Electrospun Ta-MOF/PEBA Nanohybrids and Their CH4 Adsorption Application

Green electrospun Janus membrane of polyether block amide (PEBA) doped with hierarchical magnesium hydrogen phosphate for the removal of pharmaceuticals and personal care products

It has been a challenge to prepared polyether block amide (PEBA) fibrous membrane via solution electrospinning. The only few reported methods though involved hazardous solvents and surfactants which were against the principle of green chemistry. In this work, uniform fibrous membrane of PEBA was successfully fabricated by solution electrospinning with a bio-based solvent dihydrolevoglucosenone (Cyrene). To further improve the mechanical strength and adsorption performance of the PEBA membrane, a hierarchical magnesium hydrogen phosphate (MgHPO4·1.2H2O, MHP) was synthesized to blend evenly into the PEBA matrix. A Janus MHP/PEBA membrane with one side of hydrophobic surface and the other side of hydrophilic surface was subsequently prepared, which exhibited fast adsorption, high capacity, good selectivity and reusability towards ibuprofen, acetaminophen, carbamazepine and triclosan. In addition, the Janus membrane showed high removal efficiency of the above contaminants in secondary wastewater effluent with good long term stability. It demonstrated that this Janus MHP/PEBA membrane had a good potential in practical wastewater treatment.

Synthesis of a novel Cu/DPA-MOF/OP/CS hydrogel with high capability in antimicrobial studies

Today, with the indiscriminate use of antibiotics, we face the resistance of some bacterial strains against some antibiotics. Therefore, it is essential to report and synthesize new compounds with antimicrobial properties. A novel copper/dipicolinic acid-metal-organic framework cross-linked oxidized pectin and chitosan (Cu/DPA-MOF/OP/CS) hydrogel polymer was synthesized under environmental conditions with the controllable process, which uses biodegradable polymer compounds such as pectin and chitosan in its structure. The efficient physicochemical features of the synthesized Cu/DPA-MOF/OP/CS hydrogel using SEM, FT-IR, TGA, BET, XRD, and EDS/mapping were identified and confirmed. The newly synthesized Cu/DPA-MOF/OP/CS hydrogel showed activity against Gram-positive and Gram-negative bacterial strains and fungal species, and significant antibacterial and antifungal properties were observed. In antibacterial activity, the MIC against Gram-positive species was in the range of 16-128 mg/mL, the MIC against Gram-negative species was in the range of 64-256 mg/mL, and the MIC against fungal species was in the range of 128-512 mg/mL. In antimicrobial evaluations, in addition to the MIC test, the MBC test, the MFC test, and the IZD test were performed, and the results were reported. The results were compared with commercial antibiotics in the market. Development of novel nanostructures based on hydrogel polymers with distinctive functionality can affect the performance of these nanostructures in different areas.

Advances in the Application of Electrospun Drug-Loaded Nanofibers in the Treatment of Oral Ulcers

Oral ulcers affect oral and systemic health and have high prevalence in the population. There are significant individual differences in the etiology and extent of the disease among patients. In the treatment of oral ulcers, nanofiber films can control the drug-release rate and enable long-term local administration. Compared to other drug-delivery methods, nanofiber films avoid the disadvantages of frequent administration and certain side effects. Electrospinning is a simple and effective method for preparing nanofiber films. Currently, electrospinning technology has made significant breakthroughs in energy-saving and large-scale production. This paper summarizes the polymers that enable oral mucosal adhesion and the active pharmaceutical ingredients used for oral ulcers. Moreover, the therapeutic effects of currently available electrospun nanofiber films on oral ulcers in animal experiments and clinical trials are investigated. In addition, solvent casting and cross-linking methods can be used in conjunction with electrospinning techniques. Based on the literature, more administration systems with different polymers and loading components can be inspired. These administration systems are expected to have synergistic effects and achieve better therapeutic effects. This not only provides new possibilities for drug-loaded nanofibers but also brings new hope for the treatment of oral ulcers.