Recent Advances of Photocatalytic Hydrogenation of CO2 to Methanol

A Review of the Effect of Defect Modulation on the Photocatalytic Reduction Performance of Carbon Dioxide

Constructive defect engineering has emerged as a prominent method for enhancing the performance of photocatalysts. The mechanisms of the influence of defect types, concentrations, and distributions on the efficiency, selectivity, and stability of CO2 reduction were revealed for this paper by analyzing the effects of different types of defects (e.g., metallic defects, non-metallic defects, and composite defects) on the performance of photocatalysts. There are three fundamental steps in defect engineering techniques to promote photocatalysis, namely, light absorption, charge transfer and separation, and surface-catalyzed reactions. Defect engineering has demonstrated significant potential in recent studies, particularly in enhancing the light-harvesting, charge separation, and adsorption properties of semiconductor photocatalysts for reducing processes like carbon dioxide reduction. Furthermore, this paper discusses the optimization method used in defect modulation strategy to offer theoretical guidance and an experimental foundation for designing and preparing efficient and stable photocatalysts.

Carbon Dioxide Pressure and Catalyst Quantity Dependencies in Artificial Photosynthesis of Hydrocarbon Chains on Nanostructured Co/CoO Surfaces

In this study, we investigated the influence of pressure and the quantity of Co/CoO catalyst on an artificial photosynthesis process that converts CO2 and H2O into hydrocarbons (CnH2n+2, where n ≤ 18). The adsorption of CO2 and H2O on Co/CoO surfaces proved to be pivotal in this photo-catalytic reaction. Photoexcited carbon dioxide and water molecules ((CO2)* and (H2O)*) generated by illuminating the catalyst surface led to the formation of alkene hydrocarbon molecules with carbon numbers following an approximate Poisson distribution. The optimal pressure was found to be 0.40 MPa. Pressure less than 0.40 MPa resulted in low CO2 adsorption, impeding excitation for photosynthesis. At greater pressure, oil/wax accumulation on Co/CoO surfaces hindered CO2 adsorption, limiting further photosynthesis reactions. The average number of carbon atoms in the hydrocarbons and hydrocarbon yield were correlated. The amount of Co/CoO was also found to affect the hydrocarbon yield. Our study contributes to the understanding of Co/CoO-catalyzed photosynthesis and suggests that an open-flow system could potentially enhance the productivity of long-chain hydrocarbons.

Construction of Z-scheme Bi2O3/CeO2 heterojunction for enhanced photocatalytic capacity of TiO2 NTs

Photocatalytic technology was recognized to be the effective strategy to overcome the obstacles of environment pollution and energy shortage, and the novel photocatalyst design/construction was the key point for photocatalytic performance improvement. In this paper, the Z-scheme Bi2O3 and CeO2 heterojunction was constructed on TiO2 nanotube arrays (TiO2 NTs) by the hydrothermal deposition method. The Bi2O3-CeO2 cosensitization not only extended the solar absorption region but also accelerated the photoelectron separation and transfer, finally enhanced the photocatalytic property. The photocatalysts exhibited the high RhB/MB photodegradation and Cr(VI) reduction, and the photoelectric conversion and photocatalytic H2 evolution were also preeminent. The Z-scheme heterojunction construction was recognized to be the reason for the high photoactivity, and O2- and OH radicals were formed and investigated as the main active species for the dye photodegradation. The work gives the simple method and idea to construct novel ternary Z-scheme heterojunctions with high photocatalytic capacity for environment remediation and new energy development.

Insight of the State for Deliberately Introduced A-Site Defect in Nanofibrous LaFeO3 for Boosting Artificial Photosynthesis of CH3OH

Perovskite-type LaFeO3 is regarded as a potentially efficient visible-light photocatalyst owing to its narrow bandgap energy and unique photovoltaic properties. However, the insufficient active sites and the unsatisfactory utilization of photogenerated carriers severely restrict the realistic application of pure LaFeO3. Herein, we fabricated a series of LaxFeO3-δ nanofibers (x = 1.0, 0.95, 0.9, 0.85, 0.8) with an A-site defect via sol-gel combined with the electrospinning technique. Wherein, the nonstoichiometric La0.9FeO3-δ possessed the highest CH3OH yield of 5.30 μmol·g-1·h-1 with good chemical stability. A series of advanced characterizations were applied to investigate the physicochemical properties and charge-carrier behaviors of the samples. The results illustrated that the one-dimensional (1D) nanostructures combined with the appropriate concentration of vacancy defects on the surface contributed to the radial migration of photogenerated carriers, inhibited the recombination of carriers, and provided more CO2 adsorption-activation sites. Furthermore, density functional theory (DFT) calculations were employed to reveal the influence mechanism of vacancy defects on LaFeO3. This work provides a strategy to enhance the performance of photocatalytic CO2 reduction by modulating the induced oxygen vacancies caused by the A-site defect in perovskite oxides.

Photocatalytic Reduction of Carbon Dioxide to Methanol: Carbonaceous Materials, Kinetics, Industrial Feasibility, and Future Directions

Photocatalytic carbon dioxide reduction (PCCR) for methanol synthesis (CH₃OH) targeting renewable energy resources is an attractive way to create a sustainable environment and also balance the carbon-neutral series. The application of PCCR to methanol enables the generation of solar energy while reducing CO₂, killing two birds with one stone in terms of energy and the environment. In recent years, research on CO₂ utilization has focused on hydrogenation of CO₂ to methanol due to global warming. This article mainly focuses on selective carbonaceous materials such as graphene, mesoporous carbon, and carbon nanotubes (CNTs) as catalysts for heterogeneous photocatalytic CO₂ reduction to methanol. In addition, special emphasis will be placed on the state of the art of PCCR catalysts as this type of research will be of great benefit for further development in this field. The main features of the reaction kinetics, techno-economic study, and current technological developments in PCCR are covered in detail.

Advances in the Application of Bi-Based Compounds in Photocatalytic Reduction of CO2

Bi-based semiconductor materials have special layered structure and appropriate band gap, which endow them with excellent visible light response ability and stable photochemical characteristics. As a new type of environment-friendly photocatalyst, they have received extensive attention in the fields of environmental remediation and energy crisis resolution and have become a research hotspot in recent years. However, there are still some urgent issues that need to be addressed in the practical large-scale application of Bi-based photocatalysts, such as the high recombination rate of photogenerated carriers, limited response range to visible spectra, poor photocatalytic activity, and weak reduction ability. In this paper, the reaction conditions and mechanism of photocatalytic reduction of CO₂ and the typical characteristics of Bi-based semiconductor materials are introduced. On this basis, the research progress and application results of Bi-based photocatalysts in the field of reducing CO₂, including vacancy introduction, morphological control, heterojunction construction, and co-catalyst loading, are emphasized. Finally, the future prospects of Bi-based photocatalysts are prospected, and it is pointed out that future research directions should be focused on improving the selectivity and stability of catalysts, deeply exploring reaction mechanisms, and meeting industrial production requirements.

The Progress of Metal-Organic Framework for Boosting CO2 Conversion

With the rapid development of modern society, environmental problems, including excessive amounts of CO2 released in the atmosphere, are becoming more and more serious. It is necessary to develop new materials and technologies to reduce pollution. Among them, metal–organic frameworks (MOFs) have shown potential for application in the area of catalysis due to their ultra-high specific surface area, structural versatility, and designability as well as ease of modification and post-synthesis. Herein, we summarize recent research advances by use of MOFs for boosting CO2 conversion. Furthermore, challenges and possible research directions related to further exploration are also discussed.

Developing Benign Ni/g-C3N4 Catalysts for CO2 Hydrogenation: Activity and Toxicity Study

This research discusses the CO₂ valorization via hydrogenation over the non-noble metal clusters of Ni and Cu supported on graphitic carbon nitride (g-C₃N₄). The Ni and Cu catalysts were characterized by conventional techniques including XRD, AFM, ATR, Raman imaging, and TPR and were tested via the hydrogenation of CO₂ at 1 bar. The transition-metal-based catalyst designed with atom-economy principles presents stable activity and good conversions for the studied processes. At 1 bar, the rise in operating temperature during CO₂ hydrogenation increases the CO₂ conversion and the selectivity for CO and decreases the selectivity for methanol on Cu/CN catalysts. For the Ni/CN catalyst, the selectivity to light hydrocarbons, such as CH₄, also increased with rising temperature. At 623 K, the conversion attained ca. 20%, with CH₄ being the primary product of the reaction (CH₄ yield >80%). Above 700 K, the Ni/CN activity increases, reaching almost equilibrium values, although the Ni loading in Ni/CN is lower by more than 90% compared to the reference NiREF catalyst. The presented data offer a better understanding of the effect of the transition metals’ small metal cluster and their coordination and stabilization within g-C₃N₄, contributing to the rational hybrid catalyst design with a less-toxic impact on the environment and health. Bare g-C₃N₄ is shown as a good support candidate for atom-economy-designed catalysts for hydrogenation application. In addition, cytotoxicity to the keratinocyte human HaCaT cell line revealed that low concentrations of catalysts particles (to 6.25 μg mL^–1) did not cause degenerative changes.

Cu/Zn/Zr/Ga Catalyst for Utilisation of Carbon Dioxide to Methanol—Kinetic Equations

This paper presents the kinetics of methanol synthesis from carbon dioxide and hydrogen over a Cu/Zn/Zr/Ga catalyst. Kinetic studies were carried out in a continuous-flow fixed-bed reactor in a temperature range from 433 to 513 K, pressures from 3 to 8 MPa, and GHSV from 1660 to 10,000 1/h for initial molar fractions of hydrogen from about 0.48 to 0.70, carbon dioxide from 0.05 to about 0.22, and carbon monoxide from 0 to about 0.07. Significant effects of temperature and the composition of the reaction mixture on the conversion degrees α1 and α2 were found. The Cu/Zn/Zr/Ga catalyst showed good stability over 960 h. XRD and CO2TPD characterisation were performed. Thefinally obtained results of kinetic tests were developed in the form of Langmuir–Hinshelwood kinetic equations. The numerical Levenberg–Marquardt method was used to estimate the kinetic equations. The average relative error of fitting the kinetic equations to the experimental data was 18%.

Activation of Small Molecules and Hydrogenation of CO2 Catalyzed by Frustrated Lewis Pairs

The chemistry of frustrated Lewis pair (FLP) is widely explored in the activation of small molecules, the hydrogenation of CO2, and unsaturated organic species. A survey of several experimental works on the activation of small molecules by FLPs and the related mechanistic insights into their reactivity from electronic structure theory calculation are provided in the present review, along with the catalytic hydrogenation of CO2. The mechanistic insight into H2 activation is thoroughly discussed, which may provide a guideline to design more efficient FLP for H2 activation. FLPs can activate other small molecules like, CO, NO, CO2, SO2, N2O, alkenes, alkynes, etc. by cooperative action of the Lewis centers of FLPs, as revealed by several computational analyses. The activation barrier of H2 and other small molecules by the FLP can be decreased by utilizing the aromaticity criterion in the FLP as demonstrated by the nucleus independent chemical shift (NICS) analysis. The term boron-ligand cooperation (BLC), which is analogous to the metal-ligand cooperation (MLC), is invoked to describe a distinct class of reactivity of some specific FLPs towards H2 activation.