Interactions of Amino Group Functionalized Tetraphenylvinyl and DNA: A Label-Free "On-Off-On" Fluorescent Aptamer Sensor toward Ampicillin

Development of a highly sensitive ampicillin sensor utilizing functionalized aptamers

To develop a sensitive and simple ampicillin (AMP) sensor for trace antibiotic residue detection, the influencing factors of the modification effect of nanogold-functionalized nucleic acid sequences (Adenine: A, Thymine: T) were comprehensively analyzed in this study, including the modification method, base length and type. It was found that under the same base concentration, longer chains are more likely to reach saturation than shorter chains; and when the base concentration and length are both the same, A exhibits a higher saturation modification level compared to T. Based on these research findings, a highly sensitive fluorescence aptamer sensor for detecting ampicillin was constructed using the optimized functionalized sequence (ployA6-aptamer) and experimental conditions (6 hours binding time between nucleic acid aptamer and complementary strand, pH 7 working solution, 20 minutes detection time) based on the principle of fluorescence resonance energy transfer. The sensor has a detection range of 0.18 ng ml-1 to 3.11 ng ml-1 for ampicillin, with a detection limit of 0.04 ng ml-1. It exhibits significant selectivity and achieves an average recovery rate of 98.71% in tap water and 91.83% in milk. This method can be used not only for residual ampicillin detection, but also for highly sensitive detection of various antibiotics and small biological molecules by replacing the aptamer type. It provides a research basis for the design of highly sensitive fluorescence aptamer sensors and further applications of nanogold@DNA composite structures.

Fluorescent aptasensor mediated with multiple ssDNA for sensitive detection of acetamiprid in vegetables based on magnetic Fe3O4/C-assisted separation

Acetamiprid (ACE) is a highly effective broad-spectrum insecticide, and its widespread use is potentially harmful to human health and environmental safety. In this study, magnetic Fe3O4/carbon (Fe3O4/C), a derivative of metal-organic framework MIL-101 (Fe), was synthesized by a two-step calcination method. And a fluorescent sensing strategy was developed for the efficient and sensitive detection of ACE using Fe3O4/C and multiple complementary single-stranded DNA (ssDNA). By using aptamer with multiple complementary ssDNA, the immunity of interference of the aptasensor was improved, and the aptasensor showed high selectivity and sensitivity. When ACE was present, the aptamer (Apt) combined with ACE. The complementary strand of Apt (Cs1) combined with two short complementary strands of Cs1, fluorophore 6-carboxyfluorescein-labeled complementary strand (Cs2-FAM) and the other strand Cs3. The three strands formed a double-stranded structure, and fluorescence would not be quenched by Fe3O4/C. In the absence of ACE, Cs2-FAM would be in a single-chain state and would be adsorbed by Fe3O4/C, and the fluorescence of FAM would be quenched by Fe3O4/C via photoelectron transfer. This aptasensor sensitively detected ACE over a linear concentration range of 10-1000 nM with a limit of detection of 3.41 nM. The recoveries of ACE spiked in cabbage and celery samples ranged from 89.49% to 110.76% with high accuracy.

Construction of Aggregation-Induced Emission Molecule-MnO2 Composite Nanoprobe and Its Application in Alkaline Phosphatase Detection

Alkaline phosphatase (ALP) is among the most studied enzymes by far, playing an important role in the metabolism of organisms and the regulation of protein activity. Herein, a label-free composite nanoprobe is constructed by combining inorganic nanomaterials and aggregation-induced emission (AIE) molecule to achieve highly sensitive and selective detection of ALP. Negatively charged 9,10-bis [2-(6-sulfonatopropoxyl) naphthylethenyl] anthracene (BSNVA) molecule is synthesized, which has the AIE performance and can be assembled on the surface of amino-SiO₂ nanoparticles through electrostatic interaction for fluorescence enhancement. MnO₂ nanosheets are rich in negative charges, enabling them to be wrapped on the surface of the amino-SiO₂ nanosphere to shield the positive charge on its surface, making it impossible for BSNVA to accumulate on the surface and then weakening the bio-fluorescence of the system. Furthermore, with catalyzed substrates induced by ALP, generating ascorbic acid and the redox reaction between ascorbic acid and MnO₂, the nanoprobe helps in realizing the high-sensitivity detection of ALP with a detection limit of 0.38 mU/mL. The proposed strategy requires no complex cleaning and modification processes and can overcome the quenching effect caused by the aggregation of traditional organic dyes, proving to be a simple, low-cost and "turn-on" fluorescent detection method for ALP.