Rapid Microwave-Assisted Polyol Synthesis of TiO2-Supported Ruthenium Catalysts for Levulinic Acid Hydrogenation

Sn(IV)porphyrin-Incorporated TiO2 Nanotubes for Visible Light-Active Photocatalysis

In this study, two distinct photocatalysts, namely tin(IV)porphyrin-sensitized titanium dioxide nanotubes (SnP-TNTs) and titanium dioxide nanofibers (TNFs), were synthesized and characterized using various spectroscopic techniques. SnP-TNTs were formed through the hydrothermal reaction of NaOH with TiO2 (P-25) nanospheres in the presence of Sn(IV)porphyrin (SnP), resulting in a transformation into Sn(IV)porphyrin-imbedded nanotubes. In contrast, under similar reaction conditions but in the absence of SnP, TiO2 (P-25) nanospheres evolved into nanofibers (TNFs). Comparative analysis revealed that SnP-TNTs exhibited a remarkable enhancement in the visible light photodegradation of model pollutants compared to SnP, TiO2 (P-25), or TNFs. The superior photodegradation activity of SnP-TNTs was primarily attributed to synergistic effects between TiO2 (P-25) and SnP, leading to altered conformational frameworks, increased surface area, enhanced thermo-chemical stability, unique morphology, and outstanding visible light photodegradation of cationic methylene blue dye (MB dye). With a rapid removal rate of 95% within 100 min (rate constant = 0.0277 min-1), SnP-TNTs demonstrated excellent dye degradation capacity, high reusability, and low catalyst loading, positioning them as more efficient than conventional catalysts. This report introduces a novel direction for porphyrin-incorporated catalytic systems, holding significance for future applications in environmental remediation.

An in situ study of the thermal decomposition of 2,2′-azobis(2-methylpropionitrile) radical chemistry using a dual-mode EPR resonator

A custom-built dual-mode EPR resonator was used to study the radical chemistry of AIBN thermal decomposition. This resonator enables both simultaneous in situ heating using microwaves and EPR measurements to be performed. The thermal decomposition of AIBN was compared following conventional heating methods and microwave-induced (or dielectric) heating methods. Under both heating conditions, the radicals formed and detected by EPR include the 2-cyano-2-propyl (CP●) and 2-cyano-2-propoxyl (CPO●) radicals. Under aerobic conditions, the observed relative distribution of these radicals as observed by EPR is similar following slow heating by conventional or dielectric methods. In both conditions, the kinetically favoured CPO● radicals and their adducts dominate the EPR spectra up to temperatures of approximately 80–90 °C. Under anaerobic conditions, the distribution can be altered as less CPO● is available. However, the observed results are notably different when rapid heating (primarily applied using a MW-induced T-jump) is applied. As the higher reaction temperatures are achieved on a faster timescale, none of the ST●-CPO adducts are actually visible in the EPR spectra. The more rapid and facile heating capabilities created by microwaves may therefore lead to the non-detection of radical intermediates compared to experiments performed using conventional heating methods.

Editorial Catalysts: Special Issue on “Microwave-Assisted Catalysis”

The concept of circular economy is based on several principles, such as the use of renewable energy resources, including those obtained from the sun, wind, or water; the use of natural raw materials; the manufacturing of products avoiding the generation of wastes and pollution; keeping products and materials in use for a longer time; or giving new applications to waste [...]