A Morphological and Morphometric Dental Analysis as a Forensic Tool to Identify the Iberian Wolf (Canis Lupus Signatus)

Advances in Animal Anatomy

This Special Issue was the result of reviewing Leonardo da Vinci's anatomical drawings of the bear foot and the horse trunk (among others) [...].

Post-Mortem Dental Profile as a Powerful Tool in Animal Forensic Investigations—A Review

Veterinary forensics is becoming more important in our society as a result of the growing demand for investigations related to crimes against animals or investigations of criminal deaths caused by animals. A veterinarian may participate as an expert witness or may be required to give forensic assistance, by providing knowledge of the specialty to establish a complete picture of the involvement of an animal and allowing the Courts to reach a verdict. By applying diverse dental profiling techniques, not only can species, sex, age-at-death, and body size of an animal be estimated, but also data about their geographical origin (provenance) and the post-mortem interval. This review concentrates on the dental techniques that use the characteristics of teeth as a means of identification of freshly deceased and skeletonised animals. Furthermore, this highlights the information that can be extracted about the animal from the post-mortem dental profile.

Comparative craniometric measurements of two Canid species in Egypt: the Egyptian red fox and the Egyptian Baladi dog

The Egyptian red fox (Vulpes vulpes aegyptiaca) and Egyptian Baladi dog (Canis familiaris) are two members of the Family Canidae that are widely distributed in Egypt. The skulls of different Canid species vary greatly in their size and shape; therefore, they can be used as a tool to study the evolution and evolutionary history of these animals. The craniometric measurements are crucial for species identification and determination of the specific sites for nerve blocks. The present study compared the craniometric measurements of the red fox and Baladi dog skulls by measuring 47 parameters on each skull and calculation of 8 indices. The red fox skull had significantly lower values of 41 craniometric measurements (approximately 87% of the measurements done), including skull length, width, and height, cranial length and width, palatal and mandibular length, and dental measurements. In contrast, the red fox had significantly higher values of only 3 measurements (approximately 6% of the measurements done) including the tympanic bulla measurement. While only three skull measurements did not differ significantly between the red fox and dog. Statistics revealed that domestic dog had significantly higher values of foramen magnum and palatine indices, and significantly lower value of nasal index than those of red fox. The present work reported variations in the gross and craniometric measurements of skull between the red fox and dog. The measured cranial parameters of both adult animals provide valuable information that can be used in ecological studies, comparative anatomy, and clinical veterinary sciences.

Morphometric analysis for the sex determination of the skull of the Deltari Ilir dog (Canis lupus familiaris) of Kosovo

This study aimed to explain the sex determination of the autochthonous dog Deltari Ilir with both morphometric and geometric analysis methods. For this purpose, 24 Deltari Ilir dog skulls (12 females and 12 males) were used in the study. The difference between males and females at 6 values was statistically significant. The most statistically significant difference was seen in the measurement of the greatest breadth of the occipital condyles (p < 0.000). This measurement was higher in male skulls. The next most significant difference was seen in the greatest inner height of the orbit measurement (p < 0.002). This measurement was also higher than for females. In general, the skull length measurements of male dogs were higher than that of females. Male dog skulls had greater skull length and skull height. The lateral view was used for geometric analysis and 14 landmarks were determined. As a result of principal component analysis, 22 PC values were obtained. PC1 accounted for 23.73% of the total variance. As a result of canonical variants analysis, it was observed that males and females were completely separated from each other. The caudal part of the males was wider than the females in geometric analysis. As a result of the study, sex-determining characteristics were revealed for the Deltari Ilir dog. It was seen that gender analysis could be done with both morphometric and geometric analysis methods. In addition, it was seen that morphometric results and geometric analysis results supported each other. Moreover, the results of the study will be useful in the function of comparative anatomy, in veterinary clinical practice, in zooarchaeology but why not also in the veterinary forensic investigation.

3D Insights into the Effects of Captivity on Wolf Mastication and Their Tooth Marks; Implications in Ecological Studies of Both the Past and Present

Human populations have been known to develop complex relationships with large carnivore species throughout time, with evidence of both competition and collaboration to obtain resources throughout the Pleistocene. From this perspective, many archaeological and palaeontological sites present evidence of carnivore modifications to bone. In response to this, specialists in the study of microscopic bone surface modifications have resorted to the use of 3D modeling and data science techniques for the inspection of these elements, reaching novel limits for the discerning of carnivore agencies. The present research analyzes the tooth mark variability produced by multiple Iberian wolf individuals, with the aim of studying how captivity may affect the nature of tooth marks left on bone. In addition to this, four different populations of both wild and captive Iberian wolves are also compared for a more in-depth comparison of intra-species variability. This research statistically shows that large canid tooth pits are the least affected by captivity, while tooth scores appear more superficial when produced by captive wolves. The superficial nature of captive wolf tooth scores is additionally seen to correlate with other metric features, thus influencing overall mark morphologies. In light of this, the present study opens a new dialogue on the reasons behind this, advising caution when using tooth scores for carnivore identification and contemplating how elements such as stress may be affecting the wolves under study.