Modified Ferrocenes as Primary Driers for Formulations of Alkyd Paints

Photoactive Fe Catalyst for Light-Triggered Alkyd Paint Curing

Herein, we show that the photoactive complexes [(Cp)Fe(arene)]⁺ (Cp = cyclopentadienyl; arene = C₆H₆, C₆H₅Me) act as latent catalysts that allow for photochemical control over the onset of alkyd paint curing, without the need for antiskinning agents such as the volatile 2-butanone oxime normally used to prevent curing during paint storage. The highly soluble neutral complexes [(Cp)Fe(Ch)] and [(Cp)Fe(Ch')] (Ch = cyclohexadienyl, Ch' = methylcyclohexadienyl) readily convert to the photoactive complexes [(Cp)Fe(arene)]⁺ upon oxidation in alkyd, allowing the latter to be dosed in a wide range of concentrations. Infrared and Raman studies show similar spectral changes of the alkyd paint matrix as have been observed in alkyd curing mediated by well-known, industrially applied cobalt- and manganese-based catalyst Co(neodecanoate)₂ and [(Me₃TACN)₂Mn₂(μ-OOCR)₃](OOCR). The [(Cp)Fe(Ch)]/[(Cp)Fe(arene)]⁺ system performs equally well as these cobalt- and manganese-based catalysts in terms of drying time and outperform the manganese catalyst by showing a hardness development (increase) similar to that of the cobalt-based catalyst. Based on electron paramagnetic resonance and light-activity studies, we propose that photolysis of [(Cp)Fe(arene)]⁺ generates short-lived active Fe^II species, explaining the desired latency. The [(Cp)Fe(Ch)]/[(Cp)Fe(arene)]⁺ alkyd curing systems presented herein are unique examples of intrinsically latent paint curing catalysts that (1) are based on an abundant and harmless transition metal (Fe), (2) do not require any antiskinning agents, and (3) show favorable performance in terms of drying times and hardness development.

Helmet Phthalocyaninato Iron Complex as a Primary Drier for Alkyd Paints

This study describes the catalytic performance of an iron(III) complex bearing a phthalocyaninato-like ligand in two solvent-borne and two high-solid alkyd binders. Standardized mechanical tests revealed strong activity, which appeared in particular cases at concentrations about one order of magnitude lower than in the case of cobalt(II) 2-ethylhexanoate, widespread used in paint-producing industry. The effect of the iron(III) compound on autoxidation process, responsible for alkyd curing, was quantified by kinetic measurements by time-resolved infrared spectroscopy and compared with several primary driers. Effect of the drier concentration on coloration of transparent coatings was determined by UV–Vis spectroscopy.