Solubilization of Carbamazepin by Different Classes of Nonionic Surfactants and a Bile Salt

Predicting Leachables Solubilization in Polysorbate 80 Solutions by a Linear Solvation Energy Relationship (LSER)

PURPOSE

A linear solvation energy relationship (LSER) was developed to predict the partitioning of neutral chemicals from polysorbate 80 (PS 80) micelles to water. Predicted partition coefficients were converted to a concentration dependent solubilization strength of aqueous PS 80 solutions. This solubilization strength represents a key parameter to project equilibrium levels of leaching from pharmaceutical plastic materials.

METHODS

To construct the LSER model equation, partition coefficients between PS 80 micelles and water were measured via a reference phase method or collected from the literature. Multiple linear regression of partition coefficients against five publicly available solute parameters was used to obtain the LSER system parameters.

RESULTS

112 chemically diverse compounds were incorporated for LSER model regression. The model equation shows a very good fit (R² = 0.969, SD = 0.219) for the entire dataset. The accuracy of the multi-parameter LSER model was proven to be substantially better in comparison to a single-parameter log-linear model based on the octanol-water partition coefficient.

CONCLUSION

PS 80 solubilization strength in water can expediently and accurately be calculated for neutral organic compounds with the proposed LSER model. LSER system parameters provide insightful chemical information with respect to solubilization in aqueous solutions of PS 80.

Strategies to address low drug solubility in discovery and development

Drugs with low water solubility are predisposed to low and variable oral bioavailability and, therefore, to variability in clinical response. Despite significant efforts to "design in" acceptable developability properties (including aqueous solubility) during lead optimization, approximately 40% of currently marketed compounds and most current drug development candidates remain poorly water-soluble. The fact that so many drug candidates of this type are advanced into development and clinical assessment is testament to an increasingly sophisticated understanding of the approaches that can be taken to promote apparent solubility in the gastrointestinal tract and to support drug exposure after oral administration. Here we provide a detailed commentary on the major challenges to the progression of a poorly water-soluble lead or development candidate and review the approaches and strategies that can be taken to facilitate compound progression. In particular, we address the fundamental principles that underpin the use of strategies, including pH adjustment and salt-form selection, polymorphs, cocrystals, cosolvents, surfactants, cyclodextrins, particle size reduction, amorphous solid dispersions, and lipid-based formulations. In each case, the theoretical basis for utility is described along with a detailed review of recent advances in the field. The article provides an integrated and contemporary discussion of current approaches to solubility and dissolution enhancement but has been deliberately structured as a series of stand-alone sections to allow also directed access to a specific technology (e.g., solid dispersions, lipid-based formulations, or salt forms) where required.

The influence of various excipients on the conversion kinetics of carbamazepine polymorphs in aqueous suspension

The influence of various excipients on the conversion of carbamazepine polymorphs to the dihydrate in aqueous suspension has been investigated. Ten excipients having functional groups which were potentially able to form hydrogen bonds with carbamazepine (group 1: methylcellulose, hypromellose (hydroxypropyl methylcellulose), hydroxypropylcellulose (HPC), 2-hydroxyethylcellulose (HEC), carmellose sodium (sodium carboxymethylcellulose), cellobiose; group 2: povidone (polyvinylpyrrolidone), povidone-vinyl acetate copolymer (povidone/VA) and N-methyl-2-pyrrolidone; group 3: macrogol (polyethylene glycol) and polyethylene oxide-polypropylene oxide copolymer (PEO/PPO)) were selected. Carbamazepine polymorphic forms III and I were dispersed separately into each aqueous excipient solution (0.1%, w/v) for 30 min at room temperature. The inhibition effect of each excipient was quantified using Raman spectroscopy combined with multivariate analyses. The solubility parameter of each excipient was calculated and used for categorizing excipients. Excipients in groups 1 and 2, which had both low solubility parameters (< 27.0 MPa½) and strong hydrogen bonding groups, inhibited the conversion completely. With increasing solubility parameter, the inhibition effect decreased for group 1 excipients, especially for carbamazepine form I, which had a higher specific surface area. Also, the excipients of group 3, lacking strong hydrogen bonding groups, showed poor inhibition although they had low solubility parameters (< 21.0 MPa½). This study indicated the importance of both hydrogen bonding interaction and a suitable hydrophobicity (expressed by the solubility parameter) in the inhibition of the conversion of carbamazepine to the dihydrate.

Influence of Polymorphic Form, Morphology, and Excipient Interactions on the Dissolution of Carbamazepine Compacts

To gain a deeper understanding of the behavior of carbamazepine (CBZ) and CBZ dihydrate (DH) compacts during in vitro dissolution tests various factors were investigated: hydrate formation of CBZ, crystal morphology, surface area, and excipient influence. Dissolution tests were performed in three different dissolution media: distilled water, hydroxypropyl methylcellulose (HPMC), and polyethylene glycol (PEG) solutions. For the CBZ compacts, the dissolution rate of CBZ in water was fastest (0.338 mg L(-1) min(-1)). With increasing ability of the excipients to inhibit the hydration of CBZ (PEG < HPMC), surprisingly the dissolution rate of CBZ compacts decreased: PEG solution (0.314 mg L(-1) min(-1)) > HPMC solution (0.257 mg L(-1) min(-1)). This implies that DH formation resulted in an apparent increase in the dissolution rate rather than slowing it down. For the DH compacts, the dissolution rate in water (0.055 mg L(-1) min(-1)) was slower than that of PEG and HPMC solutions (0.174 and 0.178 mg L(-1) min(-1), respectively). The contact angle measurements showed a significantly higher value in water (61.0 degrees) than in PEG and HPMC solutions (44.8 degrees and 43.1 degrees, respectively). Although the dissolution of CBZ and DH compacts in various dissolution media are complex processes, the influence and relative importance of these factors were clearly detected providing better understanding of the dissolution behavior of the drug.

Dendrimers: Novel Polymeric Nanoarchitectures for Solubility Enhancement

Poor solubility and hydrophobicity of drugs/bioactives limit their possible applications in drug delivery and formulation development. Apart from conventional methods of solubility enhancement, there are some novel methods which can be used in solubilization. Dendrimers represent a novel type of polymeric material that has generated much interest in many diverse areas due to their unique structure and properties. Dendrimer-mediated solubility enhancement mainly depends on factors such as generation size, dendrimer concentration, pH, core, temperature, and terminal functionality. Added advantage in solubilization can be achieved considering these factors. Available literature suggests that ionic interaction, hydrogen bonding, and hydrophobic interactions are the possible mechanisms by which a dendrimer exerts its solubilizing property. This review presents various mechanisms and reports relating to solubility enhancement using dendrimers. Also, micellar behavior and future possibilities in relation to solubilization via dendrimers are included.

Examination of the solubilization of drugs by bile salt micelles

The purpose of this review is to provide a critical examination of the reported solubilization of drugs by bile salt micelles. The underlying premise is that with better information regarding the inherent biological complexity, efforts to predict the oral bioavailability of drug will be enhanced. The common means of comparing the reported values was chosen to be the solubilization ratio. This is equal to the moles of drug solubilized per mole of bile salt. The values were segregated according to bile salt type, temperature, ionic strength, and the presence and absence of added lipids. Only segregation by bile salt type was pairwise statistically significant. From the solubilization ratios and the reported values of the aqueous solubility, the logarithms of the mole fraction micelle partition coefficients, log K(m/a), were calculated. The log K(m/w) was found to be correlated with the reported logarithm of the octanol/water partition coefficient. The rank order of slopes of the log K(m/a) as a function of log K(o/w) was cholate approximately taurodeoxycholate > glycocholate approximately taurocholate approximately glycodeoxycholate, with deoxycholate not being statistically different from the other data sets. The slope and intercept for the bile salt mixed micelle systems were 0.600 and 2.44, respectively, which were statistically indistinguishable from glycocholate, taurocholate, and glycodeoxycholate bile salt data. The existence of statistically significant correlations suggests that predicting the solubilization in the intestine may be possible with in vitro measurements if additional information is gathered in the appropriate micellar solutions.

Relationship between polysorbate 80 solubilization descriptors and octanol-water partition coefficients of drugs

The molar solubilization capacities (kappa) and the molar micelle-water partition coefficients (K(M)(N)) in Polysorbate 80 of several drugs (including barbiturates, steroids, and benzoic acid derivatives) are related to their log octanol-water partition coefficients (logP). Both kappa and K(M)(N) values were calculated from solubility versus Polysorbate 80 concentration profiles, which were either experimentally determined or obtained from the literature. There is a linear relationship between logP of the tested compounds and the logarithm of the molar micelle-water partition coefficient (logK(M)(N)). On the other hand molar solubilization capacities are nearly independent of logP. It is shown that the ability of Polysorbate 80 to solubilize a drug can be predicted from its logP value.