Silica Microsphere WGMR-Based Kerr-OFC Light Source and Its Application for High-Speed IM/DD Short-Reach Optical Interconnects

Silica micro-rod resonator-based Kerr frequency comb for high-speed short-reach optical interconnects

Conventional data center interconnects rely on power-hungry arrays of discrete wavelength laser sources. However, growing bandwidth demand severely challenges ensuring the power and spectral efficiency toward which data center interconnects tend to strive. Kerr frequency combs based on silica microresonators can replace multiple laser arrays, easing the pressure on data center interconnect infrastructure. Therefore, we experimentally demonstrate a bit rate of up to 100 Gbps/λ employing 4-level pulse amplitude modulated signal transmission over a 2 km long short-reach optical interconnect that can be considered a record using any Kerr frequency comb light source, specifically based on a silica micro-rod. In addition, data transmission using the non-return to zero on-off keying modulation format is demonstrated to achieve 60 Gbps/λ. The silica micro-rod resonator-based Kerr frequency comb light source generates an optical frequency comb in the optical C-band with 90 GHz spacing between optical carriers. Data transmission is supported by frequency domain pre-equalization techniques to compensate amplitude-frequency distortions and limited bandwidths of electrical system components. Additionally, achievable results are enhanced with offline digital signal processing, implementing post-equalization using feed-forward and feedback taps.

Thermo-Optical Sensitivity of Whispering Gallery Modes in As2S3 Chalcogenide Glass Microresonators

Glass microresonators with whispering gallery modes (WGMs) have a lot of diversified applications, including applications for sensing based on thermo-optical effects. Chalcogenide glass microresonators have a noticeably higher temperature sensitivity compared to silica ones, but only a few works have been devoted to the study of their thermo-optical properties. We present experimental and theoretical studies of thermo-optical effects in microspheres made of an As₂S₃ chalcogenide glass fiber. We investigated the steady-state and transient temperature distributions caused by heating due to the partial thermalization of the pump power and found the corresponding wavelength shifts of the WGMs. The experimental measurements of the thermal response time, thermo-optical shifts of the WGMs, and heat power sensitivity in microspheres with diameters of 80-380 µm are in a good agreement with the theoretically predicted dependences. The calculated temperature sensitivity of 42 pm/K does not depend on diameter for microspheres made of commercially available chalcogenide fiber, which may play an important role in the development of temperature sensors.