Neuromechanics of Dynamic Balance Tasks in the Presence of Perturbations

Treadmill-based system for postural studies: Design and validation

Computer-controlled treadmills are common in many gait labs and offer great potential for conducting perturbation-based postural studies. However, the time-course of these disturbances can be too brief to be controlled manually through product software. Here we present a system that combines a Bertec® split-belt treadmill with custom hardware and software to deliver postural disturbances during standing and record data from multiple sources simultaneously. We used this system to administer to 15 healthy participants an 8-session perturbation-based training protocol in which they learned to respond without stepping to progressively larger perturbations. Kinematic, electromyographic, and force data were collected throughout. Motion capture was used to characterize the accuracy and repeatability of the treadmill-delivered perturbations with respect to duration, displacement, and peak velocity. These (observed) data were compared to that expected based on software commands and the known constraints of the treadmill (i.e., 10 Hz operating speed). We found perturbation durations to be as expected. Peak velocities and displacements were slightly higher than expected (average increases were 0.59 cm/s and 1.76 cm, respectively). Because this increase in magnitude was consistent, it did not impede training or affect data analysis. Treadmill behavior was repeatable across 95 % of trials.

Proactive Modulation in the Spatiotemporal Structure of Muscle Synergies Minimizes Reactive Responses in Perturbed Landings

Stability training in the presence of perturbations is an effective means of increasing muscle strength, improving reactive balance performance, and reducing fall risk. We investigated the effects of perturbations induced by an unstable surface during single-leg landings on the mechanical loading and modular organization of the leg muscles. We hypothesized a modulation of neuromotor control when landing on the unstable surface, resulting in an increase of leg muscle loading. Fourteen healthy adults performed 50 single-leg landings from a 30 cm height onto two ground configurations: stable solid ground (SG) and unstable foam pads (UG). Ground reaction force, joint kinematics, and electromyographic activity of 13 muscles of the landing leg were measured. Resultant joint moments were calculated using inverse dynamics and muscle synergies with their time-dependent (motor primitives) and time-independent (motor modules) components were extracted via non-negative matrix factorization. Three synergies related to the touchdown, weight acceptance, and stabilization phase of landing were found for both SG and UG. When compared with SG, the motor primitive of the touchdown synergy was wider in UG (p < 0.001). Furthermore, in UG the contribution of gluteus medius increased (p = 0.015) and of gastrocnemius lateralis decreased (p < 0.001) in the touchdown synergy. Weight acceptance and stabilization did not show any statistically significant differences between the two landing conditions. The maximum ankle and hip joint moment as well as the rate of ankle, knee, and hip joint moment development were significantly lower (p < 0.05) in the UG condition. The spatiotemporal modifications of the touchdown synergy in the UG condition highlight proactive adjustments in the neuromotor control of landings, which preserve reactive adjustments during the weight acceptance and stabilization synergies. Furthermore, the performed proactive control in combination with the viscoelastic properties of the soft surface resulted in a reduction of the mechanical loading in the lower leg muscles. We conclude that the use of unstable surfaces does not necessarily challenge reactive motor control nor increase muscle loading per se. Thus, the characteristics of the unstable surface and the dynamics of the target task must be considered when designing perturbation-based interventions.

Standing on unstable surface challenges postural control of tracking tasks and modulates neuromuscular adjustments specific to task complexity

Understanding the modulations of motor control in the presence of perturbations in task conditions of varying complexity is a key element towards the design of effective perturbation-based balance exercise programs. In this study we investigated the effect of mechanical perturbations, induced by an unstable surface, on muscle activation and visuo-postural coupling, when actively tracking target motion cues of different complexity. Four postural tasks following a visual oscillating target of varying target complexity (periodic-sinusoidal vs. chaotic-Lorenz) and surface (stable-floor vs. unstable-foam) were performed. The electromyographic activity of the main plantarflexor and dorsiflexor muscles was captured. The coupling between sway and target was assessed through spectral analysis and the system's local dynamic stability through the short-term maximum Lyapunov exponent. We found that external perturbations increased local instability and deteriorated visuo-motor coupling. Visuo-motor deterioration was greater for the chaotic target, implying that the effect of the induced perturbations depends on target complexity. There was a modulation of the neuromotor system towards amplification of muscle activity and coactivation to compensate surface-related perturbations and to ensure robust motor control. Our findings provide evidence that, in the presence of perturbations, target complexity induces specific modulations in the neuromotor system while controlling balance and posture.