Proof-of-Concept of High-Pressure Torrefaction for Improvement of Pelletized Biomass Fuel Properties and Process Cost Reduction

The Influence of Low-Temperature Food Waste Biochars on Anaerobic Digestion of Food Waste

The proof-of-the-concept of application of low-temperature food waste biochars for the anaerobic digestion (AD) of food waste (the same substrate) was tested. The concept assumes that residual heat from biogas utilization may be reused for biochar production. Four low-temperature biochars produced under two pyrolytic temperatures 300 °C and 400 °C and under atmospheric and 15 bars pressure with 60 min retention time were used. Additionally, the biochar produced during hydrothermal carbonization (HTC) was tested. The work studied the effect of a low biochar dose (0.05 gBC × gTSsubstrate-1, or 0.65 gBC × L-1) on AD batch reactors' performance. The biochemical methane potential test took 21 days, and the process kinetics using the first-order model were determined. The results showed that biochars obtained under 400 °C with atmospheric pressure and under HTC conditions improve methane yield by 3.6%. It has been revealed that thermochemical pressure influences the electrical conductivity of biochars. The biomethane was produced with a rate (k) of 0.24 d-1, and the most effective biochars increased the biodegradability of food waste (FW) to 81% compared to variants without biochars (75%).

Municipal Solid Waste Thermal Analysis—Pyrolysis Kinetics and Decomposition Reactions

In this study, 12 organic waste materials were subjected to TG/DTG thermogravimetric analysis and DSC calorimetric analysis. These analyses provided basic information about thermochemical transformations and degradation rates during organic waste pyrolysis. Organic waste materials were divided into six basic groups as follows: paper, cardboard, textiles, plastics, hygiene waste, and biodegradable waste. For each group, two waste materials were selected to be studied. Research materials were (i) paper (receipts, cotton wool); (ii) cardboard (cardboard, egg carton); (iii) textiles (cotton, leather); (iv) plastics (polyethylene (PET), polyurethane (PU)); (v) hygiene waste (diapers, leno); and (vi) biodegradable waste (chicken meat, potato peel). Waste materials were chosen to represent the most abundant waste that can be found in the municipal solid waste stream. Based on TG results, kinetic parameters according to the Coats–Redfern method were determined. The pyrolysis activation energy was the highest for cotton, 134.5 kJ × (mol∙K)−1, and the lowest for leather, 25.2 kJ × (mol∙K)−1. The DSC analysis showed that a number of transformations occurred during pyrolysis for each material. For each transformation, the normalized energy required for transformation, or released during transformation, was determined, and then summarized to present the energy balance. The study found that the energy balance was negative for only three waste materials—PET (−220.1 J × g−1), leather (−66.8 J × g−1), and chicken meat (−130.3 J × g−1)—whereas the highest positive balance value was found for potato peelings (367.8 J × g−1). The obtained results may be applied for the modelling of energy and mass balance of municipal solid waste pyrolysis.