The First Stages of Chemical and Electrochemical Aniline Oxidation—Spectroscopic Comparative Study

Anion Storage Chemistry of Organic Cathodes for High-Energy and High-Power Density Divalent Metal Batteries

Multivalent batteries show promising prospects for next-generation sustainable energy storage applications. Herein, we report a polytriphenylamine (PTPAn) composite cathode capable of highly reversible storage of tetrakis(hexafluoroisopropyloxy) borate [B(hfip)4 ] anions in both Magnesium (Mg) and calcium (Ca) battery systems. Spectroscopic and computational studies reveal the redox reaction mechanism of the PTPAn cathode material. The Mg and Ca cells exhibit a cell voltage >3 V, a high-power density of ∼∼3000 W kg-1 and a high-energy density of ∼∼300 Wh kg-1 , respectively. Moreover, the combination of the PTPAn cathode with a calcium-tin (Ca-Sn) alloy anode could enable a long battery-life of 3000 cycles with a capacity retention of 60 %. The anion storage chemistry associated with dual-ion electrochemical concept demonstrates a new feasible pathway towards high-performance divalent ion batteries.

Electrochemical Soft Actuator: Deciphering the Difference in the Characteristics of Polaronic and Bipolaronic Forms of Polyaniline

Polyaniline (PANI) has been projected as an efficient electrochemical actuator due to its ease of synthesis, lightweight, biocompatibility, low cost, and possible low operating potential and high stress generation. However, challenges such as low inherent ionic and electronic conductivity of the polymer lead to small accumulation of ions and high ionic diffusion path length inside the polymer remain. In the present study, a highly conjugated, planar, conducting polaronic form of PANI with a nanofiber morphology is synthesized using in situ electrochemical polymerization on a reduced graphene oxide (rGO) electrode. The polymerization is carried out in the Schaefer mode at the air-water interface under controlled surface pressure in a Langmuir trough. Electrochemical, UV-visible, XPS, and Raman spectroscopic studies confirm the formation of the planar polaronic PANI form. Polymerization without surface pressure leads to the bipolaronic form of PANI. The two forms are subsequently used to understand their contributions toward electrochemical actuation in a bilayer configuration. The conducting polaronic PANI/EGO (exfoliated graphene oxide) exhibits a remarkably larger total angular displacement of 220° in aqueous 1 M NaClO₄ during a potential scan in the range ±0.9 V than the bipolaronic counterpart which exhibits a total angular displacement of 125°. Current imaging in the scanning electrochemical microscopy mode confirms a high volumetric expansion in the case of the polaronic form as compared to its bipolaronic counterpart. Raman spectroscopy reveals the oxidation to the emeraldine form in the polaronic PANI and to the pernigraniline form in the bipolaronic form during actuation. Electrochemical impedance spectroscopy study evidences the existence of a small charge transfer resistance with high bulk capacitance for the polaronic structure.

Polyaniline-Based Glyco-Condensation on Au Nanoparticles Enhances Immunotherapy in Lung Cancer

Lung cancer is considered among the deadliest cancers with a poor prognosis. Au@PG nanoparticles (NPs) are gold (Au)-based NPs featuring a polyaniline-based glyco structure (PG) generated from the polymerization of ortho-nitrophenyl-β-d-galactopyranoside (ONPG) with promising M1 macrophage polarization activity, resulting in tumor remodeling and from a cold to a hot microenvironment, which promotes the cytotoxic T cell response and tumor inhibition. The combination of Au@PG NPs and anti-programmed cell death protein 1 (PD-1) therapy improved tumor inhibition and immunosuppression, accompanied by the secretion of immunogenic cytokines. A one-pot synthetic method was developed to achieve glyco-condensation during the formation of Au@PG NPs, which induced macrophage polarization more efficiently than Au@glucose, Au@mannose, and Au@galactose NPs. The switch from M2 to M1 macrophages was dependent on NP size, with smaller Au@PG NPs performing better than larger ones, with effectiveness ranked as follows: 32.2 nm ≈ 29.8 nm < 26.4 nm < 18.3 nm. Cellular uptake by endocytosis induced size-dependent endoplasmic reticulum (ER) stress, which resulted in the activation of spleen tyrosine kinase (SYK), leading to immune modulations and macrophage polarization. Our results suggested the promising potential of Au@PG NPs in lung cancer immunotherapy.

Performance Improvement of Gold Electrode towards Methanol Electrooxidation in Akaline Medium: Enhanced Current Density Achieved with Poly(aniline-co-2-hydroxyaniline) Coating at Low Overpotential

Electronically conducting poly (aniline-co-2-hydroxyaniline) (PACHA), a copolymer of aniline and 2-hydroxyaniline (2HA), was electrochemically coated on gold substrate for methanol electrooxidation in alkaline media. The electrochemical behavior of PACHA coated gold electrode towards methanol electrooxidation was investigated via cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) for application in an alkaline fuel cell. Methanol electrooxidation was observed at two different electrode potentials depending on the concentration of the base. At the PACHA coated gold electrode, the methanol oxidation peak was observed at lower overpotential (at 0.19 V) in a solution of high base concentration (1.8 M NaOH), which was 30 mV lower than the peak for the uncoated gold electrode. In addition, the Faradic current Imax obtained on the PACHA coated electrode (20 mA) was two times higher as compared to the Faradic current Imax of the un-modified gold electrode (10 mA). In solution of lower base concentration (0.06 M NaOH), the electrooxidation of methanol became sluggish on both electrodes, as indicated by peak shifting towards positive potential and with reduced faradaic current (at 0.74 V on PACHA coated electrode; Imax 10 mA). The electrooxidation of methanol at both lower and higher electrode potentials was analyzed mechanistically and discussed in light of the literature. EIS results were interpreted using Nyquist and Bode plots. The charge transfer resistance was decreased and pseudo-capacitive behavior changed to conductive behavior when external applied potential was increased from 0.1 V to 0.4 V.

Enhanced Chemical and Electrochemical Stability of Polyaniline-Based Layer-by-Layer Films

Polyaniline (PANI) has been widely used as an electroactive material in various applications including sensors, electrochromic devices, solar cells, electroluminescence, and electrochemical energy storage, owing to PANI’s unique redox properties. However, the chemical and electrochemical stability of PANI-based materials is not sufficiently high to maintain the performance of devices under many practical applications. Herein, we report a route to enhancing the chemical and electrochemical stability of PANI through layer-by-layer (LbL) assembly. PANI was assembled with different types of polyelectrolytes, and a comparative study between three different PANI-based layer-by-layer (LbL) films is presented here. Polyacids of different acidity and molecular structure, i.e., poly(acrylic acid) (PAA), polystyrene sulfonate (PSS), and tannic acid (TA), were used. The effect of polyacids’ acidity on film growth, conductivity, and chemical and electrochemical stability of PANI was investigated. The results showed that the film growth of the LbL system depended on the acidic strength of the polyacids. All LbL films exhibited improved chemical and electrochemical stability compared to PANI films. The doping level of PANI was strongly affected by the type of dopants, resulting in different chemical and electrochemical properties; the strongest polyacid (PSS) can provide the highest conductivity and chemical stability of conductive PANI. However, the electrochemical stability of PANI/PAA was found to be better than all the other films.