Sterilization Procedures for Titanium Alloy Surfaces Leads to Higher Expression of Biofilm-Related Staphylococcus aureus Genes

Evidence-based Approach for Prevention of Surgical Site Infection

Periprosthetic joint infection (PJI) is regarded as a critical factor contributing to the failure of primary and revision total joint arthroplasty (TJA). With the increasing prevalence of TJA, a significant increase in the incidence of PJI is expected. The escalating number of cases, along with the significant economic strain imposed on healthcare systems, place emphasis on the pressing need for development of effective strategies for prevention. PJI not only affects patient outcomes but also increases mortality rates, thus its prevention is a matter of vital importance. The longer-term survival rates for PJI after total hip and knee arthroplasty correspond with or are lower than those for prevalent cancers in older adults while exceeding those for other types of cancers. Because of the multifaceted nature of infection risk, a collaborative effort among healthcare professionals is essential to implementing diverse strategies for prevention. Rigorous validation of the efficacy of emerging novel preventive techniques will be required. The combined application of these strategies can minimize the risk of infection, thus their comprehensive adoption is important. Collectively, the risk of PJI could be substantially minimized by application of a multifaceted approach implementing these strategies, leading to improvement of patient outcomes and a reduced economic burden.

Nanostructured Ti-13Nb-13Zr alloy for implant application-material scientific, technological, and biological aspects

In dentistry, the most commonly used implant materials are CP-Titanium Grade 4 and Ti-6Al-4V ELI, possessing comparably high Young's modulus (>100 GPa). In the present study, the second-generation titanium alloy Ti-13Nb-13Zr is investigated with respect to the production of advanced dental implant systems. This should be achieved by the fabrication of long semi-finished bars with high strength and sufficient ductility to allow the automated production of small implants at low Young's modulus (<80 GPa) to minimize stress shielding, bone resorption, and gap formation between the bone and implant. In addition, bacterial colonization is to be reduced, and bone adhesion is to be enhanced by adjusting the microstructure. To do so, a dedicated thermo-mechanical treatment for Ti-13Nb-13Zr has been developed. This includes the adaption of equal channel angular swaging, a modern process of severe plastic deformation to continuously manufacture nanostructured materials, to Ti-13Nb-13Zr and short-time recrystallization and ageing treatments. In particular, two-pass equal channel angular swaging at a deformation temperature of 150°C and a counterpressure of 8 MPa has successfully been used to avoid shear band formation during deformation and to produce long Ti-13Nb-13Zr bars of 8 mm diameter. During recrystallization treatment at 700°C for 10 min followed by water quenching, a sub-micron-size primary α-phase in a matrix of α″-phase was developed. Subsequent ageing at 500°C for 1 h leads to martensite decomposition and, thus, to a homogeneously nanostructured microstructure of α- and β-phase with substructures smaller than 200 nm. The resulting mechanical properties, especially the ultimate tensile strength of more than 990 MPa, fulfill the requirements of ASTM F1713 at Young's modulus of 73 GPa. Biological investigations show promising results in reducing bacterial biofilm formation and increased cell proliferation of osteoblasts compared to CP-Titanium Grade 4 and Ti-6Al-4V ELI, especially, if etched surfaces are applied.