A microanalytical study of the surfaces of normal, delipidized, and artificially "resurfaced" articular cartilage

Zwitterionic Poly-Carboxybetaine Polymers Restore Lubrication of Inflamed Articular Cartilage

Osteoarthritis is a degenerative joint disease that is associated with decreased synovial fluid viscosity and increased cartilage friction. Though viscosupplements are available for decades, their clinical efficacy is limited and there is ample need for more effective joint lubricants. This study first evaluates the tribological and biochemical properties of bovine articular cartilage explants after stimulation with the inflammatory cytokine interleukin-1β. This model is then used to investigate the tribological potential of carboxybetaine (CBAA)-based zwitterionic polymers of linear and bottlebrush architecture. Due to their affinity for cartilage tissue, these polymers form a highly hydrated surface layer that decreases friction under high load in the boundary lubrication regime. For linear pCBAA, these benefits are retained over several weeks and the relaxation time of cartilage explants under compression is furthermore decreased, thereby potentially boosting the weeping lubrication mechanism. Bottlebrush bb-pCBAA shows smaller benefits under boundary lubrication but is more viscous than linear pCBAA, therefore providing better lubrication under low load in the fluid-film regime and enabling a longer residence time to bind to the cartilage surface. Showing how CBAA-based polymers restore the lost lubrication mechanisms during inflammation can inspire the next steps toward more effective joint lubricants in the future.

Natural joints: Boundary lubrication and antiphospholipid syndrome (APS)

The paper shows that osteoporosis (OA) changes the SF content and the lipid profile substantially. To estimate the implication of the lipid environment in case the articular cartilage (AC) changes, we measured friction coefficient normal samples, with early and late stages of (OA). During joint inflammation and osteoarthritis, enzymatically activated β₂-Glycoprotein I is transformed into antibody conformation. Our hypothesis about cartilage degradation of PL bilayers by antibodies (β₂-Glycoprotein I) is considering antiphospholipid syndrome (APS), which was not discussed in the literature before. Deactivated PL molecule has no ability to form bilayers, lamellar phases, and liposomes. The phospholipid content in synovial fluid (SF) during joint inflammation, osteoarthritis, and rheumatoid arthritis is significantly higher (2-3 times) above the normal concentration of PL, and has a poor boundary-lubricating ability is deactivated.

Repulsive surfaces and lamellar lubrication of synovial joints

Surface-active phospholipid (SAPL) secreted in the synovial joint plays an important role in cartilage integrity. In healthy joints, phospholipid multibilayers coat the cartilage surface, providing boundary lamellar-repulsive hydration lubrication. Current mechanism for lubrication of synovial joints, as well as the physical and chemical nature of the cartilage surface is discussed. Friction between phospholipid (PL) bilayers attached to cartilage surfaces is considered including a discussion on the recent observation of an extreme friction reduction as a consequence of a less charged hydrophilic cartilage surface. It is proposed that the highly efficient lubrication occurring in natural joints arises from the presence of negatively charged cartilage surfaces. The lamellar-repulsive mechanisms for the reduction of friction is supported by phospholipid lamellar phases and charged macromolecules residing between contacting cartilage surfaces at pH ∼7.4.

The Probable Explanation for the Low Friction of Natural Joints

The surface of an articular cartilage, coated with phospholipid (PL) bilayers, plays an important role in its lubrication and movement. Intact (normal) and depleted surfaces of the joint were modelled and the pH influence on the surface interfacial energy, wettability and friction were investigated. In the experiments, the deterioration of the PL bilayer was controlled by its wettability and the applied friction. The surrounding fluid of an undamaged articular cartilage, the synovial fluid, has a pH value of approximately 7.4. Buffer solutions were formulated to represent the synovial fluid with various pH values. It was found that the surface interfacial energy was stabilised at its lowest values when the pH varied between 6.5 and 9.5. These results suggested that as the PL bilayers deteriorated, the hydration repulsion mechanism became less effective as friction increased. The decreased number of bilayers changed the wettability and lowered PL lubricant properties.

Investigation of Cell-Substrate Adhesion Properties of Living Chondrocyte by Measuring Adhesive Shear Force and Detachment Using AFM and Inverse FEA

It is well-known that cell adhesion is important in many biological processes such as cell migration and proliferation. A better understanding of the cell adhesion process will shed insight into these cellular biological responses as well as cell adhesion-related diseases treatment. However, there is little research which has attempted to investigate the process of cell adhesion and its mechanism. Thus, this paper aims to study the time-dependent adhesion properties of single living chondrocytes using an advanced coupled experimental-numerical approach. Atomic Force Microscopy (AFM) tips will be used to apply lateral forces to detach chondrocytes that are seeded for three different periods. An advanced Finite Element Analysis (FEA) model combining porohyperelastic (PHE) constitutive model and cohesive zone formulation is developed to explore the mechanism of adhesion. The results revealed that the cells can resist normal traction better than tangential traction in the beginning of adhesion. This is when the cell adhesion molecules establish early attachment to the substrates. After that when the cells are spreading, stress fiber bundles generate tangential traction on the substrate to form strong adhesion. Both simulation and experimental results agree well with each other, providing a powerful tool to study the cellular adhesion process.

Tribological efficacy and stability of phospholipid-based membrane lubricants in varying pH chemical conditions

In this study, the authors examine the influence of joint chemical environment by measuring changes in the tribological properties (friction coefficient and charge density) of contacting surfaces of normal and degenerated cartilage samples in bath solutions of varying pH (2.0-9.0). Bovine articular cartilage samples (n = 54) were subjected to several surface measurements, including interfacial energy, contact angle, and friction coefficient, at varying pH. The samples were delipidized and then subjected to the same measurement protocols. Our results reveal that the interfacial energy and charge density, which have been shown to be related to friction coefficient, decrease with pH in the acidic range and approach constant values at physiological (or synovial fluid) pH of 7.4 and beyond it, i.e., toward basic pH domain. The authors conclude that this rather complex response explains the long-term efficacy with respect to ageing and associated pH changes, of the phospholipid layers that facilitate the almost frictionless, hydration-lubrication involving contact in the mammalian musculoskeletal system.

Microscale consolidation analysis of relaxation behavior of single living chondrocytes subjected to varying strain-rates

Besides the elastic stiffness, the relaxation behavior of single living cells is also of interest of various researchers when studying cell mechanics. It is hypothesized that the relaxation response of the cells is governed by both intrinsic viscoelasticity of the solid phase and fluid-solid interactions mechanisms. There are a number of mechanical models have been developed to investigate the relaxation behavior of single cells. However, there is lack of model enable to accurately capture both of the mechanisms. Therefore, in this study, the porohyperelastic (PHE) model, which is an extension of the consolidation theory, combined with inverse Finite Element Analysis (FEA) technique was used at the first time to investigate the relaxation response of living chondrocytes. This model was also utilized to study the dependence of relaxation behavior of the cells on strain-rates. The stress-relaxation experiments under the various strain-rates were conducted with the Atomic Force Microscopy (AFM). The results have demonstrated that the PHE model could effectively capture the stress-relaxation behavior of the living chondrocytes, especially at intermediate to high strain-rates. Although this model gave some errors at lower strain-rates, its performance was acceptable. Therefore, the PHE model is properly a promising model for single cell mechanics studies. Moreover, it has been found that the hydraulic permeability of living chondrocytes reduced with decreasing of strain-rates. It might be due to the intracellular fluid volume fraction and the fluid pore pressure gradients of chondrocytes were higher when higher strain-rates applied.

Determination of Strain-Rate-Dependent Mechanical Behavior of Living and Fixed Osteocytes and Chondrocytes Using Atomic Force Microscopy and Inverse Finite Element Analysis

The aim of this paper is to determine the strain-rate-dependent mechanical behavior of living and fixed osteocytes and chondrocytes, in vitro. First, atomic force microscopy (AFM) was used to obtain the force–indentation curves of these single cells at four different strain-rates. These results were then employed in inverse finite element analysis (FEA) using modified standard neo-Hookean solid (MSnHS) idealization of these cells to determine their mechanical properties. In addition, a FEA model with a newly developed spring element was employed to accurately simulate AFM evaluation in this study. We report that both cytoskeleton (CSK) and intracellular fluid govern the strain-rate-dependent mechanical property of living cells whereas intracellular fluid plays a predominant role on fixed cells' behavior. In addition, through the comparisons, it can be concluded that osteocytes are stiffer than chondrocytes at all strain-rates tested indicating that the cells could be the biomarker of their tissue origin. Finally, we report that MSnHS is able to capture the strain-rate-dependent mechanical behavior of osteocyte and chondrocyte for both living and fixed cells. Therefore, we concluded that the MSnHS is a good model for exploration of mechanical deformation responses of single osteocytes and chondrocytes. This study could open a new avenue for analysis of mechanical behavior of osteocytes and chondrocytes as well as other similar types of cells.

Microscale surface friction of articular cartilage in early osteoarthritis

Articular cartilage forms the articulating surface of long bones and facilitates energy dissipation upon loading as well as joint lubrication and wear resistance. In normal cartilage, boundary lubrication between thin films at the cartilage surface reduces friction in the absence of interstitial fluid pressurization and fluid film lubrication by synovial fluid. Inadequate boundary lubrication is associated with degenerative joint conditions such as osteoarthritis (OA), but relations between OA and surface friction, lubrication and wear in boundary lubrication are not well defined. The purpose of the present study was to measure microscale boundary mode friction of the articular cartilage surface in an in vivo experimental model to better understand changes in cartilage surface friction in early OA. Cartilage friction was measured on the articular surface by atomic force microscopy (AFM) under applied loads ranging from 0.5 to 5 μN. Microscale AFM friction analyses revealed depth dependent changes within the top-most few microns of the cartilage surface in this model of early OA. A significant increase of nearly 50% was observed in the mean engineering friction coefficient for OA cartilage at the 0.5 μN load level; no significant differences in friction coefficients were found under higher applied loads. Changes in cartilage surface morphology observed by scanning electron microscopy included cracking and roughening of the surface indicative of disruption and wear accompanied by an apparent disintegration of the thin surface lamina from the underlying matrix. Immunohistochemical staining of lubricin - an important cartilage surface boundary lubricant - did not reveal differences in spatial distribution near the cartilage surface in OA compared to controls. The increase in friction at the 0.5 μN force level is interpreted to reflect changes in the interfacial mechanics of the thin surface lamina of articular cartilage: increased friction implies reduced lubrication efficiency and a higher potential for cartilage surface wear in OA. The effects of mechanical or biochemical changes or loss of the thin surface lamina on the remaining tissue with respect to OA progression is unknown and requires further study, but preservation of the surface lamina seems an important early target for the maintenance of cartilage health and prevention of OA.