Condensation By-Products in Wet Peroxide Oxidation: Fouling or Catalytic Promotion? Part I. Evidences of an Autocatalytic Process

Doxorubicin delivery performance of superparamagnetic carbon multi-core shell nanoparticles: pH dependence, stability and kinetic insight

In the past decade, magnetic nanoparticles (MNPs) have been among the most attractive nanomaterials used in different fields, such as environmental and biomedical applications. The possibility of designing nanoparticles with different functionalities allows for advancing the biomedical applications of these materials. Additionally, the magnetic characteristics of the nanoparticles enable the use of magnetic fields to drive the nanoparticles to the desired sites of delivery. In this context, the development of new MNPs in new approaches for drug delivery systems (DDSs) for cancer treatment has increased. However, the synthesis of nanoparticles with high colloidal stability triggered drug delivery, and good biocompatibility remains a challenge. Herein, multi-core shell MNPs functionalized with Pluronic ® F-127 were prepared and thoroughly characterized as drug carriers for doxorubicin delivery. The functionalized nanoparticles have an average size of 17.71 ± 4.2 nm, high water colloidal stability, and superparamagnetic behavior. In addition, the nanoparticles were able to load 936 μg of DOX per mg of functionalized nanomaterial. Drug release studies at different pH values evidenced a pH-triggered DOX release effect. An increase of 62% in cumulative drug release was observed at pH simulating tumor endosome/lysosome microenvironments (pH 4.5) compared to physiological conditions (pH 7.4). In addition, an innovative dynamic drug delivery study was performed as a function of pH. The results from this test confirmed the pH-induced doxorubicin release capability of carbon multi-core shell MNPs. The validity of traditional kinetic models to fit dynamic pH-dependent drug release was also studied for predictive purposes.

Monolithic Stirrer Reactors for the Sustainable Production of Dihydroxybenzenes over 3D Printed Fe/γ-Al2O3 Monoliths: Kinetic Modeling and CFD Simulation

The aim of this work is to evaluate the performance of the stirring 3D Fe/Al2O3 monolithic reactor in batch operation applied to the liquid-phase hydroxylation of phenol by hydrogen peroxide (H2O2). An experimental and numerical investigation was carried out at the following operating conditions: CPHENOL,0 = 0.33 M, CH2O2,0 = 0.33 M, T = 75–95 °C, P = 1 atm, ω = 200–500 rpm and WCAT ~ 1.1 g. The kinetic model described the consumption of the H2O2 by a zero-order power-law equation, while the phenol hydroxylation and catechol and hydroquinone production by Eley–Rideal model; the rate determining step was the reaction between the adsorbed H2O2, phenol in solution with two active sites involved. The 3D CFD model, coupling the conservation of mass, momentum and species together with the reaction kinetic equations, was experimentally validated. It demonstrated a laminar flow characterized by the presence of an annular zone located inside and surrounding the monoliths (u = 40–80 mm s−1) and a central vortex with very low velocities (u = 3.5–8 mm s−1). The simulation study showed the increasing phenol selectivity to dihydroxybenzenes by the reaction temperature, while the initial H2O2 concentration mainly affects the phenol conversion.

Editorial Catalysts: Special Issue on Trends in Catalytic Wet Peroxide Oxidation Processes

The catalytic wet peroxide oxidation (CWPO) process is an advanced oxidation technology that has shown great potential for the decontamination of wastewater [...]