Flexural wave propagation velocity and bone mineral density in females with and without tibial bone stress injuries

Bone adaptation to a mechanical loading program significantly increases skeletal fatigue resistance

Using a mechanical loading program to induce bone adaptation, we found that small (<2-fold) changes in the structural properties of the rat ulna increased its fatigue resistance >100-fold. This indicates that a moderate exercise program may be an effective preventative strategy for stress fractures.

INTRODUCTION

There are currently limited preventative strategies for stress fractures. Because stress fracture risk is directly influenced by skeletal properties, it has been hypothesized that modification of these properties using a mechanical loading program may positively influence risk. The aim of this study was to investigate whether the bone changes associated with a mechanical loading program can enhance skeletal fatigue resistance.

MATERIALS AND METHODS

Site-specific mechanical loading was performed on one forearm of adult female Sprague-Dawley rats using the axial compression loading model. Loading was performed 3 days/week for 5 consecutive weeks to induce adaptation. The loaded and nonloaded ulnas in each animal were removed after the loading program, and their material and structural properties were determined. The ulna pairs were subsequently loaded until fatigue failure at the same constant peak axial load.

RESULTS

Mechanical loading induced consistent and predictable changes in the structural properties of loaded ulnas, with the largest change being a nearly 2-fold increase in midshaft minimum second moment of area (I(MIN)). The mechanical-loading induced bone changes resulted in a >100-fold increase in fatigue resistance in loaded ulnas, with resistance being exponentially related to the structural properties of the ulna.

CONCLUSIONS

This study found that by enhancing the structural properties of a bone through a mechanical loading program, its fatigue resistance could be significantly improved. This indicates that an exercise program aimed at modifying bone structure may be used as a possible prevention strategy for stress fractures.

Distal tibia areal bone mineral density: use in detecting low aBMD of the hip in young women

Dual-energy X-ray absorptiometry (DXA) is a primary clinical tool for identification of adults with low areal bone mineral density (aBMD) and who are at increased risk for future osteoporosis and fragility fractures. Procedures for several aBMD scans of clinical interest might be limited by artifact, inaccessible anatomical regions, and positioning errors. Sites for scanning that overcome these limitations need further investigation for application to large-scale screening and relevance to clinical decisions regarding diagnosis and treatment. In this study, 146 women (mean +/- SE age = 20.1 +/- 0.1 yr, height = 163.3 +/- 0.2 cm, weight = 60.0 +/- 0.2 kg) underwent DXA of the total body (TB) and right and left total proximal femurs (TPF), total forearms (TF), and distal tibiae (DT). Osteopenia was identified in 24 women. Areal BMD was positively related among all measurement sites (r = 0.55-0.81, all p < 0.001). Total body, TF, and DT aBMD each displayed low sensitivity (0.29-0.33) and high specificity (0.95-0.98) to detect osteopenia of the TPF. Addition of TB fat-free mass slightly enhanced the predictive value of DT aBMD. Overall, DT aBMD can discriminate between osteopenic and normal subjects with comparable accuracy to TB or TF aBMD.

Ground Reaction Forces and Bone Parameters in Females with Tibial Stress Fracture

PURPOSE

Tibial stress fracture is a common overuse running injury that results from the interplay of repetitive mechanical loading and bone strength. This research project aimed to determine whether female runners with a history of tibial stress fracture (TSF) differ in ground reaction force (GRF) parameters during running, regional bone density, and tibial bone geometry from those who have never sustained a stress fracture (NSF).

METHODS

Thirty-six female running athletes (13 TSF; 23 NSF) ranging in age from 18 to 44 yr were recruited for this cross-sectional study. The groups were well matched for demographic, training, and menstrual parameters. A force platform measured selected GRF parameters (peak and time to peak for vertical impact and active forces, and horizontal braking and propulsive forces) during overground running at 4.0 m.s.(-1). Lumbar spine, proximal femur, and distal tibial bone mineral density were assessed by dual energy x-ray absorptiometry. Tibial bone geometry (cross-sectional dimensions and areas, and second moments of area) was calculated from a computerized tomography scan at the junction of the middle and distal thirds.

RESULTS

There were no significant differences between the groups for any of the GRF, bone density, or tibial bone geometric parameters (P > 0.05). Both TSF and NSF subjects had bone density levels that were average or above average compared with a young adult reference range. Factor analysis followed by discriminant function analysis did not find any combinations of variables that differentiated between TSF and NSF groups.

CONCLUSION

These findings do not support a role for GRF, bone density, or tibial bone geometry in the development of tibial stress fractures, suggesting that other risk factors were more important in this cohort of female runners.