Chemical Composition of Apricot Pit Shells and Effect of Hot-Water Extraction

The Effect of One-Year Fermentation of Maesil Fruit (Prunus mume) Sugar Syrup on Amygdalin Level: A Natural Toxic Compound

Prunus mume (maesil) is an economically important fruit in Korea. Recently, public interest in maesil sugar syrup is increasing. However, the presence of toxic amygdalin in the fruit syrup is a concern. Thus, the current investigation aimed to observe effects of maesil maturity, ripening methods, processing, and fermentation period on the amygdalin level in maesil sugar syrup. Six different types of maesil sugar syrup were prepared and amygdalin content was monitored at 3-month intervals. Higher levels (>63 mg/L) of amygdalin were found in syrups prepared from unripe fruit compared to those in syrups made from ripe fruit after 3 months of fermentation. A rapid reduction in amygdalin content was observed until 9 months in all syrups, gradually reducing to <5 mg/L at 12 months. More than 9 months of maturation is crucial for reducing the amygdalin content maesil sugar syrup, regardless of fruit maturity, source of fruit, and processing method.

Biochar as an effective material for acetone sorption and the effect of surface area on the mechanism of sorption

Walnut shells and apricot pits were used to produce non-activated, air-activated and steam-activated biochar. The specific surface area decreased in the order steam-activated (500-727 m 2.g-1), air-activated (59-514 m2.g-1) and non-activated biochars (1.71-236 m2.g-1). The results indicated that water steam created a multi-layer block structure with a well-developed porous structure, especially at 900 °C, while activation with air resulted in a more fragmented structure with a higher amount of coarse pores, leading to lower specific surface values. Acetone sorption experiments were performed in order to determine the acetone sorption capacity and to evaluate the acetone sorption kinetics of the biochars, as well as to identify the possible mechanism of sorption. The maximum sorption capacity estimated from the adsorption isotherms up to a relative pressure of 0.95 ranged from 60.3 to 277.3 mg g-1, and was highest in the steam-activated biochar with the largest surface area. The acetone adsorption isotherms were fitted with different adsorption models, where the Fritz-Schlunder model showed the best fitting results. The adsorption kinetics was evaluated using two kinetics models - pseudo first order and pseudo second order. The results indicated that the biochars with a large surface area exhibited physical sorption through van der Waals forces as the dominant mechanism, while acetone sorption on samples with a smaller surface area can be attributed to a mixed dual sorption mechanism, which combines physical sorption and chemisorption on oxygen functional groups. The perfect reusability of the biochars was confirmed by four consecutive adsorption-desorption cycles.

Thermal and Viscoelastic Responses of Selected Lignocellulosic Wastes: Similarities and Differences

Woody lignocellulosic biomasses comprise the non-edible parts of fruit trees. In recent years, the exploitation of this biomass has been widening in order to mitigate environmental issues. At the same time, this waste could be transformed into a value-added product (active carbon by pyrolysis, isolation of nanocellulose, oils or proteins). For either valorization path, a complete thermo-mechanical characterization is required. A detailed thermo-mechanical study (TGA, DSC, DMA) was performed on two types of lignocellulosic wastes, with and without kernels: on one side, the walnut shells (WS) and the pistachio shells (PsS) and, in the second category, the apricot seeds (AS), the date seeds (DS), and the plum seeds (PS). The results of the sample-controlled thermal analyses (HiRes TGA) evidenced a better resolution of the degradation steps of WS. Kinetic studies conducted also by conventional TGA (Flynn-Wall-Ozawa) and modulated TGA (MTGA) allowed us to make comparative reasonings concerning the degradation of the investigated biomasses. The DMA results revealed the effect of water traces and oil kernels on relaxation and supported the atypical DSC endotherm emphasized in the freezing temperature domain.

Apricot Seed Shells and Walnut Shells as Unconventional Sugars and Lignin Sources

The present study focuses on using apricot seeds shells and walnut shells as a potential renewable material for biorefinery in Ukraine. The goal of the research work was to determine the relationship between the chemical composition of solid residues from biomass after acid pretreatment with H₂SO₄, alkaline pretreatment with NaOH, and a steam explosion pretreatment and the recovery of sugars and lignin after further enzymatic hydrolysis with the application of an industrial cellulase Cellic CTec2. Apricot seeds shells and walnut shells consist of lots of cellulose (35.01 and 24.19%, respectively), lignin (44.55% and 44.63%, respectively), hemicelluloses (10.77% and 26.68%, respectively), and extractives (9.97% and 11.41%, respectively), which affect the efficiency of the bioconversion of polysaccharides to sugars. The alkaline pretreatment was found to be more efficient in terms of glucose yield in comparison with that of acid and steam explosion, and the maximum enzymatic conversions of cellulose reached were 99.7% and 94.6% for the solids from the apricot seeds shells and the walnut shells, respectively. The maximum amount of lignin (82%) in the residual solid was obtained during the processing of apricot seed shells submitted to the acid pretreatment. The amount of lignin in the solids interferes with the efficiency of enzymatic hydrolysis. The results pave the way for the efficient and perspective utilization of shells through the use of inexpensive, simple and affordable chemical technologies, obtaining value-added products, and thus, reducing the amount of environmental pollution (compared to the usual disposal practice of direct burning) and energy and material external dependency (by taking advantage of these renewable, low-cost materials).

AN EFFECTIVE BIOSORBENT DERIVED N EFFECTIVE BIOSORBENT DERIVED FROM PRODUCTION WASTE ROM PRODUCTION WASTE FOR WATER TREATMENT: STUDYING OR WATER TREATMENT: STUDYING THE ADSORPTION OF SYNTHETIC DYES HE ADSORPTION OF SYNTHETIC DYES

Introduction. Eco-friendly disposal of food waste, in particular, nutshells and fruit kernels, is an important issue to ensure sustainable nature management. These secondary raw materials are the source of valuable polymeric materials, cellulose and lignin.Problem Statement. IGiven the capacity of the food industry in Ukraine and the amount of waste produced, the development of technologies for processing lignin-cellulose biomass is an important research and practical issue.Purpose. The purpose of this research is to study the adsorption properties of chemically modified biosorbent based on plant materials concerning synthetic dyes of different types and classes; to assess the feasibility of biosorbent production and efficiency of its application in water treatment.Materials and Methods. Lignocellulose sorbent (LCS) has been synthesized from non-wood raw materials by chemical modification with the use of phosphoric acid with the addition of urea in an aqueous media. The Fourier transform infrared and standard methods of plant raw material analysis have been used to determine the physicochemical characteristics of LCS. The adsorption of anionic (methyl orange, alizarin red S, eosin Y), cationic (methylene blue, neutral red), and nonionic (aniline yellow) dyes on LCS from aqueous solution has been studied in the batch mode.Results. The adsorption capacity of LCS towards cationic dyes (47.0–53.3 mg/g) is higher than that of anionic (22.2–36.9 mg/g) and nonionic (4.7 mg/g) ones. The adsorption kinetics have been adequately described by a pseudo-second-order equation. Adsorption of all classes of dyes on LCS is thermodynamically feasible, spontaneous, and endothermic process. The liquid by-product of LCS production contains 15% nitrogen and 10% phosphorus, so it may be used as a fertilizer. Conclusions. The proposed method for processing food waste provides obtaining effective sorbent and liquid NP-fertilizer. LCS removes both cationic and anionic pollutants from water, so it may be considered a promisingbiosorbent for water purification.

Design and Preparation of Biomass-Derived Carbon Materials for Supercapacitors: A Review

The synthesis and application of biomass-derived carbon in energy storage have drawn increasing research attention due to the ease of fabrication, cost-effectiveness, and sustainability of the meso/microporous carbon produced from various biological precursors, including plants, fruits, microorganisms, and animals. Compared to the artificial nanostructured carbons, such as fullerene, carbon nanotube and graphene, the biomass-derived carbons may obtain superior capacitance, rate performance and stability in supercapacitor applications ascribing to their intrinsic nanoporous and hierarchical structures. However, challenges remain in processing techniques to obtain biomass-derived carbons with high carbon yield, high energy density, and controllable graphitic microstructures, which may require a clear understanding over the chemical and elemental compositions, and the intrinsic microstructural characteristics of the biological precursors. Herein we present comprehensive analyses over the impacts of the chemical and elemental compositions of the precursors on the carbon yield of the biomass, as well as the mechanism of chemical activation on the nanoporous structure development of the biomass-derived carbons. The structure–property relationship and functional performance of various biomass-derived carbons for supercapacitor applications are also discussed in detail and compared. Finally, useful insights are also provided for the improvements of biomass-derived carbons in supercapacitor applications.

Toward Complete Utilization of Miscanthus in a Hot-Water Extraction-Based Biorefinery

Miscanthus (Miscanthus sp. Family: Poaceae) was hot-water extracted (two h, at 160 °C) at three scales: laboratory (Parr reactor, 300 cm3), intermediate (M/K digester, 4000 cm3), and pilot (65 ft3-digester, 1.841 × 106 cm3). Hot-water extracted miscanthus, hydrolyzate, and lignin recovered from hydrolyzate were characterized and evaluated for potential uses aiming at complete utilization of miscanthus. Effects of scale-up on digester yield, removal of hemicelluloses, deashing, delignification degree, lignin recovery and purity, and cellulose retention were studied. The scale-dependent results demonstrated that before implementation, hot-water extraction (HWE) should be evaluated on a scale larger than a laboratory scale. The production of energy-enriched fuel pellets from hot-water extracted miscanthus, especially in combination with recovered lignin is recommended, as energy of combustion increased gradually from native to hot-water extracted miscanthus to recovered lignin. The native and pilot-scale hot-water extracted miscanthus samples were also subjected to enzymatic hydrolysis using a cellulase-hemicellulase cocktail, to produce fermentable sugars. Hot-water extracted biomass released higher amount of glucose and xylose verifying benefits of HWE as an effective pretreatment for xylan-rich lignocellulosics. The recovered lignin was used to prepare a formaldehyde-free alternative to phenol-formaldehyde resins and as an antioxidant. Promising results were obtained for these lignin valorization pathways.

Utilization of Euryale ferox Salisbury seed shell for removal of basic fuchsin dye from water: equilibrium and kinetics investigation

Euryale ferox Salisbury (E. ferox) is an environmentally and economically important wetland macrophyte.