Short communication: Effect of stirring operations on changes in physical and rheological properties of nonfat yogurts during storage

Effects of changes in homogenization sequence and temperature for milk on physicochemical properties of stirred yoghurt

In this study, the effects of homogenization sequence (before or after heat treatment) and homogenization temperature (40, 50 and 60 °C) for milk were investigated on physicochemical properties of stirred yoghurt. Stirred yoghurts were produced from homogenized and subsequently heat-treated milks, and heat-treated and subsequently homogenized milks and stored at 4 °C for 30 days. Number of grains, mean perimeter of grains, visual roughness, firmness, apparent viscosity, consistency coefficient in yoghurts produced from homogenized milk after heat treatment were higher, compared to those in yoghurts produced from milk homogenized before heat treatment, and these increased when homogenization temperature increased. To conclude, this study showed that some physicochemical properties of yoghurt were changed, by altering homogenization sequence and homogenization temperature for milk.

Effects of Freezing Raw Yak Milk on the Fermentation Performance and Storage Quality of Yogurt

In this study, the effects of freezing yak milk at -20 °C and -40 °C for 30, 90 and 180 days on the fermentation characteristics and storage quality of the corresponding yogurt were discussed. The results showed that, compared with that of yogurt made from fresh yak milk, the lactic acid bacteria (LAB) growth and acid production rate of the yogurt in the -20 °C group decreased at 90 d. The water-holding capacity, viscosity and hardness decreased during storage, and a sour taste was prominent, while no significant changes were observed in the -40 °C group. At 180 d of freezing, the post-acidification of the yogurt in the -20 °C and -40 °C groups increased after 21 d of storage. Compared with the -40 °C group, the -20 °C group showed a significant decrease in LAB counts, a decrease in pH value to 3.63-3.80 and poor texture and sensory quality.

Effect of the Heat Exchanger Type on Stirred Yogurt Properties Formulated at Different Total Solids and Fat Contents

In this work stirred yogurts were produced using a technical scale pilot in which the cooling step was processed using either a tubular (THX; low shear) or a plate (PHX, high shear) heat exchanger. The aim was to determine how total solids (TS, adjusted using lactose) and fat contents (FC) impact stirred yogurt properties during storage, depending on the heat exchanger used. Using raw milk, cream, skim milk powder, and lactose, four yogurts were formulated at 16.5% TS and 4.2% proteins, with different FC (0.0, 1.3, 2.6, and 3.9%); one more control yogurt was formulated at 14% TS, 4.2% proteins, and 0.0% FC. Analyses of yogurts (firmness, viscosity, induced syneresis) were realized at days 1, 3, 7, 21, and 34 after production. The addition of lactose between the non-fat yogurt at 14 or 16.5% TS had little to no effect on stirred yogurt properties. Increasing FC reduced syneresis while increasing firmness and viscosity. The use of PHX reduced the syneresis compared to THX; however, it also tended to reduce the firmness of the yogurts with 3.9% FC.

Quinoa flour as a skim milk powder replacer in concentrated yogurts: Effect on their physicochemical, technological, and sensory properties

Milk standardization with solids (i.e., nonfat milk solids, MSNF) for yogurt manufacture is traditionally achieved by the addition of skim milk powder (SMP). However, the addition of SMP to milk‐based yogurt increases lactose content and decreases both protein content and gel firmness. Thus, in this work, quinoa flour (QF; 0%, 25%, 50%, 75%, and 100% w/w) was used to replace SMP in concentrated yogurt. The physicochemical, textural, and sensory properties and microstructure of the yogurt were evaluated during cold storage. Generally, protein content, water‐holding capacity, and L* value decreased, while syneresis, textural attributes, and viscosity increased with increasing QF content. The substitution of high levels of QF (>25%, w/w) for SMP led to significantly shorter fermentation times, as compared to the control sample. The scanning electron microscopy observations showed significant changes in the yogurt microstructure as a consequence of QF replacement. Samples with 25% (w/w) substitution of QF and control had the highest scores in overall acceptance. According to the results, QF could be applied as an interesting raw material for concentrating the milk‐based yogurt at substitution level of 25% (w/w).