Properties Analysis and Preparation of Biochar–Graphene Composites Under a One-Step Dip Coating Method in Water Treatment

Characterization of unconventional sand-based substrates for adsorption of micropollutants in nature-based systems

The focus of this study is the characterization of unconventional sand-based substrates used in our previous project EmiSûre, (Interreg Greater Region (German federal states Rhineland-Palatinate and Saarland, the Grand Duchy of Luxembourg, regions Wallonia and Lorraine from Belgium and France, respectively), 2017-2021). The project aimed to develop and test alternative, nature-based technologies for the elimination of micropollutants (MPs) from municipal wastewater. For the characterization, two approaches were chosen. In the first approach, adsorption kinetics with a single compound allowed a perception of the adsorption capacity of the studied substrates compared to conventional substrates (granular activated carbons). This knowledge was completed by the second approach: an implementation of the studied substrates in packed-bed columns, which treated a mixture of 27 MPs in tap water for 10 months. Additionally, all three substrates (bentonite sand, sand with 15% activated biochar and sand with 15% zeolite) were characterized for physical and chemical properties, and the microbial potential of the activated and non-activated biochar was examined. From the studies, it is clear that the sand with an admixture of activated biochar is the most efficient sorbent in terms of single compound adsorption in batch (dye) and adsorption of 27 MPs on packed-bed columns. In contrast to the two other substrates, it shows long-term stable removal efficiencies. In the packed-bed columns, 18 out of 27 compounds were removed on average with high efficiency (80-99%), which is impressive, if we consider the variety of the compounds examined (pharmaceuticals, herbicides, pesticides, etc.) and their removal in conventional treatments. Additionally, adsorption models were created for the experimental data of all compounds adsorbed on the substrate with an admixture of activated biochar resulting in the best fit with the combined Langmuir-Freundlich model. These satisfying results suggest the application of the sand-based substrate with an admixture of activated biochar for further research and possibly upscale installations with the aim to offer and prove a reasonable and efficient alternative for MPs elimination from municipal wastewater.

Vitamin C-Assisted Fabrication of Aerogels from Industrial Graphene Oxide for Gaseous Hexamethyldisiloxane Adsorption

Volatile methyl siloxanes (VMSs) as a trace impurity in biogas decreases its energy utilization, and thus need to be removed. In this paper, a one-step hydrothermal reduction was performed to produce three-dimensional reduced graphene oxide aerogels (rGOAs) using industrial-grade graphene oxide (IGGO) as raw material and vitamin C (VC) as a reductant to facilitate the fabrication of rGOAs. The synthesis of rGOAs was a simple, green, and energy-efficient process. The developed rGOAs were characterized using the Brunauer–Emmett–Teller method, Raman spectrometry, scanning electron microscopy, Fourier-transform infrared spectroscopy, X-ray diffraction measurements and contact angle. The results obtained showed that rGOA-1 with a VC/IGGO ratio of 1/1 (m/m) exhibited a hierarchical porous structure and super-hydrophobicity, yielding a high specific surface area (137.9 m2 g−1) and superior water contact angle (143.8°). The breakthrough adsorption capacity of rGOA-1 for hexamethyldisiloxane (L2, a VMS model) was 11 times higher than that of IGGO. Low inlet concentration and bed temperature were considered beneficial for the L2 adsorption. Interestingly, rGOA-1 was less sensitive to water, and it was readily regenerated for reuse by annealing at 80 °C. The rGOAs have been demonstrated to have great potential for the removal of siloxanes from biogas.