Laccase-Catalyzed Reduction of Oxygen at Electrodes Modified by Carbon Nanotubes with Adsorbed Promazine or Acetosyringone

Optimizing Covalent Immobilization of Glucose Oxidase and Laccase on PV15 Fluoropolymer-Based Bioelectrodes

Enzymatic biofuel cells (EBCs) represent a promising technology for biosensors, biodevices, and sustainable green energy applications, thanks to enzymes' high specificity and catalytic efficiency. Nevertheless, drawbacks such as limited output power and short lifetime have to be solved. Nowadays, research is addressed to the use of 3D electrode structures, but the high cost and the industrialization difficulties of such electrodes represent a key issue. The purpose of the paper is thus to describe the use of a low-cost commercial conductive polymer (Sigracell^® PV15) as support for the covalent immobilization of glucose oxidase and laccase, for bioanode and biocathode fabrication, respectively. Efficient immobilization protocols were determined for the immobilized enzymes in terms of employed linkers and enzyme concentrations, resulting in significant enzymatic activities for units of area. The analysis focuses specifically on the optimization of the challenging immobilization of laccase and assessing its stability over time. In particular, an optimum activity of 23 mU/cm² was found by immobilizing 0.18 mg/cm² of laccase, allowing better performances, as for voltage output and electrochemical stability, and a direct electron transfer mechanism to be revealed for the fabricated biocathode. This study thus poses the basis for the viable development of low-cost functional EBC devices for biomedical applications.

Immobilizing Enzymes on a Commercial Polymer: Performance Analysis of a GOx-Laccase Based Enzymatic Biofuel Cell Assembly

Enzymatic Biofuel Cell (EBC) represents a promising green source since it is capable of harvesting electricity from renewable and abundantly available biofuels using enzymes as catalysts. Nevertheless, nowadays long-term stability and low power output are currently the main concerns. To this end, several research studies focus on using complex tridimensional and highly expensive nanostructures as electrode support for enzymes. This increases cell performance whilst drastically reducing the economic feasibility needed for industrial viability. Thus, this paper analyzes a novel flow-based EBC consisting of covalent immobilized GOx (bioanode) and Laccase (biocathode) on a commercial flat conductive polymer. A suitable immobilization technique based on covalent ligands is carried out to enhance EBC durability. The experimental characterization demonstrates that the cell generates power over three weeks, reaching 590 mV and 2.41 µW cm−2 as maximum open circuit voltage and power density, respectively. The most significant contributions of this configuration are definitely ease of implementation, low cost, high scalability, and reproducibility. Therefore, such a design can be considered a step forward in the viable EBC industrialization process for a wide range of applications.

Carbon-Encapsulated Iron Nanoparticles as a Magnetic Modifier of Bioanode and Biocathode in a Biofuel Cell and Biobattery

This work demonstrates the application of magnetic carbon-encapsulated iron nanoparticles (CEINs) for the construction of bioelectrodes in a biobattery and a biofuel cell. It has been shown that carbon-encapsulated iron nanoparticles are a suitable material for the immobilization of laccase (Lc) and 1,4-naphthoquinone (NQ) and fructose dehydrogenase (FDH). The system is stable; no leaching of the enzyme and mediator from the surface of the modified electrode was observed. The onset of the catalytic reduction of oxygen to water was at 0.55 V, and catalytic fructose oxidation started at −0.15 V. A biobattery was developed in which a zinc plate served as the anode, and the cathode was a glassy carbon electrode modified with carbon-encapsulated iron nanoparticles, laccase in the Nafion (Nf) layer. The maximum power of the cell was ca. 7 mW/cm2 at 0.71 V and under external resistance of 1 kΩ. The open-circuit voltage (OCV) for this system was 1.51 V. In the biofuel cell, magnetic nanoparticles were used both on the bioanode and biocathode to immobilize the enzymes. The glassy carbon bioanode was coated with carbon-encapsulated iron nanoparticles, 1,4-naphthoquinone, fructose dehydrogenase, and Nafion. The cathode was modified with carbon-encapsulated magnetic nanoparticles and laccase in the Nafion layer. The biofuel cell parameters were as follows: maximum power of 78 µW/cm2 at the voltage of 0.33 V and under 20 kΩ resistance, and the open-circuit voltage was 0.49 V. These enzymes worked effectively in the biofuel cell, and laccase also effectively worked in the biobattery.

Stabilization-destabilization and redox properties of laccases from medicinal mushroom Ganoderma lucidum and human pathogen Yersinia enterocolitica

Laccases or benzenediol oxygen oxidoreductases (EC 1.10.3.2) are polyphenol multicopper oxidases that are known for their structural and functional diversity in various life forms. In the present study, the molecular and physico-chemical properties (redox-potential and secondary structures) of fungal laccase isozymes (FLIs) isolated from a medicinal mushroom Ganoderma lucidum were analyzed and compared with those of the recombinant bacterial laccases (rLac) obtained from different Yersinia enterocolitica strains. It was revealed that the FLIs contained His-Cys-His as the most conserved residue in its domain I Cu site, while the fourth and fifth residues were variable (Ile, Leu, or Phe). Evidently, the cyclic voltammetric measurements of Glac L2 at Type 1 Cu site revealed greater E° for ABTS/ABTS⁺ (0.312 V) and ABTS⁺/ABTS²⁺ (0.773 V) compared to the E° of rLac. Furthermore, circular dichroism-based conformational analysis revealed structural stability of the FLIs at acidic pH (3.0) and low temperature (<30 °C), while the isozymes were destabilized at neutral pH (7.0) and high-temperature conditions (>70 °C). The zymographic studies further confirmed the functional inactivation of FLIs at high temperatures (≥70 °C), predominantly due to domain unfolding. These findings provide novel insight into the evolution of the catalytic efficiency and redox properties of the FLIs, contributing to the existing knowledge regarding stress responses, metabolite production, and the biotechnological utilization of metabolites.