounced with SBP, was attributed to enzyme adsorption on the polymeric products deposited on the membrane surface. Soybean peroxidase was selected as the most appropriate peroxidase for future research.