Comprehensive Kinetics of the Photocatalytic Degradation of Emerging Pollutants in a LED-Assisted Photoreactor. S-Metolachlor as Case Study

Techno-economic evaluation of UV light technologies in water remediation

Disinfection commonly follows conventional treatments in wastewater treatment and remediation plants aiming at reducing the presence of pathogens. However, the presence of the so called "micropollutants" has emerged as a serious concern, therefore developing tertiary treatments that are not only able to remove pathogens but also to degrade micropollutants is worth investigating. Nowadays, UV-C photo-degradation processes are widely used for disinfection due to their simplicity and easy operation; additionally, they have shown potential for the removal of contaminants of emerging concern. Conventional mercury lamps are being replaced by light-emitting diodes (LEDs) that avoid the use of toxic mercury and can be switched on and off with no effect on the lamp lifetime. This work aims to comparatively evaluate the performance of several photo-degradation technologies for the removal of two targeted micropollutants, the pharmaceutical dexamethasone (DXMT) and the herbicide S-metolachlor (MTLC), using UV irradiation doses typical of disinfection processes. To this end, the technical performance of UV-A/UV-C photolysis, UV-A/UV-C photocatalysis, UV-C/H₂O₂ and UV-C/NaOCl has been compared. The influence of operating conditions such as the initial concentration of the pollutants (3 mg L^-1 - 30 mg L^-1, concentrations found in membrane or adsorption remediation steps), pH (3-10), and water matrix (WWTP secondary effluent, and ultrapure water) on the degradation efficiency has been studied. The economic evaluation in terms of electricity and chemicals consumption and the carbon footprint has been evaluated. UV-C photolysis and UV-C photocatalysis appear as the most suitable technologies for the degradation of DXMT and MTLC, respectively, in terms of kinetics (1.53·10^-1 min^-1 for DXMT and 1.96·10^-2 min^-1 for MTLC), economic evaluation (1 € m^-3 for DXMT and 32 € m^-3 for MTLC) and environmental indicators (0.5 g-CO₂ for DXMT and 223.1 g-CO₂ for MTLC).

Removal of Chloroacetanilide Herbicides from Water Using Heterogeneous Photocatalysis with TiO2/UV-A

Chloroacetanilide herbicides are widely used in the agricultural sector throughout the world. Because of their poor biodegradability, high water solubility, and long persistence, chloroacetanilide herbicides have a high potential to contaminate water, and conventional water treatment processes do not ensure sufficient removal. Therefore, heterogeneous photocatalysis using TiO2/UV-A was investigated for the degradation of alachlor, acetochlor, and metolachlor from water. Two commercially available TiO2 (P25 and AV-01) were used as photocatalysts. Different experimental setups were also tested. In addition, the toxicity of single herbicides and mixtures of their photocatalytic degradation products to the freshwater alga Chlorella kessleri was investigated via a growth inhibition test. The maximum removal efficiency for alachlor, acetochlor, and metolachlor was 97.5%, 93.1%, and 98.2%, respectively. No significant differences in the removal efficiency of chloroacetanilide herbicides were observed for the photocatalysts used. Although the concentrations of all herbicides during photocatalysis decreased, the toxicity of the resulting mixtures of degradation products increased or remained the same, indicating the formation of toxic degradation products.

Special Issue on “Green Catalysts: Application to Waste and Groundwater Treatment”

Water and soil pollution are among the most critical global problems due to population growth, industrial development, and associated resource consumption [...]