Pellets for oral administration of low-molecular-weight heparin

Buccal delivery of low molecular weight heparin by cationic polymethacrylate nanoparticles

Buccal delivery seems to be a very promising administration route for macromolecular drugs. Here, we explored the potential of cationic polymethacrylate nanoparticles (NPs) as a carrier system for the buccal delivery of low molecular weight heparin (LMWH). LMWH-loaded NPs were prepared by emulsification solvent diffusion method and the NPs were analyzed for their physiochemical properties, rheological evaluations and ex vivo transport studies across buccal mucosa. The prepared LMWH-loaded NPs showed a mean diameter between 400 and 500nm with unimodal size distribution with negative surface charge. Viscosity measurements revealed a positive rheological synergism between the prepared NPs and mucin when mixed under physiological conditions. After 4h, about 6.3±0.9% of LMWH was released in case of using Eudragit^® RS (ERS); while Eudragit^® RL (ERL) NPs released only 3.0±0.3 % of its LMWH content and this incomplete release was slightly ameliorated in the presence of mucin reaching to 7.2±0.3 % and 4.8±0.3 % for ERS and ERL, respectively. The ex-vivo permeability of heparin through the buccal mucosa was significantly increased after using polymetharylate NPs while no heparin permeation was detected from free heparin solution. Confocal laser scanning microscopy (CLSM) imaging indicated the mucoadhesive properties of the polymetharylate NPs where the drug-free NPs were detected in the superficial layers of buccal mucosa. LMWH-loaded NPs had less mucoadhesive properties showing significant deeper penetration of the mucosa. The results indicated that mucoadhesive cationic polymethacrylate NPs offer a possible approach for the buccal delivery of heparin.

Preparation and evaluation of a novel oral delivery system for low molecular weight heparin

OBJECTIVE

The objective of the present work was to prepare and evaluate a novel oral formulation for systemic delivery of low molecular weight heparin (LMWH). The formulation consisted of Eudragit S 100-coated positively charged liposomes encapsulating LMWH and a penetration enhancer.

MATERIALS AND METHODS

Positively charged liposomes were first prepared by the thin film hydration method using lipid (soy phosphotidylcholine and cholesterol) and stearyl amine (SA) in the optimum ratio of 16:1, along with cetylpyridinium chloride (CPC) as a penetration enhancer. Prepared liposomes were coated with negatively charged Eudragit S 100 (0.3% w/v). The formulations were studied for various in vitro and in vivo properties. Differential scanning calorimetry (DSC), x-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR) studies, and in vitro drug release were used for in vitro characterization of the formulations. Ex vivo permeation studies were performed by using distal small intestine of rat. Oral absorption studies were conducted with the rat model.

RESULTS

Coating of the liposomes was confirmed by SEM and particle size determination studies. In vitro release studies of coated liposomes have demonstrated that the release of LMWH was in the following order: Stomach < small intestine < distal small intestine < colon. Ex vivo permeation studies have shown a fivefold increase in permeation of LMWH with Eudragit S 100-coated liposomes compared to uncoated, uncharged liposomes. Oral absorption studies have showed that with Eudragit-coated liposomes, the oral bioavailability of LMWH was improved, compared to plain LMWH solution. This is revealed by a threefold increase in the area under the curve (AUC) of the plasma concentration time curve.

CONCLUSION

A novel formulation for oral delivery of LMWH was thus successfully prepared and evaluated.

Development of enoxaparin sodium polymeric microparticles for colon-specific delivery

Background and aims

Recent studies have shown that low molecular weight heparins are effective in the treatment of inflammatory bowel disease. Therefore, there is considerable interest in the development of an oral colonic delivery pharmaceutical system allowing targeted release of heparin in the inflamed tissue. The objective of this study was to prepare microparticles for the oral administration and colonic release of enoxaparin and to evaluate the influence of certain formulation factors on their characteristics.

Methods

Microparticles were prepared by water/oil/water double emulsion technique followed by solvent evaporation. The influence of several formulation factors on the characteristics of microparticles were evaluated. The formulation factors were alginate concentration in the inner aqueous phase, polymer (Eudragit^® FS 30D and Eudragit^® RS PO) concentration in the organic phase and ratios between the two polymers. The microparticles were characterized in terms of morphology, size, entrapment efficiency and enoxaparin release.

Results

The results showed that increasing sodium alginate percentage reduced the encapsulation efficiency of enoxaparin and accelerated enoxaparin release. Regarding the influence of the two polymers, reducing polymer concentration in the organic phase led to a smaller size of microparticles, a lower entrapment efficiency and an important retardation of enoxaparin release. The formulation prepared with Eudragit^® FS 30D limited the release to a maximum of 3% in gastric simulated environment, a specific characteristic of oral systems for colonic delivery, and fulfilled our objective to delay the release.

Conclusions

Microparticles prepared with Eudragit^® FS 30D represent a suitable and potential oral system for the colonic delivery of enoxaparin.

Oral delivery of low molecular weight heparin by polyaminomethacrylate coacervates

PURPOSE

Oral bioavailability of low molecular weight heparin (LMWH) can be achieved by several advanced drug delivery approaches. Here, a new preparation method for coacervates (CAs) using non-toxic polyethylene glycol derivates was developed.

METHODS

LMWH were coacervated with polyaminomethacrylates (Eudragit® RL or RS) using polyethylene glycol (PEG) derivatives as non-toxic solvents. CAs were analyzed for their physicochemical properties and pharmacokinetic parameters were determined for different formulations in rabbits.

RESULTS

CAs from both polymer types using various PEGs were of irregular shape and had particle sizes of around 40 μm, encapsulation efficiencies of >90%, and complete LMWH in vitro release was obtained within 2 h. In vivo, oral Absorption at doses of 300 IU/kg was rather low (F < 2.5%) while dose increase resulted in a maximum at 600 IU/kg (FRL: 6.0 ± 1.2%; FRS: 5.8 ± 2.5%) and 1,200 IU/kg did not result in higher bioavailability (FRL: 4.6 ± 0.4%; FRS: 4.1 ± 0.8%). CAs were applicable to various LMWH types where the oral availability decreased in the order fondaparinux>enoxaparin>nadroparin>certoparin depending mainly on the molecular weight.

CONCLUSIONS

CAs prepared by an organic solvent-free method allowed the oral delivery of LMWHs. The therapeutic efficiency and the simple and solvent-free manufacturing process underlines the high potential of this new preparation method.

New challenges for a second-generation low-molecular-weight heparin: focus on bemiparin

Bemiparin is a second-generation low-molecular-weight heparin (LMWH) that has the lowest molecular weight, the longest half-life and the highest anti-Factor Xa/anti-Factor IIa activity ratio. The safety and efficacy of bemiparin has been demonstrated in several studies and currently it is licensed for the treatment and prophylaxis of venous thromboembolism (VTE), as well as for the prevention of clotting in the extracorporeal circuit during hemodialysis. Multicenter pharmacoeconomic studies carried out in the Spanish National Health system indicate that bemiparin is more cost effective than enoxaparin for the prevention of VTE in total knee replacement. Interestingly, recent results suggest that bemiparin could be useful as an adjuvant treatment in the management of lower-extremity diabetic ulcers. Since international guidelines recommend LMWHs for initial and continuous anticoagulant treatment in cancer patients with VTE, as well as for its prevention, results from ongoing trials could be critical to establish the potential of bemiparin in oncological patients. Finally, the pharmacokinetics of two oral bemiparin formulations are currently being analyzed in a Phase I trial.