Evaluation of the Morphometry of Sperm from the Epididymides of Dogs Using Different Staining Methods

Kinematic and Morphometric Assessment of Fresh Semen, before, during and after Mating Period in Brahman Bulls

The objective of the present study was to determine the effects that the reproductive season has on the motility, kinematics, morphology, and sperm morphometry of Brahman bulls evaluated with a commercial CASA system. The experiment was carried out at the Costa Rica Institute of Technology from March to August 2021. A total of eight Brahman bulls were used. A total of 28 ejaculates were collected in the pre-mating period (PMP), during it (DMP), and after it (AMP) using an electroejaculator. The sperm concentration was measured with the Accuread photometer. The motility was measured using a Spermtrack® counting chamber. The analyses were performed with the CASA-Mot ISAS®v1 system. The morphology was analyzed using a microscope with a negative phase contrast objective. Morphometry was evaluated with the CASA-Morph. The sperm concentration did not present differences between the PMP and AMP; however, it was significantly higher than DMP (p > 0.05). Regarding the progressiveness variables, linearity on forward progression (LIN), straightness (STR), and wobble (WOB) were higher (p < 0.05) DMP. A kinematic principal component analysis grouped all the variables into three factors and an effect on the reproductive period was found (p < 0.05) in the parameters of the head and middle part of the sperm, such as width and perimeter, which were greater in the PMP. The length of the sperm head in the PMP and DMP did not show differences; however, both were larger (p < 0.05) than AMP. The insertion distance of the middle piece of the sperm was significantly greater than DMP. Finally, the PMP contained cells with a larger insertion angle (p < 0.05) than AMP. These findings are important to understand the implications of reproductive status on sperm quality and to consider them in andrological evaluations.

Feline sperm head morphometry in relation to male pedigree and fertility

Computer-assisted sperm morphometry analysis is an advanced tool which allows to precise measure sperm head parameters like length, width, area, and perimeter. On the basis of these and calculated parameters, morphometric subpopulations of spermatozoa can be distinguished. In many species, the distribution of subpopulation within the ejaculate is related to male fertility. There is no information about such a relation for domestic cats; therefore, the aim of this study was to evaluate whether spermatozoa from non-pedigree and purebred domestic cats differ in morphometric parameters. The second aim was to check if there is a relationship between sperm morphometry and fertility. Urethral semen was collected from 27 tomcats, divided into three study groups: non-pedigree cats of unknown fertility, purebred infertile cats and purebred fertile cats. The morphometric assessment was performed by CASMA, followed by principal component analysis and clustering. The results revealed huge intra- and inter-individual variation in sperm head morphometric parameters and three sperm-head morphometric subpopulations were identified in feline semen. Neither mean values of morphometric parameters nor the distribution of spermatozoa between morphometric subpopulations differ between non-pedigree cats of unknown fertility and purebred infertile and fertile cats. We hypothesize that other factors, especially abnormalities of the midpiece and tail, and overall worse quality of the semen of infertile males could have masked the effect of subtle changes in the sperm head morphometry.

Morphometry of Boar Spermatozoa in Semen Stored at 17 °C—The Influence of the Staining Technique

Simple Summary

To obtain satisfactory results in artificial insemination, it is necessary to use high-quality ejaculates for the production of insemination doses and then maintain the biological value of the sperm during storage. Boar spermatozoa, owing to the specific structure of the cell membrane, are particularly sensitive to temperature changes. For this reason, cryopreservation cannot be used in artificial insemination practice, and there may be limitations to successful storage of semen in a liquid state. The practice of using boar semen for artificial insemination does not include analyses of the effect of storage time of boar semen on sperm dimensions. Therefore, the aim of the study was to analyse the morphometry of sperm during storage of liquid boar semen. An attempt was also made to evaluate the suitability of three staining methods for assessment of boar sperm morphometry. The morphometric dimensions of boar sperm were shown to change during storage of liquid semen. These changes affected the sperm head more than the tail and were due to the staining method used. The analyses are very important as they provide more information about the morphometric dimensions of the sperm during preservation of boar semen. The applied sperm staining techniques allows for a more accurate assessment of male reproductive cells.

Abstract

The aim of the study was to assess the morphometry of sperm during storage of liquid boar semen at 17 °C. An attempt was also made to evaluate the suitability of three staining methods for assessment of boar sperm morphometry. The study was carried out on 20 Landrace boars. Semen was collected from the boars every 5 days by the manual method. Four ejaculates from each boar were analysed (80 ejaculates in total). Analyses were performed five times: at 1 h, 24 h, 48 h, 96 h, and 168 h after semen collection. Blisters with insemination doses were opened immediately before the analyses. From each insemination dose, smears were prepared for morphometric evaluation of sperm, which were stained by three methods (eosin-nigrosin—EN, eosin-gentian—EG, and SpermBlue—SB). Morphometric measurements of 15 randomly selected sperm with normal morphology were performed on each slide. The morphometric measurements included the following parameters: sperm head length, width, area, and perimeter; tail length; and total sperm length. The results of the morphometric measurements were used to calculate the head shape index. The morphometric dimensions of the sperm were shown to change during storage of semen at 17 °C. The extent of these changes, however, depended on the staining method used, as the three methods result in different morphometric dimensions of sperm, in the case of both the head and the tail. In the slides stained by the eosin-nigrosin method, the dimensions of the head and tail were smaller at every time of storage than in the slides stained by the SpermBlue and eosin-gentian methods.