Removal of Crotamiton from Reverse Osmosis Concentrate by a TiO2/Zeolite Composite Sheet

3D printed cylindrical capsules as a Chlorella pyrenoidosa immobilization device for removal of lead ions contamination

Immobilization is considered as a promising strategy toward the practical applications of powdered adsorbent. Herein, three dimensional (3D) printing cylindrical capsules with cross-linked PVA hydrogels membrane in encapsulate Chlorella pyrenoidosa (Cp) were utilized for removal of lead ions. The chemical compositions, hydrogels performance and morphologies of the membranes were determined by Fourier transformed infrared spectroscopy (FTIR), cross-linking degree, swelling degree, membrane flux and scanning electron microscopy (SEM). It is found that PVA cross-linking structure is successfully synthesized on the surface of capsule body and cap due to the presence of PVA in the filament. The lead ions adsorption capacity related to initial concentration of 50 mg/L in 48 h is reached 75.61%, revealing a good removal ability. The self-floating 3D printed capsules device also shows an excellent recovering property. After 7 runs of adsorption experiment, the lead ions adsorption ratio remains 78.56%, which will bring a broad prospect in wastewater treatment, chemical slow release along with sample preparation and separation.

Acetaldehyde gas removal by a nylon film-TiO2 composite sheet prepared on a paper surface using interfacial polymerization and electrostatic interactions

In this study, preparation of a nylon film-TiO₂ composite sheet with both physical durability under UV irradiation and TiO₂ photocatalysis functionality was investigated. First, a nylon film was directly prepared on paper by interfacial polymerization using ethylenediamine and terephthaloyl chloride in a cyclohexane-chloroform mixture (3:1, v/v). Next, the nylon-coated paper was treated with tetraethyl orthosilicate and 3-aminopropyltrimethoxysilane to prepare polysiloxane on its surface. This was followed by fixation of TiO₂ powder via electrostatic interactions with the polysiloxane. Although nylon films on paper usually decompose under TiO₂ photocatalysis, the nylon film-TiO₂ composite sheets prepared using 0.5%-1.0% (w/v) TiO₂ did not decompose under photocatalysis. The residual rate of strength of the sheet remained at almost 100% after 240 h, which could be attributed to protection of the sheet by the polysiloxane layer. The nylon film was fibrous and could effectively adsorb acetaldehyde gas. All of the nylon film-TiO₂ composite sheets prepared using 0.5%-5.0% TiO₂ photocatalytically removed acetaldehyde under UV irradiation and no acetaldehyde gas was detected after 240-300 min. These results show the nylon film-TiO₂ composite sheet can effectively remove acetaldehyde gas by photocatalysis and adsorption and could be applied to removal of volatile organic compounds in indoor air.