Fabrication and fuzzy analysis of AAO membrane with manipulated pore diameter for applications in biotechnology

Simulation and Analysis of Anodized Aluminum Oxide Membrane Degradation

Microelectromechanical systems (MEMS)-based filter with microchannels enables the removal of various microorganisms, including viruses and bacteria, from fluids. Membranes with porous channels can be used as filtration interfaces in MEMS hemofilters or mini-dialyzers. The main problems associated with the filtration process are optimization of membrane geometry and fouling. A nanoporous aluminum oxide membrane was fabricated using an optimized two-step anodization process. Computational strength modeling and analysis of the membrane with specified parameters were performed using the ANSYS structural module. A fuzzy simulation was performed for the numerical analysis of flux through the membrane. The membrane was then incorporated with the prototype for successive filtration. The fluid flux and permeation analysis of the filtration process have been studied. Scanning electron microscope (SEM) micrographs of membranes have been obtained before and after the filtration cycles. The SEM results indicate membrane fouling after multiple cycles, and thus the flux is affected. This type of fabricated membrane and setup are suitable for the separation and purification of various fluids. However, after several filtration cycles, the membrane was degraded. It requires a prolonged chemical cleaning. High-density water has been used for filtration purposes, so this MEMS-based filter can also be used as a mini-dialyzer and hemofilter in various applications for filtration. Such a demonstration also opens up a new strategy for maximizing filtration efficiency and reducing energy costs for the filtration process by using a layered membrane setup.

Simulation, analysis, fabrication and characterization of tunable AAO membrane for microfluidic filtration

Microfluidic filtration is an essential process in many biomedical applications. Micro or nanoporous membranes are used for colloidal retention. During the membrane filtration process visualization of various phenomena is challenging. Theoretical models have been proposed to visualize the transport mechanism. In this work, ANSYS Fluent is used for 3D designing of the microfluidic system and Fuzzy simulations are used to study flow rate and velocity, to get the maximum benefit from Anodized Aluminium oxide membrane in practical applications. The proposed method exploits relations between driving force, membrane area, and fluid flow. After optimization of parameters for the filtration, the AAO membrane with desired pore diameter was fabricated using the two-step anodization method. Scanning electron microscope is used for characterization of fabricated AAO membrane. The simulated and theoretical results using computer-based programs are then compared for manipulation of flow rate during the filtration process. Along with the manipulation of flow rate from nanoporous membrane other challenges faced during the filtration process are also highlighted with possible solutions.