Photocatalytic Removal of Cr(VI) by Thiourea Modified Sodium Alginate/Biochar Composite Gel

Adsorption of Safranin O Dye by Alginate/Pomegranate Peels Beads: Kinetic, Isotherm and Thermodynamic Studies

Water pollution is regarded as a dangerous problem that needs to be resolved right away. This is largely due to the positive correlation between the increase in global population and waste production, especially food waste. Hydrogel beads based on sodium alginate (Alg) and pomegranate fruit peels (PP) were developed for the adsorption of Safranin O dye (SO) in aqueous solutions. The obtained Alg-PP beads were widely characterized. The effects of the contact time (0-180 min), initial concentration (10-300 mg/L), initial pH (2-10), adsorbent dosage (1-40 g/L) and the temperature (293-333 K) were investigated through batch tests. The data proved that the adsorption kinetics of SO reached equilibrium within 30 min and up to 180 min. The dye adsorption is concentration dependent while a slight effect of pH was observed. The adsorption data of SO onto synthesized beads follow the pseudo second-order model. The experimental data fitted very well to Langmuir model with correlation factor of 0.92 which demonstrated the favourable nature of adsorption. The maximum adsorption capacity of Alg-PP could reach 30.769 mg/g at 293 K. Calculation of Gibbs free energy and enthalpy indicated that adsorption of SO onto Alg-PP is spontaneous (negative ΔG) and endothermic (ΔH = 9.30 kJ/mol). Analysis of diffusion and mass transport phenomena were presented. The removal efficiency was found to be 88% at the first cycle and decreased to 71% at the end of the seventh cycle. The reported results revealed that the Alg-PP beads could be used as a novel natural adsorbent for the removal of high concentrated solutions of Safranin O which is a cationic dye from liquid affluents and as future perspective, it can be used to remove various pollutants from wastewater.

Synthesis of ZnO immobilized on recycled polyethylene terephtalate for sonocatalytic removal of Cr(VI) from synthetic, drinking waters and electroplating wastewater

In this study, Cr(VI) was removed sonocatalytically by the zinc oxide nanoparticle coated with polyethylene terephthalate (PET) fabricated through a facile co-precipitation method. The crystal structure, functional groups on the surface, morphology, surface composition and oxidation states of the nanomaterials were investigated by XRD, FTIR, SEM, EDX and XPS techniques. Environmental parameters including solution pH, catalyst dose, hexavalent chromium concentration, H₂O₂ content, purging gases, organic compounds and type and anions strength on the sonotocatalytic removal of Cr(VI) were also investigated. Additionally, the contribution of each process, reusability, Cr(VI) reduction from actual water and electroplating wastewater were evaluated. Under the optimal conditions, [Cr(VI)]₀=20 mg/L, nanocomposite loading=1.6 g/L and pH=5, 99.92% of Cr(VI) was removed within 60 min. By increaing, Cr(VI) concentration (5-50 mg/L), k_obs decreased to values between 0.1498 and 0.0063 min^-1 and the calculated electrical energy per order (E_Eo) increased from 148.68 to 3535.24 kWh.m^-3, respectively. The presence of purging gases, organic compounds and ionic strength negatively affected Cr(VI) reduction. Examination of radical scavengers showed that the most active radicals in Cr(VI) removal were O₂^•- and h⁺. The removal of the Cr(VI) using the US/ZnO-PET method (99.92%) was higher than that of the US/ZnO method (70.78%). The catalyst activity was well maintained up to eight consecutive cycles. In addition, the removal efficiency was approximately 72.23 and 68.55% for drinking water and real electroplating wastewater samples, respectively. The results of toxicity in the sonotocatalytic removal of Cr(VI) by Daphnia magna showed LC₅₀ and toxicity unit (TU) 48 h, which was equal to 81.46 and 1.227 vol percent.