Application of Bioelectrochemical System and Magnetite Nanoparticles on the Anaerobic Digestion of Sewage Sludge: Effect of Electrode Configuration

Integrated dark-fermentation-microbial electrosynthesis for efficient wastewater treatment and bioenergy recovery

High ammonia concentration in wastewater can hinder methane production rate in anaerobic digestion (AD)-microbial electrosynthesis systems (ADMES). To address this issue, a dual-chamber reactor was fabricated using an anion exchange membrane (AEM) to separate the dark-fermentation (DF) and ADMES process, preventing ammonia migration from the DF chamber to the ADMES chamber. As a result, the DF-ADMES achieved a high methane yield based on chemical oxygen demand (COD) of 0.35 L CH4/gCOD compared to control operation AD (0.23 L CH4/gCOD) and ADMES (0.30 L CH4/gCOD). Additionally, hydrogen could be recovered from the DF chamber which improved the energy efficiency of the DF-ADMES reactor (91.7 %) as compared to control AD (53.4 %) and ADMES (71.9 %). Thus, a dual-chamber DF-ADMES with an AEM separator could be a feasible design for scalable treatment of high nitrogen-containing wastewater and high bioenergy recovery.

Effect of Electrode Spacing on the Performance of a Membrane-Less Microbial Fuel Cell with Magnetite as an Additive

A microbial fuel cell (MFC) is a bioelectrochemical system that can be employed for the generation of electrical energy under microbial activity during wastewater treatment practices. The optimization of electrode spacing is perhaps key to enhancing the performance of an MFC. In this study, electrode spacing was evaluated to determine its effect on the performance of MFCs. The experimental work was conducted utilizing batch digesters with electrode spacings of 2.0 cm, 4.0 cm, 6.0 cm, and 8.0 cm. The results demonstrate that the performance of the MFC improved when the electrode spacing increased from 2.0 to 6.0 cm. However, the efficiency decreased after 6.0 cm. The digester with an electrode spacing of 6.0 cm enhanced the efficiency of the MFC, which led to smaller internal resistance and greater biogas production of 662.4 mL/g VS_fed. The electrochemical efficiency analysis demonstrated higher coulombic efficiency (68.7%) and electrical conductivity (177.9 µS/cm) for the 6.0 cm, which was evident from the enrichment of electrochemically active microorganisms. With regards to toxic contaminant removal, the same digester also performed well, revealing removals of over 83% for chemical oxygen demand (COD), total solids (TS), total suspended solids (TSS), and volatile solids (VS). Therefore, these results indicate that electrode spacing is a factor affecting the performance of an MFC, with an electrode spacing of 6.0 cm revealing the greatest potential to maximize biogas generation and the degradability of wastewater biochemical matter.

Application of Magnetite-Nanoparticles and Microbial Fuel Cell on Anaerobic Digestion: Influence of External Resistance

In this paper, the application of magnetite-nanoparticles and a microbial fuel cell (MFC) was studied on the anaerobic digestion (AD) of sewage sludge. The experimental set-up included six 1 L biochemical methane potential (BMP) tests with different external resistors: (a) 100 Ω, (b) 300 Ω, (c) 500 Ω, (d) 800 Ω, (e) 1000 Ω, and (f) a control with no external resistor. The BMP tests were carried out using digesters with a working volume of 0.8 L fed with 0.5 L substrate, 0.3 L inoculum, and 0.53 g magnetite-nanoparticles. The results suggested that the ultimate biogas generation reached 692.7 mL/g VSfed in the 500 Ω digester, which was substantially greater than the 102.6 mL/g VSfed of the control. The electrochemical efficiency analysis also demonstrated higher coulombic efficiency (81.2%) and maximum power density (30.17 mW/ m2) for the 500 Ω digester. The digester also revealed a higher maximum voltage generation of 0.431 V, which was approximately 12.7 times the 0.034 V of the lowest-performing MFC (100 Ω digester). In terms of contaminants removed, the best-performing digester was the digester with 500 Ω, which reduced contaminants by more than 89% on COD, TS, VS, TSS and color. In terms of cost-benefit analysis, this digester produced the highest annual energy profit (48.22 ZAR/kWh or 3.45 USD/kWh). This infers the application of magnetite-nanoparticles and MFC on the AD of sewage sludge is very promising for biogas production. The digester with an external resistor of 500 Ω showed a high potential for use in bioelectrochemical biogas generation and contaminant removal for sewage sludge.

Application of Bioelectrochemical Systems and Anaerobic Additives in Wastewater Treatment: A Conceptual Review

The interspecies electron transfer (IET) between microbes and archaea is the key to how the anaerobic digestion process performs. However, renewable energy technology that utilizes the application of a bioelectrochemical system together with anaerobic additives such as magnetite-nanoparticles can promote both direct interspecies electron transfer (DIET) as well as indirect interspecies electron transfer (IIET). This has several advantages, including higher removal of toxic pollutants present in municipal wastewater, higher biomass to renewable energy conversion, and greater electrochemical efficiencies. This review explores the synergistic influence of bioelectrochemical systems and anaerobic additives on the anaerobic digestion of complex substrates such as sewage sludge. The review discussions present the mechanisms and limitations of the conventional anaerobic digestion process. In addition, the applicability of additives in syntrophic, metabolic, catalytic, enzymatic, and cation exchange activities of the anaerobic digestion process are highlighted. The synergistic effect of bio-additives and operational factors of the bioelectrochemical system is explored. It is elucidated that a bioelectrochemical system coupled with nanomaterial additives can increase biogas-methane potential compared to anaerobic digestion. Therefore, the prospects of a bioelectrochemical system for wastewater require research attention.

Utilization of Response Surface Methodology in Optimization and Modelling of a Microbial Electrolysis Cell for Wastewater Treatment Using Box–Behnken Design Method

A vast quantity of untreated wastewater is discharged into the environment, resulting in contamination of receiving waters. A microbial electrolysis cell (MEC) is a promising bioelectrochemical system (BES) for wastewater treatment and energy production. However, poor design and control of MEC variables may lead to inhibition in the system. This study explored the utilization of Response Surface Methodology (RSM) on the synergistic aspects of MEC and magnetite nanoparticles for wastewater treatment. Influences of temperature (25–35 °C), voltage supply (0.3–1.3 V) and magnetite nanoparticle dosage (0.1–1.0 g) on the biochemical methane potentials (BMPs) were investigated with the aim of optimizing biogas yield, chemical oxygen demand removal and current density. The analysis of variance (ANOVA) technique verified that the quadratic models obtained were substantial, with p-values below 0.05 and high regression coefficients (R2). The optimum biogas yield of 563.02 mL/g VSfed, chemical oxygen demand (COD) removal of 97.52%, and current density of 26.05 mA/m2 were obtained at 32.2 °C, 0.77 V and 0.53 g. The RSM revealed a good comparison between the predicted and actual responses. This study revealed the effective utilization of statistical modeling and optimization to improve the performance of the MEC to achieve a sustainable and eco-friendly situation.