Deposition of naphthalene and tetradecane vapors in models of the human respiratory system

A filter-based system mimicking the particle deposition and penetration in human respiratory system for secondhand smoke generation and characterization

INTRODUCTION

Secondhand smoke endangers both the environment and the health of nonsmokers. Due to the scarcity of repeatable data generated by human subjects, a system capable of generating representative secondhand smoke is essential for studying smoke properties. This work presents the design and validation of a filter-based system that could mimic the particle deposition and penetration in human respiratory system for secondhand smoke generation and characterization.

METHODS

Guided by our study on characterizing size-dependent filtration efficiency of common materials, we identified three filter media that generate similar particle deposition efficiencies compared to different regions of the human respiratory system over a wide submicron size range. We demonstrated the performance of the proposed filter-based system using various operating conditions. Additionally, we compared the properties of secondhand smoke particles to those of primary smoke particles.

RESULTS

The difference in aerosol deposition efficiencies between the filter-based system and the International Commission on Radiological Protection (ICRP) model was less than 10% in the size range of 30 to 500 nm. High concentrations of metals were detected in the secondhand smoke. The contents of Ni and Cr generated from the secondhand electronic cigarettes are at least 20 and 5 times above the regulated daily maximum intake amount.

CONCLUSION

Given the agreement in aerosol respiratory deposition between the filter-based system and the ICRP model, such a system can facilitate laboratory studies of secondhand smoke due to its simple structure, high repeatability, and ease of control while remaining free of human subjects.

Nanoparticle mass transfer from lung airways to systemic regions--Part I: Whole-lung aerosol dynamics

This is a two-part paper describing inhaled nanoparticle (NP) transport and deposition in a model of a human respiratory tract (Part I) as well as NP-mass transfer across barriers into systemic regions (Part II). Specifically, combining high-resolution computer simulation results of inhaled NP deposition in the human airways (Part I) with a multicompartmental model for NP-mass transfer (Part II) allows for the prediction of temporal NP accumulation in the blood and lymphatic systems as well as in organs. An understanding of nanoparticle transport and deposition in human respiratory airways is of great importance, as exposure to nanomaterial has been found to cause serious lung diseases, while the use of nanodrugs may have superior therapeutic effects. In Part I, the fluid-particle dynamics of a dilute NP suspension was simulated for the entire respiratory tract, assuming steady inhalation and planar airways. Thus, a realistic airway configuration was considered from nose/mouth to generation 3, and then an idealized triple-bifurcation unit was repeated in series and parallel to cover the remaining generations. Using the current model, the deposition of NPs in distinct regions of the lung, namely extrathoracic, bronchial, bronchiolar, and alveolar, was calculated. The region-specific NP-deposition results for the human lung model were used in Part II to determine the multicompartmental model parameters from experimental retention and clearance data in human lungs. The quantitative, experimentally validated results are useful in diverse fields, such as toxicology for exposure-risk analysis of ubiquitous nanomaterial as well as in pharmacology for nanodrug development and targeting.