Electrochemical Performance of 2D-Hierarchical Sheet-Like ZnCo2O4 Microstructures for Supercapacitor Applications

One-Step Microwave-Assisted Hydrothermal Preparation of Zn-ZnO(Nw)-rGO Electrodes for Supercapacitor Applications

Zn-ZnO(Nw)-rGO hybrid electrodes for supercapacitor applications were successfully prepared in situ by a one-step microwave-assisted hydrothermal method by deposition of reduced graphene oxide (rGO) on the structure of ZnO nanowires grown on the Zn foil. During the hydrothermal treatment, two processes occur the reduction of graphene oxide (GO) and the deposition of rGO on the Zn-ZnO(Nw) support. The growth of ZnO nanowires was achieved by thermal oxidation below the melting point of the Zn foil in a controlled atmosphere. The as-obtained electrodes were assessed for structural, optical, and morphological properties by X-ray diffraction, Raman spectroscopy, ultraviolet-visible spectroscopy, SEM microscopy, and EDX analysis. The supercapacitor properties of the Zn-ZnO(Nw)-rGO hybrid electrodes were investigated by cyclic voltammetry, electrochemical impedance spectroscopy, and galvanostatic charge-discharge analysis. The CV curve reveals that the Zn-ZnO(Nw)-rGO hybrid structures work as negative electrodes and exhibit a non-ideal rectangle-like shape, suggesting that the as-synthesized structure behaves as a pseudo-capacitor. A maximum capacitance was determined to be 395.79 mF cm^-2 at a scan rate of 5 mV s^-1. Based on GCD analysis, the maximum specific capacitance of 145.59 mF cm^-2 was achieved at a low power density of 2 mA cm^-2. The cycle life assessment of the Zn-ZnO(Nw)-rGO hybrid electrode over a 250-cycle number was performed by CV and GCD analysis. The maximum retention rate of 120.86% was achieved from GCD analysis over 250 cycles for the Zn-ZnO(Nw)-rGO hybrid electrode.

Fabrication of vertically aligned CNT- vanadium oxide hybrid architecture with enhanced compressibility and supercapacitor performance

The demand for energy storage devices in wearable electronics effectuates a requisition for compressible and flexible supercapacitors with high performance and mechanical reliability. We report the fabrication of vanadium oxide hybrid with VACNT and its electrochemical supercapacitor performance along with the compression response. Compressive modulus of 730 ± 40 kPa is obtained for bare VACNT forest whereas its hybrid with vanadium oxide shows a compressive modulus of 240 ± 60 kPa. Controlled CVD process enabled the formation of porous CNT architecture coated with vanadium oxide particles due to the simultaneous reduction of V₂O₅and partial oxidation of CNT forest. Vanadium oxide decorated on vertically aligned carbon nanotubes acts as the active material for supercapacitor applications. A 17 folds increase in areal capacitance and 36 folds increase in volumetric capacitance are observed on depositing vanadium oxide particles on the VACNT forest. High coulombic efficiency of 97.8% is attained even after 10 000 charge-discharge cycles indicating the high stability of the hybrid.

Nano/Micro and Bio-Inspired Materials on Wide-Bandgap-Semiconductor-Based Optoelectronic/Power Devices

This Special Issue on “Nano/Micro and Bio-Inspired Materials on Wide-Bandgap-Semiconductor-Based Optoelectronic/Power Devices” is a collection of 20 original articles dedicated to theoretical and experimental research works providing new insights and practical findings in the field of solid-state technology-related topics [...]

A Comparative Evaluation of Sustainable Binders for Environmentally Friendly Carbon-Based Supercapacitors

Environmentally friendly energy storage devices have been fabricated by using functional materials obtained from completely renewable resources. Gelatin, chitosan, casein, guar gum and carboxymethyl cellulose have been investigated as sustainable and low-cost binders within the electrode active material of water-processable symmetric carbon-based supercapacitors. Such binders are selected from natural-derived materials and industrial by-products to obtain economic and environmental benefits. The electrochemical properties of the devices based on the different binders are compared by using cyclic voltammetry, galvanostatic charge/discharge curves and impedance spectroscopy. The fabricated supercapacitors exhibit series resistance lower than a few ohms and values of the specific capacitance ranged between 30 F/g and 80 F/g. The most performant device can deliver ca. 3.6 Wh/kg of energy at a high power density of 3925 W/kg. Gelatin, casein and carboxymethyl cellulose-based devices have shown device stability up to 1000 cycles. Detailed analysis on the charge storage mechanisms (e.g., involving faradaic and non-faradaic processes) at the electrode/electrolyte interface reveals a pseudocapacitance behavior within the supercapacitors. A clear correlation between the electrochemical performances (e.g., cycle stability, capacitance retention, series resistance value, coulombic efficiency) ageing phenomena and charge storage mechanisms within the porous carbon-based electrode have been discussed.

Extended Graphite Supported Flower-like MnO2 as Bifunctional Materials for Supercapacitors and Glucose Sensing

A simple, efficient, and cost-effective extended graphite as a supporting platform further supported the MnO₂ growth for the construction of hierarchical flower-like MnO₂/extended graphite. MnO₂/extended graphite exhibited an increase in sp² carbon bonds in comparison with that of extended graphite. It can be expected to display better electrical conductivity and further promote electron/ion transport kinetics for boosting the electrochemical performance in supercapacitors and glucose sensing. In supercapacitors, MnO₂/extended graphite delivered an areal capacitance value of 20.4 mF cm⁻² at 0.25 mA cm⁻² current densities and great cycling stability (capacitance retention of 83% after 1000 cycles). In glucose sensing, MnO₂/extended graphite exhibited a good linear relationship in glucose concentration up to about 5 mM, sensitivity of 43 μA mM⁻¹cm⁻², and the limit of detection of 0.081 mM. It is further concluded that MnO₂/extended graphite could be a good candidate for the future design of synergistic multifunctional materials in electrochemical techniques.

Potato Chip-Like 0D Interconnected ZnCo2O4 Nanoparticles for High-Performance Supercapacitors

Zinc cobaltite (ZnCo2O4) is an emerging electrode material for supercapacitors due to its rich redox reactions involving multiple oxidation states and different ions. In the present work, potato chip-like 0D interconnected ZnCo2O4 nanoparticles (PIZCON) were prepared using a solvothermal approach. The prepared material was characterized using various analytical methods, including X-ray powder diffraction and scanning electron microscopy. The possible formation mechanism of PIZCON was proposed. The PIZCON electrode material was systematically characterized for supercapacitor application. The areal capacitance of PIZCON was 14.52 mF cm−2 at 10 µA cm−2 of current density, and retention of initial capacitance was 95% at 250 µA cm−2 following 3000 continuous charge/discharge cycles. The attained measures of electrochemical performance indicate that PIZCON is an excellent supercapacitor electrode material.