Abdominal Aortic Endograft Implantation Immediately Induces Vascular Stiffness Gradients That May Promote Adverse Aortic Neck Dilatation: Results of A Porcine Ex Vivo Study

PURPOSE

Endovascular aortic repair (EVAR) is the method of choice for most abdominal aortic aneurysm (AAA) patients requiring intervention. However, chronic aortic neck dilatation (AND) following EVAR progressively weakens the structural seal between vessel and endograft and compromises long-term results of the therapy. This experimental ex vivo study seeks to investigate mechanisms of AND.

MATERIALS AND METHODS

Porcine abdominal aortas (n=20) were harvested from slaughterhouse pigs and connected to a mock circulation. A commercially available endograft was implanted (n=10) or aortas were left untreated as controls (n=10). Vascular circumferential strain was assessed via ultrasound in defined aortic segments as a parameter of aortic stiffness. Histology and aortic gene expression analysis were performed to investigate potential changes of aortic wall structure and molecular differences due to endograft implantation.

RESULTS

We found that endograft implantation acutely induces a significant stiffness gradient directly at the interface between stented and unstented aortic segments under pulsatile pressure. Comparing stented aortas with unstented controls, we detected increased aortic expression levels of inflammatory cytokines (Il6 and Ccl2) and matrix metalloproteinases (Mmp2 and Mmp9) after 6 hours of pulsatile pressurization. This effect, however, was abolished when repeating the same experiment under 6 hours of static pressure.

CONCLUSIONS

We identified endograft-induced aortic stiffness gradients as an early trigger of inflammatory aortic remodeling processes that might promote AND. These results highlight the importance of adequate endograft designs to minimize vascular stiffness gradients and forestall late complications, such as AND.

CLINICAL IMPACT

AND may compromise the long-term results following endovascular aortic repair. However, the mechanisms behind the underlying detrimental aortic remodeling are still unclear. In this study we find that endograft-induced aortic stiffness gradients induce an inflammatory aortic remodeling response consistent with AND. This novel pathomechanistic insight may guide the design of new aortic endografts that minimize vascular stiffness gradients and forestall late complications such as AND.

TEVAR and EVAR, the unknown knowns of the cardiovascular hemodynamics; and the immediate and long-term consequences of fabric material on major adverse clinical outcome

This review discusses the impact of endovascular aneurysm repair on cardiovascular (CV) hemodynamics and the role of stent-graft material, i.e., polytetrafluoroethylene (PTFE) vs. polyester in post-procedural outcomes. Endovascular aneurysm repair has been widely employed in the last decades for thoracic and abdominal aneurysm repair. However, aortic endografts are stiff and alter the native flow hemodynamics. This failure to simulate the native aorta could lead to added strain on the heart, manifesting as increased left ventricular strain, higher pulse pressure, and congestive heart failure later. This could result in adverse CV outcomes. Also, evidence is mounting to support the implication of stent-graft materials, i.e., PTFE vs. polyester, in adverse post-procedural outcomes. However, there is an absence of level one evidence. Therefore, the only way forward is to plan and perform a randomised controlled trial to demonstrate the alterations in the CV hemodynamics in the short and long run and compare the available stent-graft materials regarding procedural and clinical outcomes. We believe the best solution, for now, would be to reduce the stented length of the aorta. At the same time, in the longer term, encourage continuous improvement in stent-graft materials and design.

Two decades of experience in explantation and graft preserving strategies following primary endovascular aneurysm repair and lessons learned

Objectives

We aim to scrutinize our evolving re-intervention strategies following primary endovascular aortic aneurysm repair (EVAR) - EVAR GORE SalvAge Fabric Technique (ARAFAT), aortic sac double breasting with endograft preservation, and stent-graft explantation.

Methods

We performed 1,555 aortic interventions over the study period, including 910 EVARs. Factors associated with the need for reintervention and the likelihood of chronic fabric fatigue failure (CFFF) were investigated. Using conventional and innovative diagnostic modalities with Prone contrASt enHanced computed tomography Angiography (PASHA), 136 endoleaks (ELs) were identified (15 type I, 98 type II; 18 type III; 5 type IV).

Results

Forty-four (4.84%) patients underwent re-intervention post-primary EVAR; 18 ARAFATs, 12 double breastings, and 14 explantations. Choice of re-intervention was based on patient fitness and mode of failure. Mean EL detection duration following primary EVAR was 53.3 ± 6.82 months, while mean time to re-intervention was 70.20 ± 6.98 months. The mean sac size before the primary EVAR and re-intervention was 6.00 ± 1.75 cm and 7.51 ± 1.94 cm, respectively. Polyester (61.40%) was the most commonly employed stent-graft material. Use of more than three modular stent-graft components (3.42 ± 1.31, p = 0.846); with the proximal stent-graft diameter of 31.6 ± 3.80 cm (p = 0.651) and the use of iliac limbs more than 17 mm (p = 0.364), all added together are contributing factors. We had one peri-operative mortality following explantation due to sepsis-induced multiorgan failure.

Conclusions

Our re-intervention strategies matured from stent graft explantation to graft preservation with endovascular relining of the stent-graft. Graft preservation with aortic sacotomy and double breasting were used to manage concealed ELs due to aortic hygroma.

Combined thoracic endovascular aortic repair and endovascular aneurysm repair and the long-term consequences of altered cardiovascular haemodynamics on morbidity and mortality: case series and literature review

Background

Thoracic and abdominal aortic stent grafts are firmer and more rigid than the native aorta. Aortic implanted devices have been implicated in the development of acute systolic hypertension, elevated pulse pressure, and reduced coronary perfusion.

Case summary

We report four cases of staged thoracic endovascular aortic repair (TEVAR) and then endovascular aneurysm repair (EVAR). All patients had TEVAR first for thoracic aortic aneurysm and later on developed infra-renal abdominal aortic aneurysm (AAA) that required EVAR. There were three males and one female with a median age of 74.5 years (range 67.5-78.5). None of the patients developed aortic-related major clinical adverse effects or required any aortic intervention during their follow-up. However, within 2 years, all patients developed symptomatic left ventricular hypertrophy with diastolic dysfunction. All patients had bilateral lower limb oedema, with on and off chest pain and shortness of breath (SOB), necessitating coronary angiograms, which showed no evidence of coronary artery disease. Three patients died from cardiovascular-related morbidities, and the fourth patient is still complaining of SOB despite a normal coronary angiogram.

Discussion

Aortic-endograft compliance mismatch is an invisible enemy, with troubling consequences for the aorta proximal and distal to the endograft. Aortic stiffness due to vascular endograft could lead to cardiovascular adverse events, even in the absence of direct aortic-related complications. After combined TEVAR and EVAR, the compliance mismatch and elasticity loss are even more pronounced than with TEVAR alone, which necessitates patient monitoring for the development of cardiovascular complications.

Influence of shape-memory stent grafts on local aortic compliance

The effect of repair techniques on the biomechanics of the aorta is poorly understood, resulting in significant levels of postoperative complications for patients worldwide. This study presents a computational analysis of the influence of Nitinol-based devices on the biomechanical performance of a healthy patient-specific human aorta. Simulations reveal that Nitinol stent-grafts stretch the artery wall so that collagen is stretched to a straightened high-stiffness configuration. The high-compliance regime (HCR) associated with low diastolic lumen pressure is eliminated, and the artery operates in a low-compliance regime (LCR) throughout the entire cardiac cycle. The slope of the lumen pressure–area curve for the LCR post-implantation is almost identical to that of the native vessel during systole. This negligible change from the native LCR slope occurs because the stent-graft increases its diameter from the crimped configuration during deployment so that it reaches a low-stiffness unloading plateau. The effective radial stiffness of the implant along this unloading plateau is negligible compared to the stiffness of the artery wall. Provided the Nitinol device unloads sufficiently during deployment to the unloading plateau, the degree of oversizing has a negligible effect on the pressure–area response of the vessel, as each device exerts approximately the same radial force, the slope of which is negligible compared to the LCR slope of the native artery. We show that 10% oversizing based on the observed diastolic diameter in the mid descending thoracic aorta results in a complete loss of contact between the device and the wall during systole, which could lead to an endoleak and stent migration. 20% oversizing reaches the Dacron enforced area limit (DEAL) during the pulse pressure and results in an effective zero-compliance in the later portion of systole.

Innovative textile structures designed to prevent type III endoleaks in endovascular stent-grafts

The damage caused to the fabric of endovascular stent-grafts most often occurs at the contact zones between the fabrics where they are attached to the apices of Z-shaped stents as a result of normal physiologic pulsatile movement within angulated vessels in vivo. Although design improvements were made over the years, the risks were not fully eliminated even with the newer M-shaped stent reconfiguration. In this study, we proposed to create and manufacture a novel fabric for stent-grafts with specifically designed reinforced zones to enhance resistance to fabric abrasion. These reinforced zones are set at the vicinity of the apices of the Z-shaped stents and between two adjacent Z-shaped stents where folding and pleating are commonly observed to occur in angulated vessels. Three innovative weaving structures with two different types of yarns and two controls were designed and prepared. Two commonly used commercial devices supported, respectively, with ringed stents, and Z-shaped stents were selected as the references for comparison. Textile structures including thickness, water permeability, mechanical properties, (more specifically tensile and bursting stress, as well as fatigue simulation) were tested on all fabrics. Compared to commercially available plain weaves, the fabrics with locally reinforced zones showed improved mechanical characteristics and fatigue resistant properties. A fabric designed with specifically reinforced zones has now clearly been shown to effectively reduce the abrasion caused by the apices of Z-shaped stents. However, further optimization may still be possible.