Development of a micro-miniature nanoindentation instrument with a force resolution of 1 nN

A MEMS nanoindenter with an integrated AFM cantilever gripper for nanomechanical characterization of compliant materials

This work presents the development of a MEMS nanoindenter that uses exchangeable AFM probes for quasi-static nanomechanical characterization of compliant and ultra-compliant materials. While the electrostatic micro-force transducer of the MEMS nanoindenter provides a maximum indentation depth up to 9.5 µm with a maximum output force of 600 µN, experimental investigations reveal that it can achieve a depth and force resolution better than 4 pm Hz^-1/2 and 0.3 nN Hz^-1/2, in air for f≥ 1 Hz. A passive AFM probe gripper is integrated into the MEMS nanoindenter, allowing the nanoindenter to utilize various AFM probes as an indenter for material testing. A proof-of-principle experimental setup has been built to investigate the performance of the MEMS nanoindenter prototype. In proof-of-principle experiments, the prototype with a clamped diamond AFM probe successfully identified an atomic step (∼0.31 nm) within a Si < 111 > ultraflat sample using the scanning probe microscopy mode. The nanomechanical measurement capability of the MEMS nanoindenter prototype has been verified by means of measurements of reference polymer samples using a silicon AFM probe and by means of measurements of the elastic properties of a PDMS sample using a spherical diamond-coated AFM probe. Owing to its compact and low-cost but high-resolution capacitive readout system, this MEMS nanoindenter head can be further applied for in-situ quantitative nanomechanical measurements in AFMs and SEMs.

A microelectromechanical systems (MEMS) force-displacement transducer for sub-5 nm nanoindentation and adhesion measurements

We present a highly sensitive force-displacement transducer capable of performing ultra-shallow nanoindentation and adhesion measurements. The transducer utilizes electrostatic actuation and capacitive sensing combined with microelectromechanical fabrication technologies. Air indentation experiments report a root-mean-square (RMS) force resolution of 1.8 nN and an RMS displacement resolution of 0.019 nm. Nanoindentation experiments on a standard fused quartz sample report a practical RMS force resolution of 5 nN and an RMS displacement resolution of 0.05 nm at sub-10 nm indentation depths, indicating that the system has a very low system noise for indentation experiments. The high sensitivity and low noise enables the transducer to obtain high-resolution nanoindentation data at sub-5 nm contact depths. The sensitive force transducer is used to successfully perform nanoindentation measurements on a 14 nm thin film. Adhesion measurements were also performed, clearly capturing the pull-on and pull-off forces during approach and separation of two contacting surfaces.