Hypolipidemic activities of partially deacetylated α-chitin nanofibers/nanowhiskers in mice

Bioactive carbohydrate polymers from marine sources as potent nutraceuticals in modulating obesity: a review

The majority of bioactive polysaccharides are present in some marine creatures. These polysaccharides are considered as promising anti-obesity agents, their anti-obesity properties involve a number of mechanisms, including suppression of lipid metabolism and absorption, impact on satiety, and prevention of adipocyte differentiation. Obesity is linked to type 2 diabetes, cardiovascular disease, and other metabolic syndromes. In this review various bioactive polysaccharides like chitin, chitosan, fucosylated chondroitin sulphate, chitooligosaccharides and glycosaminoglycans have been discussed for their anti-obesity effects through various pathways. Critical evaluation of observational studies and intervention trials on obesity, lipid hypertrophy, dyslipidemia, and type 2 diabetes was done with a primary focus on specific marine fauna polysaccharide as a source of seafood that is consumed all over the world. It has been observed that consumption of individual seafood constituents was effective in reducing obesity. Thus, marine derived novel bioactive polysaccharides have potential applications in food and pharmaceutical industries.

Polysaccharide-based biosorbents for cholesterol and bile salts in gastric-intestinal passage: Advances and future trends

Cholesterol is one of the hazard elements for many cardiovascular diseases, but many cholesterol-lowering drugs are expensive and unhealthy. Therefore, it is necessary to develop edible and safe biosorbents to reduce excess cholesterol and bile salts in the gastric-intestinal passage. Polysaccharide-based biosorbents offer a feasible strategy for decreasing them. This review summarized polysaccharide-based biosorbents that have been developed for adsorbing cholesterol and bile salts from the gastric-intestinal passage and analyzed common modification methods for these adsorbents. Finally, the adsorption models were also elucidated. Polysaccharides, including β-cyclodextrin, pectin, chitin/chitosan, dietary fiber extract, and cellulose, have been proposed for adsorbing cholesterol and bile salts in the gastric-intestinal passage as biosorbents. This is mainly due to the retention of pores, the capture of the viscosity network, and the help of hydrophobic interactions. In spite of this, the adsorption capacity of polysaccharides is still limited. Therefore, the modifications for them became the most popular areas in the recent studies of in vitro cholesterol adsorption. Chemical approaches namely grafting, (1) acetylation, (2) hydroxypropylation, (3) carboxymethylation, and (4) amination are considered to modify the polysaccharides for higher adsorption ability. Moreover, ultrasonic/microwave/pressure treatment and micron technology (microfluidization, micronization, and ball milling) are effective physical modification methods, while the biological approach mainly refers to enzymatic hydrolysis and microbial fermentation. The adsorption models are generally explained by two adsorption isotherms and two adsorption kinetics. In sum, it is reckoned that further food applications will follow soon.

A review on extraction of polysaccharides from crustacean wastes and their environmental applications

Disposal of biodegradable waste of seashells leads to an environmental imbalance. A tremendous amount of wastes produced from flourishing shell fish industries while preparing crustaceans for human consumption can be directed towards proper utilization. The review of the present study focuses on these polysaccharides from crustaceans and a few important industrial applications. This review aimed to emphasize the current research on structural analyses and extraction of polysaccharides. The article summarises the properties of chitin, chitosan, and chitooligosaccharides and their derivatives that make them non-toxic, biodegradable, and biocompatible. Different extraction methods of chitin, chitosan, and chitooligosaccharides have been discussed in detail. Additionally, this information outlines possible uses for derivatives of chitin, chitosan, and chitooligosaccharides in the environmental, pharmaceutical, agricultural, and food industries. Additionally, it is essential to the textile, cosmetic, and enzyme-immobilization industries. This review focuses on new, insightful suggestions for raising the value of crustacean shell waste by repurposing a highly valuable material.

Fortification of puffed biscuits with chitin and crayfish shell: Effect on physicochemical property and starch digestion

Chitin is a polysaccharide and possesses numerous beneficial properties such as nontoxicity, biodegradability and biocompatibility, which draws much attention to its applications in food. Crayfish shell is a source of chitin alongside an antioxidants and a potential source of beneficial dietary fiber. In this study, chitin (CH) and crayfish shell (CS) with different concentrations were used to study their impact on pasting characteristics of flour mixture (wheat flour and glutinous rice flour) and influence on physicochemical and starch digestion property of puffed biscuit. The Rapid Visco-Analyzer results showed that the viscosity of powder mixture was decreased with the ratio of CH and CS increased. CH resulted in lowest peak viscosity and breakdown values of mixed powder. It was indicated that increasing amounts of CH and CS led to significantly reduced moisture content, expansion ratio but raised density of biscuits. CH and CS inhibited starch digestion and promoted a remarkable increase (P < 0.05) of resistant starch (RS) content. The hydrolysis kinetic analysis suggested a decelerating influence of CH on the hydrolysis content with lower values of equilibrium hydrolysis percentage (C∞) while CS on hydrolysis rate with lower kinetic constant (K). The estimated glycemic index (eGI) of the CH (15-20%) samples were below 55. These results are of great significance in delaying starch digestion and provided a better choice in design of fried puffed snacks for special crowd with chronic diseases such as diabetes, cardiovascular disease, and obesity.

Maria H, Gopi S, Volova T, C. M. Fernandes S, Thomas S. Extraction of Nanochitin from Marine Resources and Fabrication of Polymer Nanocomposites: Recent Advances

Industrial sea food residues, mainly crab and shrimp shells, are considered to be the most promising and abundant source of chitin. In-depth understanding of the biological properties of chitin and scientific advancements in the field of nanotechnology have enabled the development of high-performance chitin nanomaterials. Nanoscale chitin is of great economic value as an efficient functional and reinforcement material for a wide range of applications ranging from water purification to tissue engineering. The use of polymers and nanochitin to produce (bio) nanocomposites offers a good opportunity to prepare bioplastic materials with enhanced functional and structural properties. Most processes for nanochitin isolation rely on the use of chemical, physical or mechanical methods. Chitin-based nanocomposites are fabricated by various methods, involving electrospinning, freeze drying, etc. This review discusses the progress and new developments in the isolation and physico-chemical characterization of chitin; it also highlights the processing of nanochitin in various composite and functional materials.

Comparison of cast films and hydrogels based on chitin nanofibers prepared using TEMPO/NaBr/NaClO and TEMPO/NaClO/NaClO2 systems

Neutral TEMPO/NaClO/NaClO₂ (TNN) oxidation, with NaClO₂ as the primary oxidant under aqueous conditions at pH 6.8 was applied to selectively oxidize surface C6 primary hydroxyl groups of α-chitin to carboxylate groups. When 0.1 mmol TEMPO, 1 mmol NaClO and 20 mmol NaClO₂ were added to 1 g α-chitin, the yield of water-insoluble oxidized chitin was 91.93 %, and the carboxylate content was 0.695 mmol/g. The TNN oxidized chitin (TNN-Ch) was mostly converted to individual nanofibrils by mechanical disintegration in water, with mostly widths of 20-24 nm and average lengths of 1 μm. Compared to chitin nanofibers produced by TEMPO/NaBr/NaClO system (TBN-ChNs), with average widths of 16.67 ± 7.9 nm and average lengths of 770 ± 170 nm, TNN-ChNs were wider, longer and had a higher aspect ratio; its films and hydrogels also showed better mechanical properties, which indicated the size effect on the nanofiber-based materials resulted from different oxidation process.