Experimental study on co-culture of DiI labeled rat bone marrow mesenchymal stem cells and polycaprolactone film in vitro to make a cell patch

Hydrogel composed of type II collagen, chondroitin sulfate and hyaluronic acid for cartilage tissue engineering

BACKGROUND

Cartilage tissue engineering is a promising way to repair cartilage defects. Different materials have been applied in the preparation of cartilage hydrogels, but all with various disadvantages.

OBJECTIVE

The aim of this study was to prepare cartilage hydrogel using type II collagen, chondroitin sulfate and hyaluronic acid, to explore their gelation effect and compressive strength, and to analyze the feasibility of their application in cartilage tissue engineering.

METHODS

Type II collagen (Col II), hyaluronic acid (HA) and chondroitin sulfate (CS) were mixed in a certain proportion to prepare gel scaffolds; changes in chemical groups were detected by Fourier transform infrared. After the hydrogel was prepared, its compressive strength was measured. Umbilical cord stem cells were co-cultured with hydrogel scaffolds to observe its cytocompatibility and analyze whether stem cells had cellular activity during co-culture; histological staining was applied to observe the hydrogel loaded with stem cells.

RESULTS

Cartilage hydrogels were successfully prepared with good compressive strength, and Fourier transform infrared analysis showed that Schiff base reaction occurred during the preparation process and tight chemical cross-linking was formed. The results of umbilical cord stem cell co-culture showed that the hydrogel had good cytocompatibility and the stem cells had good activity in the hydrogel.

CONCLUSIONS

Cartilage hydrogels with stable structures were successfully prepared and had good compressive strength. Hydrogel scaffold could provide a suitable living environment for umbilical cord stem cells, so that they maintain normal cell morphology and activity, and has a good application potential in cartilage tissue engineering.

Preparation of myocardial patches from DiI-labeled rat bone marrow mesenchymal stem cells and neonatal rat cardiomyocytes contact co-cultured on polycaprolactone film

DiI-labeled BMSCs were contact co-cultured with CMs on PCL film to prepare myocardial patches. BMSCs were labeled with DiI dye. DiI-labeled BMSCs were co-cultured with CMs on PCL film in the experimental group, while CMs were replaced with the same amount of unlabeled BMSCs in the control group. After 24 h, cell growth was observed by light microscopy and cells were fixed for scanning electron microscopy. After 7 days of co-culture, cells were stained for immunofluorescence detection of myocardial markers cardiac troponin T (cTnT) and α-actin. Differentiation of BMSCs on PCL was observed by fluorescence microscopy. The efficiency of BMSC differentiation into CMs was analyzed by flow cytometry on the first and seventh days of co-culture. CMs were stained with calcein alone and contact co-cultured with DiI-labeled BMSCs on PCL film to observe intercellular dye transfer. Finally, cells were stained for immunofluorescence detection of connexin 43 (Cx43) expression and to observe the relationship between gap junctions and contact co-culture. After co-culture for 24 h, cells were observed to have attached to PCL by light microscopy. Upon appropriate excitation, DiI-labeled BMSCs exhibited red fluorescence, while unlabeled CMs did not. Scanning electron microscopy revealed a large number of cells on the PCL membrane and their cell state appeared normal. On the seventh day, some DiI-labeled BMSCs expressed cTnT and α-actin. Flow cytometry showed that the rate of stem cell differentiation in the experimental group was significantly higher than the control group on the seven day (20.12% > 3.49%, P < 0.05). From the second day of co-culture, immunofluorescence staining for Cx43 revealed green fluorescent puncta in some BMSCs; from the third day of co-culture, a portion of BMSCs exhibited green fluorescence in dye transfer tests. Contact co-culture of DiI-labeled BMSCs and CMs on PCL film successfully generated myocardial patches.